Rage RC LightWave Manuel utilisateur

Hull Length:
Overall length:
Width:
Height:
Weight:
Motor:
Charger:
Servo:
On-Board Electronics:
10” (254mm)
11 5/8” (300mm)
3” (80mm)
2 5/8” (67mm)
6.6 oz. (187g)
7.4V 500mAh Lithium-Ion
180A brushed water-cooled
USB charger
2-channel, 2.4GHz
2-in-1 combo w/ ESC & 2.4GHz receiver
INSTRUCTION MANUAL

The RageRC LightWave is a micro-size boat that’s perfect for racing across a large swimming pool
that features a waterproof 9-gram servo for precise steering control and an electronic speed
2
LIGHTWAVE CONTENTS

vehicle, it is strrecommended that ou read the ENTIRE manual before ou
1.
2.
3.
4.
5.
6.
7. Make sure the motor mount is secured to the hull so that the motor does not
8.
9.
10.
1.
make sure the boat cannot be controlled bevice.
2.
3. Make sure the outside of the boat and inside of the hull are complet
ensure that mold and mildew are not allowed to grow and damage the
components.
4. R wear to the boat before running it again.
5.
6.
3
7
10

mechanicto corrrate this product. ailure to operate in a safe and
responsible manner could result in injurge to the product or other prop-
ert. This product is not intended for use bren without direct adult supervi-
manner that does not endanger ourself and others or result in damage to the product
or propert.
•
• Never operate our boat while standing in water.
• Never operate our boat in the presence of swimmers.
•
working on or around these parts.
•
contact with is or serious injurcould result.
•
•
or injur. This boat is controlled bradio signal that is subject to interference
from manrces and could result in a momentarcontrol.
•
protected for this purpose. Moisture can damage unprotected electronics.
• Make sure to keep all chemicals, small parts, and anthing electrical out of the
reach of children.
4
Rage RC.

Important Note:
to the place of purchase immediatel.
Important
•
materials.
•
•
•
prge and/or personal injur. DO NOT use a NiCd or NiMh charger to
•
be removed from service immediatcompletel.
•
•
•
at room temperature (approximatto 77°ahrenheit) in a drrea for best results.
•
should be between 40 to 100°
• Li-ion cells should not be discharged to below 3.0 volts per cell. In the case of this 2-cell,
•
5

Important Note:
-
(approximatcst. This will take some management of the charge
6

7
er
1. Rotate the hatch lock on the hull cover clockwise to unlock
the speed control.
the hatch.
2. Remove the hull cover.
3.
4.
Ensure that the wires and plug are facing the front of the boat.
AntennaLight Switch
Steering Trim
Steering Dual Rates
Throttle Dual Rates
Steering Reverse
Indicator LED
Steering Wheel
Throttle Trigger
Power Switch
TRANSMITTER FUNCTIONS

8
Slide the switch
up for ON and
Solid red:
(below 4.3V).
is limited space, such as a pool).
Steering Dual Rates
Steering Reverse Switch
The steering trim is used if the steering is not centered
Steering Trim
Battery LED MonitorON/OFF Switch
Dual-Rate Functions
Servo Reverse
Switch
LED Lights
Button
Steering Trim

9
With the LightWave, there is no need to
or towards the driver for the boat to move
forward.
5. If binding is successful, the blinking light will turn solid. If not, start the binding process again with
step 1.
To stop, release the trigger.
Rotate the steering wheel to the right, or clockwise
turns.
Receiver Connection and Binding
How to Operate Your Boat

10
earlier in this manual
ed
Ce manuel convient aux modèles suivants
2
Table des matières

















