Redline TR1500 Supplément
Redline TR1500 Trike Motorcycle Lift Table
Assembly & Operation Manual
Step 1
Use the provided bolts shown to secure the front wheel stop to the front of either the lift itself, or to the front
of the front extension panel if you intend to use the front extension panel. We do not recommend using the
front extension unless you actually have an unusually long motorcycle and require this panel.
This photo below shows the wheel stop installed.
Step 2
Assuming you wish to install the front extension, it slides over the front of the table as shown.
Be sure to line up the large holes on the sides of the front extension panel with the same holes found in the li table.
Next, you’ll install the front extension support pole. The TR1500 comes with 4 poles total as shown below. The 2 longest
poles support the side extensions (installed later). The middle length pole is an an-p stabilizer bar (installed later).
Finally, the shortest pole is the front extension support pole.
You’ll insert the shortest pole through the front extension panel and also through the li table at the same me,
resulng in the shortest pole slightly exing the front extension panel on both sides. Once done, you’ll insert the
provided clevis pin and coer pin on each side of the front extension support pole
Step 3
Next, you’ll insert the middle length pole into the base of the machine. This is an an-p stabilizer bar.
You’ll then use the pictured hardware to install the p-over feet into the ends of the p-over bar.
Step 4
In step 4, you’ll insert the 2 longest support poles into the 2 most rearward holes in the li’s tabletop, and then
slide the side extensions over those protruding bars.
Again, using the supplied hardware you’ll insert all 4 clevis and coer pins, eecvely pinning the side
extensions into place so that they cannot possibly slide o without intenonally doing so.
Step 5
Next, you’ll aach the 3 piece ramp assembly to the table top as shown using the hooks of the ramps to drop
into the holes in the table top, as well as the holes in the side extensions
Hardware is supplied to bolt all three ramps together, but we do not recommend doing so as it makes it
especially dicult to remove and replace the ramps when all three are connected. Nevertheless, the hardware
and bolt holes are included in case the customer wishes to do so.
Step 6
If you purchased the oponal wheel vise with your trike li, both your table and your front extension panel
come pre-drilled with the necessary mounng holes to install the Redline wheel vise to this table as shown. Be
sure to use ratchet straps to secure your bike to the li as the wheel vise alone is not sucient to hold the
motorcycle rmly to the li.
Autres manuels Redline Système de levage
Manuels Système de levage populaires d'autres marques
morse
morse 82H-124 Manuel utilisateur
Braun
Braun NL955 Series Manuel utilisateur
haacon
haacon 1889.10 Manuel utilisateur
Protekt
Protekt AT 252 Manuel utilisateur
R. Beck Maschinenbau
R. Beck Maschinenbau HS 600 Manuel utilisateur
Nova Technology International, LLC
Nova Technology International, LLC NAS Series Manuel utilisateur
Genie
Genie Z-60/34 Manuel utilisateur
Screen Technics
Screen Technics INTERFIT Vertical Up Lift Manuel utilisateur
Mortuary Lift
Mortuary Lift ULTIMATE 1000 Manuel utilisateur
Custom Equipment
Custom Equipment Hy-Brid 3 Series Manuel de programmation
Custom Equipment
Custom Equipment Hy-Brid Lifts 2 Series Manuel de programmation
Hy-Brid Lifts
Hy-Brid Lifts HB-P3.6 Manuel de programmation
