STEALTH-IN-1114
How Does the Super Stealth 360 Work?
The STL360’s infrared sensor “ sees” temperature changes caused by the
motion of people or cars within its protection zone and turns on lights
automatically. It welcomes visitors and may deter intruders.
Total coverage. Two sensors in one.
Two powerful detectors combine to
give the STL360“Can’t Miss”Detection:
180º long forward range (180º x 60’)
plus superb 360º detection below and
to all sides.
How do the scanning LED detection indicators work?
Scanning LEDs serve as a
deterrent by indicating a
security device in operation. They
also show the STL360’s mode of
operation.
Automatic Mode: When the STL360
is “On Guard” in Auto mode, three
red LEDs scan
continuously day and night, except
during detections
(at which time the controlled lights
will go on and LEDs will be o).
Test Mode:When the sensor is in
“Test Mode” all of the LEDs will be
o.
Manual Override Mode:
When the sensor is ready for
“Manual Override Mode” the middle
LED will be on steady.
Evening Timer Mode:
When the sensor is ready for“Eve-
ning Timer Mode Mode” the middle
LED will be blink.
TIME
1 8 HRS 5 SECS 12 MINS – +
EVENING
TIMER
SENS
How long do the lights stay on?
Lights remain on as long as there is movement within the
protection zone. Once the zone is vacated lights can be adjusted to remain
on approximately 5 seconds up to 12 minutes. Since the lights are on only
when needed, and the sensor uses only one watt. The Stealth is extremely
energy ecient.
Can outdoor lights still be turned on with the light switch?
Yes. STL360 can be controlled by a conventional indoor switch or circuit
breaker. STL360 operates in the auto mode unless changed. Lights can be
turned on or o manually at night only with the Manual Override Mode..
Wall Switch Manual Override: (to keep lights on)
Flip the switch twice slowly (o-on-o-on) within 1–2 seconds. If you set this
during the sensor will become “ready” for the Manual Override Mode and will
start Manual Override at dusk.
Evening Timer: (to keep lights on, and is repeated every night): Flip the
switch three times slowly (o-on-o-on-o-on) within 1½ – 3 seconds. You
can set this during the day and the Evening Timer Mode will begin at dusk.
To Resume Automatic Mode:
Switch power o for at least 10 seconds, then back on.
Will STL360 detect animals?
STL360 may detect large animals. Having animals trigger the sensor can give
property a “lived-in” look. However, you can limit animal detection by turning
down the sensitivity knob and/or placing the blinders provided on the lower
part of the forward lens.
How do you make
adjustments to the sensor?
Use the adjustment tool
provided, or a screwdriver with a 1/8”
wide blade, to adjust the controls
on the front of the sensor. (see page
11-12)
“On Guard Auto Mode”
LEDs scan continuously back & forth
“Test Mode” all LEDs o
Middle LED on steady is
Manual Override Mode
Middle LED blinking is
Evening Timer Mode
1 2
