Quest Engineering Q40 Manuel utilisateur
40
QUEST
metal detectors
IN THE BOX
QUICK START
ASSEMBLE
QUICK START
For the first time using. You need a philip screw
driver to assemble the unit. Follow the steps
illustrated and set a comfortable distance of the
handle and tight the screws.
1
5
4
3
6
7
2
8
1Sec
QUICK START
ON
OFF
POWER ON/OFF
04:00Hr FULL
WIRELESS HEADPHONES
1Sec
Ater power on the Q40 and wireless
headphone, press the button on the
right side once to activate the wireless
function. The headphones have been
pre-paired. If necessary place the
headphone 5 inches close the console
and press the power button once to pair.
WIRE HEADPHONES
HEADPHONES/CHARGE
On/Off
QUICK START
4Sec
QUICK START
MUTE／MAX VOLUME
VOLUME + - 1
SPEAKER VOLUME
QUICK START
Power tower, base station and even
houses will cause falsing alarm
when no metal under the coil.
Users can reduce the sensitivity by
pressing on the downward triangle
buttons directly.
Users can increase the sensitivity
by pressing the upward triangle
when searching on low
interference locations.
HOLD
+／- ONE LEVEL
FAST+/ - SENSITIVITY
SENSITIVITY
Level-up
After powered on the detector, press the M button once to select
different modes.
•COIN MODE very stable, medium recover speed, target for
ancient or morden coins. TID range 40~99
•JEWELRY MODE very sensitive, high recover speed, target at gold
rings jewelry items. TID range 20~99
•ALL METAL MODE very sensitive high recovery speed. ZERO
discrimination. Good for gold prospecting.
•BEACH MODE normal sensitivity, low recover speed, strong
saltwater immunity. 20~99
PROGRAM
Level-up
By pressing on the PINPOINT
button(the round button with cross
sign), the detector will enter a non-
motion mode and alarm to target
without moving the coil. Users can
use this function to pinpoint target
with cross action as illustrated.
We strongly recommend to select
the Xpointer for further assistance
during digging to save the time.
HOLD
PINPOINTING
Level-up
The Q40 come with ground balancing(G.B.) function. We recommend
G.B. every time you change the detecting area. Please press and hold
the square button and pump the coil from 6”/15cm height to 1” from
the ground. When you do not hear the sound is not been pulled from
the ground or pushed to the ground, the G.B. is finished.
The ground mineralization condition is indicated by the round bar with
Fe%. The G.C. with two digit indicate the Ground Canceling level. If
you can not G.B. at high mineralization ground you can use G.C.
function on the MENU to set manually.
GROUND BALANCING
HOLD&PUMP
Autres manuels pour Q40
1
Table des matières
Autres manuels Quest Engineering Capteur de sécurité
