RA EBM Manuel utilisateur

8W Emergency Exit

Box Installation

Instructions p.1

Red Arrow Trading

Elsworth House, Herries Road South

Sheffield, S6 1QS

T: 0800 195 0006 F: 0870 043 3946

E: [email protected] www.redarrowtrading.com

For models: EBM

This installation must be carried out by an electrician. Please read these instructions carefully

before installation. Leave a copy for the user/maintenance engineer for future reference.

Specification

• 8W Emergency Exit Box

• 240V

• 8W T5 Fluorescent Tube

• 100 Lumen Output

• 3 Hours emergency duration

• 1 Year guarantee

• IP20

• Powder coated steel body, polycarbonate legend

General Information

These instructions contain important information

regarding safety. They should be read carefully and retained

at the installation for future reference. We will not accept any

responsibility for any injury, damage or loss which may arise

as a result of incorrect installation, operation or maintenance

due to non-adherence to these instructions.

The emergency lighting must be installed by a competent

person or persons in accordance with the relevant wiring

regulations.

All self-contained emergency lighting luminaires require a

continuous 220V/240V single phase 50Hz supply to deep

the inbuilt batteries charged. This supply must be taken from

the lighting supply in the area being protected in order that

should the mains lighting supply fail the emergency lighting in

that area will illuminate.

In addition MAINTAINED and SUSTAINED fittings require

a separate switched live supply enabling the fitting to be

operated normally from the mains supply.

Please note: The design life of a T5 fluorescent lamp is 5000

hours and therefore if maintained / sustained fittings all

illuminated 24 hours a day lamp life will be approximately 6

months. If the lamps are not replaced promptly, the

luminaires circuitry maybe damaged.

Before commencing installation (and before work of any kind

takes place) ensure that the electrical supply and the battery

pack are disconnected.

EMERGENCY LIGHTS SHOULD ONLY BE CONNECTED

TO A STABLE, PERMANENT ELECTRICAL SUPPLY.

FREQUENT SUPPLY INTERRUPTIONS WILL RESULT IN

DAMAGING “CHARGE/DISCHAGE” CYCLING OF THE

FITTING AND WILL INVALIDATE ANY GUARANTEE.

Safety Instructions

1. Ensure sufficient distance around the apparatus for the

correct ventilation.

2. Ventilation should not be impeded by covering the unit in

anyway.

3. Please dispose of any batteries in the correct manner.

4. Do not use in tropical and / or high temperature climates.

5. Do not allow any water to come into contact with this

product.

6. If the external flexible cable or cord to this light fitting is

damaged, it must be replaced by a qualified electrician on

order to avoid a hazard.

Installation Instructions

1. Fix the light fitting to wall.

IMPORTANT NOTE: TO EXTEND BATTERY LIFE ALWAYS

FIT LUMINAIRE WITH BATTERIES AT THE BOTTOM

WHEN WALL MOUNTING.

2. Connect mains supply wiring as follows:

3. For component protection in transit and user safety the

luminaire battery fuse is supplied separately in the fitting.

4. When all connections have been made reassemble the fitting

completely.

5. Switch on 220V~240V AC supply and check that the green

LED indicator illuminates to conform charging of batteries.

6. Allow a short period for part charging of the batteries and

then isolate the mains supply to the fitting in order to check

the correct operation of the fitting in emergency mode.

After a further 36 hours on continuous charge (and only at

a safe appropriate time) a mains failure should be simulated

to ensure that the fitting illuminates for its specified time.

Thereafter the fitting will have at least 1 hours backup after

14 hours chanrge and will be fully charged within 24 hours.

8W Emergency Exit

Box Installation

Instructions p.2

For models: EBM

T: 0800 195 0006 F: 0870 043 3946

E: [email protected] www.redarrowtrading.com

Red Arrow Trading

Elsworth House, Herries Road South

Sheffield, S6 1QS

Maintenance

1. Failed lamps should be replaced promptly to avoid damage to the luminaire.

2. Repairs should only be carried out by a qualified electrician. Only replacement components authorised by Red Arrow should

be used. Disposal of replaced components should be in accordance with the component manufactures instructions.

3. Special care should be taken if it is required to open the fitting beyond that which is necessary for re-lamping the fitting

may still be live even though the mains supplies have been disconnected. In these circumstances disconnect the battery

supply immediately.

4. Servicing, cleaning, lamp replacement etc. Should only be carried out after the fitting has been made electrically safe.

5. Cleaning of luminaires should be carried out at regular intervals not only to ensure good optical performance but also to

ensure that dirt does not accumulate to impair the electrical or thermal safety of the fitting.

6. To avoid damage to the luminaire failed lamps should be replaced promptly with a lamp of the recommended type and

rating, and of the same manufacture following these instructions.

7. The rated life of miniature T5 fluorescent tubes operating continuously on emergency maintained / sustained circuits is

some 5,000 hours. Therefore all lamps operating continuously in maintained / sustained fittings should be replaced on a 4

to 6 monthly maintenance schedule to maintain maximum system integrity.

8. NB Due to the small diameter of T5 fluorescent tubes manufacturers are unable to fit electrode shields as fitted to larger

T12 tubes and therefore some blackening of the tube ends is to be expected as a normal characteristic.

9. Batteries are the Nickel Cadmium type and have a normal service life of approximately 4 years.

10. Battery replacement should be carried out after 4 year period.

Month Test Year 1 Year 2 Year 3 Year 4 Year 5

signed date signed date signed date signed date signed date

1Functional

2Functional

3 Functional

4 Functional

5 Functional

6 1 hour

7 Functional

8 Functional

9 Functional

10 Functional

11 Functional

12 1 hour

3 hour

Product complies with

all relevant European

standards

Product is suitable for

mounting on flammable

material

Guarantee

This product is guaranteed for a period of 1 year from the date of purchase. The guarantee is invalid in the case of improper use, tampering, removal of the Q.C. date label, installation in

an improper working environment or installation not according to the current edition of the I.E.E. Wiring Regulations (BS7671). The guarantee is also invalidated if the luminaire has

been Mega tested. Should this product fail during the guarantee period it will be replaced free of charge, subject to correct installation and return of the faulty unit. We do not accept

responsibility for any installation costs associated with the replacement of this product. e reserve the right to alter specifications without prior notice.

Table des matières

Autres manuels RA Équipement d'éclairage