RAB Lighting FFLED39 Manuel utilisateur

FFLED39 INSTALLATION INSTRUCTIONS

IMPORTANT

READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.

RAB xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper

grounding is required for safety. For xtures weighing more than 10lbs: Do not mount to an outlet cover unless a

separate splice box is used. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE

INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT

AND THE HAZARDS INVOLVED.

WARNING: Make certain power is OFF before installing or maintaining xture. No user serviceable

parts inside.

Thank you for buying RAB lighting xtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.

Call the Marketing Department at 888-RAB-1000, or email: marketing@rabweb.com

LOCATION

1. Seal arm thread using teon tape or silicone sealant.

2. Secure the LED Flood to a 1/2” NPS hole in a

junction box or landscape post.

3. Plug all unused holes and seal threads with silicone.

4. The swivel arm on the LED Flood allows 180º of

vertical aiming adjustment depending on mounting

location.

GUARD OR SHIELD INSTALLATION

Wire Guard and Poly Shield mount with (4) #8-32

Stainless Steel Screws. Screws are provided with

accessory. See gure 1 for Guard. See gure 2

for Shield

1. Line up guard with pre-existing, pre-drilled holes in

frame as shown, tighten screws.

GUARD & SHIELD INSTALLATION

The Wire Guard and Poly Shield can be mounted on the

same xture with (4) #8-32 screws as shown below.

Stainless

Steel

Screws

Stainless

Steel

Screws

Figure 1

Figure 2

WIRING

Universal voltage drivers permit operation at 120V to

277VAC, 50 or 60 Hz except xtures factory ordered

with a 120V photocell (/PC)

1. Connect the BLACK xture lead to the

(+) LINE supply lead.

2. Connect the WHITE xture lead to the

(-) COMMON supply lead.

3. Connect the bare copper Ground wire from xture

to supply ground.

FFLED39 INSTALLATION INSTRUCTIONS

FFLED39-IN-1011

CLEANING & MAINTENANCE

CAUTION: Be sure xture temperature is cool

enough to touch. Do not clean or maintain while

xture is energized.

1. Clean glass lens with non-abrasive glass cleaning

solution.

2. Do not open the xture to clean the LED. Do not

touch the LED.

TROUBLESHOOTING

1. Check that the line voltage at the xture is correct.

Refer to wiring directions.

2. Is the xture grounded properly?

3. Is the photocell, if used, functioning properly?

Note: These instructions do not cover all details or variations

in equipment nor do they provide for every possible situation

during installation, operation or maintenance.

US:Pat D643,147, CA: Pat Pending CN: Pat Pending,

MX: Pat Pending

ACCESSORIES AND

REPLACEMENT PARTS

Chrome Wire Guard: GDFFLED39W

Poly Shield: GDFFLED39P

Lens & Door Replacement: LFFLED39 (bronze)

LFFLED39W (white)

FFLED39 Cool FFLED39N Neutral FFLED39Y Warm

Table des matières

Autres manuels RAB Lighting Projecteur

RAB Lighting

RAB Lighting SMSBULLET2X12 Manuel utilisateur

RAB Lighting

RAB Lighting CANVAS78TW Manuel utilisateur

RAB Lighting

RAB Lighting WP2C Manuel de service

RAB Lighting

RAB Lighting FXLED Series Manuel utilisateur

RAB Lighting

RAB Lighting Gotcha! Plus GT500 Manuel utilisateur

RAB Lighting

RAB Lighting BULLET2X12 Manuel utilisateur

RAB Lighting

RAB Lighting FFLED Slipfitter Manuel de service

RAB Lighting

RAB Lighting PIP XL 70W Manuel utilisateur

RAB Lighting

RAB Lighting SMARTBULLET SQB1 Manuel utilisateur

RAB Lighting

RAB Lighting FLEX FLOOD Manuel de service

RAB Lighting

RAB Lighting FLOODZILLA Manuel utilisateur

RAB Lighting

RAB Lighting LESLIE SMSLES2X13 Manuel utilisateur

RAB Lighting

RAB Lighting ANGSHARK Manuel utilisateur

Manuels Projecteur populaires d'autres marques

VIZULO

VIZULO Micro Martin Guide de l'utilisateur

EuroLite

EuroLite LED IP FL-100 SMD Manuel utilisateur

Cooper Wheelock

Cooper Wheelock XB12 Manuel utilisateur

Allen + Roth

Allen + Roth 17624-000 Manuel utilisateur

ADJ

ADJ 4 STAGE PAK Manuel utilisateur

Cooper Lighting

Cooper Lighting EGL91SW233 Manuel utilisateur

Max

Max 37496 Manuel utilisateur

BEGA

BEGA 85 143 Manuel utilisateur

Beamz

Beamz 151.226 Manuel utilisateur

EuroLite

EuroLite LED IP FL-8 Manuel utilisateur

Ledj

Ledj PERFORMER 36 RGB Manuel utilisateur

Perel

Perel ELS3 Manuel utilisateur

Perel

Perel ELS3WD Manuel utilisateur

LumX

LumX LM 36130 Manuel utilisateur

Xtricity

Xtricity 4-80053 Manuel utilisateur

Stahl

Stahl 6521/4 Series Manuel utilisateur

Ecosense

Ecosense EcoSpec Manuel utilisateur

Ayrton

Ayrton minipanel FX Manuel utilisateur