RCA D940 Manuel utilisateur
DSS is a registered trademark of DIRECTV, Inc.,
a unit of Huges Electronics Corp.
D940
REMOTE CONTROL
SIGNAL SENDER
Use RCA DSS®Remote
to control RCA Brand DSS
Receiver from any TV
(Requires TVs
to be prewired to
DSS System Signal).
Operating Precautions ..........2
System Contents ....................4
System Set-Up
Extension Unit....................5
Base Unit ..........................6
Infrared Extender ..............7
Trouble Shooting ..................8
DSS System Signal Splitting....9
DSS Accessories..................10
Warranty............................12
TABLE OF CONTENTS
®
2
When using your Remote Control Signal Sender as with any other electri-
cal device, basic safety precautions should always be followed to reduce the
risk of fire, electric shock and injury to persons, including the following:
1. Read and understand all instructions.
2.Follow all warnings and instructions marked on the product.
3.Unplug this product from the wall outlet before cleaning. Do not use
liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.
4.Do not use this product near water, for example: near a bath tub,
washbowl, kitchen sink, or laundry tub, in a wet basement, or in or
near a swimming pool.
5.Do not place this product on an unstable cart, stand, or table.
The product may fall, causing serious damage to the product.
6.This product should be operated only from the type of power source
indicated on the marking label. If you are not sure of the type of
power supply to your home or building, consult your dealer or local
power company.
7.To reduce the risk of electric shock, do not disassemble this product,
but take it to a qualified serviceperson when some service or repair
work is required. Opening or removing covers may expose you to dan-
gerous voltages or other risks and voids warranty. Incorrect reassembly
can cause electric shock when the product is subsequently used.
Operating Precautions
3
Operating Precautions
8.Unplug this product from the wall outlet and refer servicing to qualified
service personnel under the following conditions:
A. When the plug is damaged.
B.If liquid has been spilled into the product.
C.The product has been exposed to rain or water
D.If the product does not operate normally by following
the operating instructions.
E.If the product has been dropped or the cabinet has been damaged.
F.If the product exhibits a distinct change in performance.
•No repairs to the unit(s) should be attempted by the customer.
•This device complies with Part 15 of the FCC Rules. Operation of
this device is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesirable operation.
•“NOTE: This equipment has been tested and found to comply with the
limits for remote control security devices in accordance with the specifi-
cations in sub parts C and E of part 15 of FCC rules. These limits are
designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accor-
dance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that Radio Frequency
Energy does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the
following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and Base Unit.
•Connect the equipment into an outlet on a circuit different from that to
which the Base Unit is connected.
•Consult the dealer or an experienced radio/TV technician for help.”
4
Compatible Components
• Television
• VCRs
• Stereo Receivers
• Tape Decks
• CD Players
• Cable Converter
• DSS®Receiver
• Anything operated by Infrared
Remote Control
System Contents
Extension Unit
The Extension Unit senses the Infrared signals
from your remote control and an LED lights
to indicate that signals are being detected.
The Extension Unit converts the remote con-
trol signals into radio frequency transmissions
for communication with the Base Unit.
Base Unit
The Base Unit has an antenna, power cord,
and a jack for the Infrared Extender. The Base
Unit receives Radio Frequency (RF) transmis-
sions from the Extension Unit. A light indi-
cates that a signal is being received. The Base
Unit then converts the RF transmissions back
into Infrared signals used to control your
DSS®Receiver. The Base Unit will operate up
to 100 feet away from the Extension Unit.
Infrared Extender
This device consists of an Infrared Diode
connected to a 4 ft. extension wire and plug.
It plugs into the Base Unit for situations
where placement in front of the instrument
is difficult.
Your D940 Remote Control Signal Sender consists of two units
(Extension Unit and Base Unit) and an infrared extender.
5
Where to Use
Use in the room where you want to use your
remote control (example: use in the additional
room wired to receive DSS®System signal).
How to Install
1.Plug the Extension Unit into a standard
electrical outlet.
2.Place the logo side of the Extension Unit facing
you. It can be placed up to 18 feet from where
you will be using the remote control.
Extension Unit Set-Up
6
Base Unit Set-Up
Where to Use.
Use in the room where the DSS®
Receiver is located.
How to Set-Up
1.Plug the Base Unit power cord into standard
electrical outlet.
2.Point the front of the Unit (logo side) facing
the DSS Receiver. Extend the antenna
for best performance.
3.Check the following distances
• Base Unit is within 20 feet of DSS Receiver.
• Base Unit is within 100 feet of Extension Unit.
After setting up your Extension and Base Units, operate the Signal
Sender by aiming your remote at the RCA logo on the front of the
Extension Unit.
7
Infrared Extender Set-Up
Where to Use
•Use when Base Unit cannot be easily
placed in front of the DSS®Receiver.
(Example: when DSS Receiver and Base
Unit are located in a closed cabinet).
•Use when you would prefer to conceal the
Base Unit in a cabinet or behind furniture.
How To Use
1.Plug the Infrared Extender into back of
Base Unit.
2.Place the Infrared Diode (located on the
opposite end of the extension cord) in
clear view of DSS Receiver to enable
signal transmission.
Example of Application: TV & DSS Receiver in Cabinet
8
1. Make sure both units are plugged into a standard electrical outlet.
2. If the red light inside the Extension Unit does not light when the
Remote Control is operated:
•Make sure you are pointing at the front of the Extension Unit
(the RCA logo is on the front).
•Make sure you are within 18 feet of the front of the
Extension Unit.
•Make sure nothing is blocking the path between the remote and
the Extension Unit.
3. If your DSS®Receiver does not respond but the red light inside the
Base Unit lights when a remote control is used:
•Make sure the Base Unit is within 20 feet of your
DSS Receiver.
•Make sure the Base Unit front is pointing at the front of your
DSS Receiver.
•Make sure nothing is blocking the Base Unit and the
DSS Receiver.
4. If the red light on the Extension Unit lights when you operate the
remote but does not light in the Base Unit:
•Extend the antenna all the way up or move the antenna to a
different position for better reception.
•Make sure the Extension Unit is no more than 100 feet from
the Base Unit.
5. Move the Unit that appears not to be working to another location
and try it again.
6. Attach the infrared extender to the Base Unit for situations where
there is an obstruction (TV Cabinet, etc.).
Troubleshooting
9
DSS®Signal Splitting
OPTION 1. (Refer to above diagram)
1.Hook up the DSS®Receiver as directed in the DSS
receiver instructions.
2. Connect DSS Receiver to your TV1 with a cable from the A/V
OUTPUT on the DSS Receiver to the A/V INPUT on TV1.
3.Connect DSS Receiver to TV2 with a cable from OUT to TV
to an A/B switch at TV2.
OPTION 2.
1. Hook up the DSS®Receiver as directed in the DSS Receiver instructions.
2. Use one of the following DSS System Signal Combiners to split the
“Out To TV” cable. (Refer to page 10)
DSS Model D2271 Two Way Signal Combiner
DSS Model D2471 Four Way Signal Combiner
3. Hook one of the “Out To TV” cable lines to the TV originally
hooked up to your DSS Receiver and the other to a second TV.
To purchase these accessories, contact your local dealer. If no dealer is
available, call the toll free number listed on next page and order by
phone (please allow 2–4 weeks for delivery).
D900 Universal Remote Controls Muti-Brand TVs
VCRs, Cable Boxes, Laser Disc
Players, and the RCA DSS®
Receiver. Add a DSS system
remote to every Signal Sender
Extension Unit.
D935 DSS Signal Sender Extension Unit
Use with your Base Unit to
control your DSS system receiver
from additional locations.
D2271 2 Way Signal Combiner 2 Way or 4 Way signal splitter to
D2471 4 Way Signal Combiner run your DSS System“Out To
TV” cable to additional locations.
VH74 A/B Switch Use to switch between your DSS
system and antenna.
10
DSS®Accessories
Autres manuels pour D940
1
Table des matières
Autres manuels RCA Télécommande
RCA
RCA RCR3283 - Universal Remote Control Guide de l'administrateur
RCA
RCA RCR311SR Manuel utilisateur
RCA
RCA RCR312W Manuel utilisateur
RCA
RCA RCRF03B Guide de l'administrateur
RCA
RCA RCRN04GBE Manuel utilisateur
RCA
RCA RCR804BFDR Manuel utilisateur
RCA
RCA RCR461 Manuel utilisateur
RCA
RCA RCRTBL08BE1 Manuel utilisateur
RCA
RCA RCU703SP - 3-function Universal Remote... Manuel utilisateur
RCA
RCA RCR4373 - Universal Snowboard Remote Manuel utilisateur
RCA
RCA RCU600D - Universal Remote Control Manuel utilisateur
RCA
RCA RCR504BR Series Manuel utilisateur
RCA
RCA CRCR4383NR Manuel utilisateur
RCA
RCA RCU1300 Manuel utilisateur
RCA
RCA RCR504BR Series Manuel utilisateur
RCA
RCA RCRPS02GR Guide de l'administrateur
RCA
RCA RCR002RWDZ Manuel utilisateur
RCA
RCA RCR314WE Manuel utilisateur
RCA
RCA RCR312W - 3 Device Partially Backlit Universal Remote... Guide de l'administrateur
RCA
RCA RCRPS04GZ Manuel utilisateur
Manuels Télécommande populaires d'autres marques
Panasonic
Panasonic EUR7622KB0 Manuel utilisateur
Bang & Olufsen
Bang & Olufsen Beo4 Manuel utilisateur
Sunwave Tech.
Sunwave Tech. RemoteComm SRC-7000 Manuel utilisateur
Multiplex
Multiplex PROFI TX 9 Manuel utilisateur
One Remote
One Remote RMB4 Manuel utilisateur
FUTABA
FUTABA 9ZAP - PART2 Manuel utilisateur
