RapID Lab CR1400 Manuel utilisateur
Copyright © 2013 RapID Lab, Inc. All rights reserved.
Please note that RapID Lab highly recommends upgrading to the CR1500 scanner if
you haven’t already. The CR1500 provides a faster and more reliable scan for your
workflow.
Setting up CODE CR1400 Scanner for RapID Tags as a USB keyboard
The instructions below will program the CODE CR1400 Scanner to properly decode the RapID Tag
Datamatrix symbols. More information may be found on the RapID Lab website:
www.rapidlab.com/support
1. Unplug the CODE CR1400 from the PC.
2. While holding the trigger pressed, plug the reader into the USB port on the PC and hold for 5-10
seconds. You will hear 5 rapid beeps and then you can let go of the trigger. The unit is now in Boot
Mode.
3. To reset the CODE CR1400, simply hold the trigger down again for approximately 5-10 seconds until
it reboots. The reader will vibrate first and then beep several times and is now reset.
4. Next, simply scan the following codes shown in the table below.
Required Codes:
Copyright © 2013 RapID Lab, Inc. All rights reserved.
Optional Codes:
This turns the scanner into a continuous
scan mode that works well for hands free
operation. Note that the CR1400 will
enter into Continuous Scan mode by
default when placed in the Scanner Stand.
This sets a duplicate rejection
period of 0, 1, or 3 seconds so that
tags are not ‘double scanned’.
Table des matières
Autres manuels RapID Lab Clavier
