REGULA 70 4M-5A Series Manuel utilisateur
DOCUMENT READER
REGULA 70Х4M.ХХХ-5А
User’s Guide
2019
Certi ed Quality
Management System
FCC/Canada Radio Frequency Rules and Regulations
FCC Labeling for USA
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are esigned to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one
or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
FCC ID: 2AOFE-7024M5A
ISED Labeling for Canada
This device contains license-exempt transmitter(s) / receiver(s)
that comply with Innovation, Science and Economic Development
Canada’s license-exempt RSS(s). Operation is subject to the following
two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference
that may cause undesired operation of the device.
IC code: 25676-70X4M5A
L’émetteur/récepteur exempt de licence contenu dans
le présent appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes:
(1) L’appareil ne doit pas produire de brouillage;
(2) L’appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement.
Statement of compliance with safety standards:
The device complies with safety standards listed below:
IEC/EN/UL 62368-1, CSA 22.2. No 62368, IEC 62471, IEC 62479
min 20 см
OPERATING RESTRICTIONS
1. ATTENTION! CONSULT THIS USER’S GUIDE AT ALL STAGES
OF DEVICE OPERATION.
2. When operating the device, do not remove any seals set by
the manufacturer during the whole warranty period.
3. DO NOT SWITCH ON THE DEVICE IN CASE OF ITS MALFUNCTION!
4. DO NOT PLACE ANY FOREIGN OBJECTS ON THE OBJECT GLASS
OF THE DEVICE!
5. DO NOT USE THE DEVICE WHEN THE USB CABLE IS DAMAGED!
6. DO NOT DISMANTLE THE DEVICE AND ELIMINATE ANY
MALFUNCTIONS OCCURRED DURING DEVICE OPERATION WITHOUT
QUALIFIED ASSISTANCE.
7. Do not operate the reader if the object glass is dirty
(see paragraph 3.3 of this User’s Guide).
8. DO NOT OPERATE THE DEVICE AT A DISTANCE CLOSER
THAN 20 CM TO OTHER RADIO-TAIL DEVICES INCLUDING SIMILAR
DEVICES.
This symbol means the product must not be as
household waste, and should be delivered to an
appreciate collection facility for recycling. For more
information on disposal and recycling of this product,
contact your local municipality service, or the shop
where you bought this product.
9. Changes or modi cations not expressly approved by Regula
Baltija, LTD could void the user’s authority to operate the equipment.
CONTENTS
LIST OF ABBREVIATION ..............................6
1 DESCRIPTION AND OPERATION ...................... 11
1.1 Device Function ............................. 11
1.2 Technical Characteristics ....................... 11
1.3 Delivery Set ................................ 12
1.4 Conguration and Operation ..................... 13
1.5 Marking and Sealing .......................... 15
1.6 Packaging ................................. 15
2 INTENDED USE ................................. 16
2.1 Operating Restrictions ......................... 16
2.2 Preparing the Device for Use .................... 16
2.3 Device Use ................................. 18
3 TECHNICAL MAINTENANCE ......................... 20
4 SHIPPING, STORAGE AND UTILIZATION ................ 22
4.1 Shipping .................................. 22
4.2 Storage ................................... 22
4.3 Recycling .................................. 22
5 MANUFACTURER’S WARRANTY ....................... 23
6 ACCEPTANCE CERTIFICATE ......................... 23
APPENDIX A. Device Calibration ....................... 24
APPENDIX B. Drivers Installation ...................... 26
APPENDIX C. Cover Replacement ...................... 27
APPENDIX D. Downloading Regula Document Reader SDK ..... 29
APPENDIX E. Simplied EU Declaration of Conformity ........ 30
6
User’s Guide Document Reader Regula 70X4M.XXX
LIST OF ABBREVIATION
SDK –Software Development Kit
DR SDK –Document Reader SDK
USB –Universal Serial Bus
OCR –Optical Character Recognition
MRZ –Machine Readable Zone
VIZ –Visual Inspection Zone
ISO –International Organization for Standardization
PPI –Pixels per inch – Image resolution
FDS –Frontline Document System is a reference database,
which contains pattern images of passports,
identity and travel documents, driver’s licenses and
vehicle documents, as well as the data on the basic
authenticity features of passports, IDs and travel
documents, driver’s licenses and vehicle documents
at ve levels of protection: printing design, ultraviolet
365 nm and 254 nm, infrared and special materials
PC/SC –Personal Computer Smart Card Interface
ISO 7816 –ISO 7816-1,-2,-3,-4 Standards for ICC (Smart Cards)
7
User’s Guide Document Reader Regula 70X4M.XXX
This User’s Guide (hereinafter referred to as the “Guide”) applies
to Regula 70X4M.XXX-5A Document Readers (hereinafter referred to
as the “Device”) intended for capturing full-page document images
under white, infrared, ultraviolet and coaxial white light schemes,
The documents must meet ISO 7810 standard and be either of ID-1, ID-2
or ID-3 sizes
as well as for reading the text (OCR), graphic and biometric
information from the document,
For documents with RFID-tags executed under ISO 14443A standard
or for documents (Smart-cards) executed under ISO 7816 Smart Card
Standard
verifying its authenticity features and transferring the obtained data
to the user application.
The Document Reader “Regula 70X4M.XXX-5A” can be produced in
one of the Modications shown in table 1. The type of the modication
is to be discussed with the Customer when preparing the sales
agreement.
Table 1
Parametres
Device
modications
White
light
IR
870 nm
UV
365 nm
White
coaxial
RFID
reader
Smart-
card
reader
7004M.100-5A • •
7004M.110-5A • • •
7004M.111-5A • • • •
7024M.100-5A • • •
7024M.110-5A • • • •
7024M.111-5A • • • • •
7034M.100-5A • • • •
7034M.110-5A • • • • •
7034M.111-5A • • • • • •
This Guide contains the description of the Device structure,
principle of operation, and operating rules.
8
User’s Guide Document Reader Regula 70X4M.XXX
The device (depending on the modication) along with supplied
software can:
1. capture color images of a document with the resolution of
400 ppi, 470 ppi or 500 ppi under white, ultraviolet and white coaxial
light and grayscale images under infrared light;
Supported graphic format: BMP, JPEG, JPEG-2000, PNG, TIFF
2. OCR of the data from MRZ of the documents under Doc 9303
ICAO and ISO 7501 standards: 2 lines of 44 characters, 2 lines of
36 characters and 3 lines of 30 characters;
3. evaluate MRZ print quality and verify its authenticity under
Doc 9303 ICAO, ISO 7501, ISO 1831, ISO 1073-2 standards;
4. read 1D and 2D barcodes from a document image;
Supported bar-codes types: PDF-417, Codabar, Code 128, Code 39, Code
39 extended, Code 93, EAN-13, EAN-8, Interleaved 2 of 5 (ITF), Standard
2 of 5 (Industrial), Matrix 2 of 5, IATA 2 of 5 (Airline), UPC-A, UPC-E
5. identify the type and nationality of a document;
6. localize the holder’s photo and signature (if any) of a document
for the recognizable by the system types of documents;
7. OCR of the VIZ data from the documents, including non –
ICAO standard documents;
8. read data from an RFID-chip under “Machine Readable Travel
Documents. Technical Report. Logical Data Structure (LDS)” ICAO
specication;
Supported access modes: Direct, ВАС, ЕАС
Identication: Passive and Active
RFID-chip types: ISO 14443 types А and В
Data exchange rate: 106,212,424 or 848 Kbaud (asymmetric rates support)
9. read data from a contact Smart-card (under the control
of Smart-card application);
ISO 7816 compatible, asynchronous (Т0 and Т1) smart cards are supported.
Data exchange rate: from 2 till 500 Kbaud
10. checking automatically the following authenticity parameters
of the documents:
UV-features:
– absence of luminescence of document material
(UV dull paper check):
- Blank Element
- MRZ Element
- Photo Element
9
User’s Guide Document Reader Regula 70X4M.XXX
– luminescence of UV protection bers;
– luminescence of UV patterns;
– reading-out text luminescing under UV light and its
comparison with the data retrieved from MRZ or VIZ
(OCR Security Text).
IR-features:
– MRZ printing contrast (IR B900 ink)
– photo embedding type;
– visibility or invisibility :
- Blank Element
- Filled-in document data
- Photo
cross-checking of text data obtained from MRZ, VIZ,
barcode, RFID-chip and Visa;
MRZ check-sums and MRZ completion accuracy;
IPI (invisible personal information) visualization
11. retrieve the specimens images and the description of
a document from FDS information system database for
comparative analysis (comparing with the scanned document);
12. graphic interface Readerdemo.exe: English, Russian, Italian,
Spanish, Lithuanian, Romanian, Arabic, Ukrainian, Latvian, French,
Chinese, Polish.
The device works with the PC under the User application control and
ensures the performance of functions, specied in “Programmer’s
Guide. Document Reader” and “Programmer’s Guide. RFID
Reader”
The User application intended for controlling the device must
be developed on the bases of the libraries from the Software
Development Kits (SDK) under the mentioned Programmer’s
Guides.
Test application Readerdemo.exe (see “Test application
(Readerdemo.exe)”) is an example of the User application designed
for testing the functions DR SDK and RFID SDK (supplied as a part
of the DR SDK).
The user application design and organization of the user application
interaction with the SDK software components are the exclusive
responsibility of the Customer and is not described in this document.
Data reading-out from the contact Smart-cards is performed under
the control of the Application, compatible with EMV CCS requirements
for asynchronous smart cards and is not described in the present
Guide.
10
User’s Guide Document Reader Regula 70X4M.XXX
PC minimal requirements:
CPU: Intel Core i3 (Intel Core i5)
OS:Windows 7 (Windows 10);
RAM: 4 (8) GB;
Video RAM: 32 (64) MB;
Two USB 2.0 ports;
HDD: 32 (120) GB.
Note:
optionally document reader can work under OS Linux.
The device is powered through the PC USB port.
The time required by the device for document reading and recognition
may vary from 1 to 30 sec. It depends on several factors, such as:
device modication,
software settings concerning reading and authenticity
verication,
availability of RFID chip in a document and RFID chip
characteristics,
PC performance.
ATTENTION!
USE USB CABLE FROM THE DELIVERY SET ONLY
(2 CONNECTORS OF A TYPE AND 1 CONNECTOR OF B TYPE).
Only the user with the administrator’s rights can prepare the PC for
using it along with the device, install the software and test the device.
The customer must follow the safety rules adopted at the user’s
enterprise and the rules of this Guide.
Ce manuel convient aux modèles suivants
9
Table des matières
