RCI 910TC-WRM Manuel utilisateur

910TC-WRM

INSTALLATION

1. Remove power to the unit prior to installing the remote

receiver. (Fig.1)

2. Insert the pins of the remote board into the header of the button

as indicated below. Ensure the pins are aligned and fully engaged in

the header. (Fig.2)

3. Reapply power to the unit.

4.Once installed the transmitter and receiver must be paired to each

other for proper operation.

R03-18TG-4

IS910TC-WRM-WRB

Remote Receiver and Remote Transmitter

The remote module allows wireless activation of the 910TC button for convenience or installations that do not allow for wire access.

5. On the back of the remote board, locate the button and LED as

indicated below. (Fig.3)

6. Press and hold the button on the board until the red LED comes

on, then release.

7. While the LED is lit press the button on the transmitter (Fig. 4),

the LED will blink indicating the code is being stored.

8. The red LED will go out to indicate the storing of the code has

been successful. Up to 5 transmitters can be paired with one

receiver by following the above process. NOTE: Should you need to

reprogram or delete a transmitter, all transmitters will be erased and

need to be reprogrammed individually.

9. To erase all units, press and hold the button on the back of the

board until the red LED comes on. Continue to hold the button until

the LED goes out.

10. Repeat steps 6-8 to reprogram

www.rutherfordcontrols.com • Phone: 1.800.265.6630 • Fax: 1.800.482.9795 • Email: [email protected]

Fig. 1

Fig. 2 Fig. 4

Fig. 3

910TC-WRM

Regulatory Statements

FCC Regulatory Statements

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the Federal

Communication Commission (FCC) rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

NOTE: ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE COULD VOID THE

USER’S AUTHORITY TO OPERATE THE EQUIPMENT.

www.rutherfordcontrols.com • Phone: 1.800.265.6630 • Fax: 1.800.482.9795 • Email: [email protected]

ISED

This device complies with ISED Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:

(1) this device may not cause interference, and

(2) this device must accept any interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme avec ISED Canada applicables aux appareils radio exempts de licence.

L’exploitation est autorisée aux deux conditions suivantes:

(1) l’appareil ne doit pas produire de brouillage, et

(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

CAN ICES-3 (B)/NMB-3(B)

910TC-WRM

Autres manuels RCI Récepteur

RCI

RCI CLiK64-TR Manuel utilisateur

Manuels Récepteur populaires d'autres marques

Garmin

Garmin GA 23 Manuel utilisateur

Aiphone

Aiphone PS-12F Manuel utilisateur

IMES

IMES TCS-01CA-PMI Manuel utilisateur

BWI Eagle

BWI Eagle AIR-EAGLE SR Manuel

AMIMON

AMIMON AMN12310 WHDI Manuel utilisateur

Dual

Dual DMCPA79BT Mode d'emploi

Sound Associates

Sound Associates SA652P Manuel utilisateur

Sherwood

Sherwood NewCastle R-772 Manuel utilisateur

Audio

Audio A10-RX Series Manuel utilisateur

AllSee

AllSee PushShare PSRV1.1 Manuel utilisateur

DEMAG

DEMAG DRC-DR D2 Manuel utilisateur

Teleco

Teleco TVRCL868A02 Manuel utilisateur

Bosch

Bosch RF3222E Manuel utilisateur

Kramer

Kramer 631R Manuel utilisateur

Xpress

Xpress xmc10 Manuel utilisateur

JVC

JVC KD-MR1BTS Manuel utilisateur

Omega Engineering

Omega Engineering UWTC-REC3 Manuel utilisateur

e-survey

e-survey E300 Pro Manuel utilisateur