Pyle PWMA130 Manuel utilisateur
WIRELESS RECHARGEABLE
PORTABLE AMPLIFIER
PWMA130
USER'S MANUAL
WWW.PYLEAUDIO.COM
1. This system is with cassette player and recorder.
2. B
uilt-in one channel wireless receiver. W
ith TONE and ECHO controls. Suitable for karaoke.
7. With power, charging, low battery and RF indicators.
8.
uilt-in 12V2.2A rechargeable battery. Suitable for both indoor
and outdoor use.
3. B ith one handheld
microphone or body pack transmitter with headset MIC and
lapel MIC.
4. With one 6.35mm MIC input jack and one RCA line input jack.
5. With one 6.35mm line out jack and one 3.5mm phone out jack.
6. W
Power supply : AC, DC 12V, built-in rechargeable battery.
9. Power Output: 120W
CAUTIONS
1. Free from high temperature. Don't expose the device to
equipment.
2. Don't place the device in the environment of humidity and dirts.
3. Place the device in the ventilated environment.
4. Don't pull the power cord while you pull out the plug. H
plug to pull out Ac power.
5. Pull out the AC power if you will not use the device for a long
time.
6. Your operation must be subjected to the specified voltage
the device and complied with this guide.
7. Don't open chassis :it is very dangerous to open the
your hand inside the chassis. If the device is not proper,
pull out the plug at once and retailer or the
nearest distributor.
hot
old the
marked on
chassis or
put
contact your
PARTS DESCRIPTION
FEATURES
1
2
3
4
56
7
8
9
10
11
12
13
14
++
DC 12VDC 12V
MICMIC
LINE OUTLINE OUT
LINELINE
ININ
PHONEPHONE
15
16
17
18
19
1. Battery compartment/cover
2. AC input jack
3. AF level indicator
4. Cassette player and recorder
5. Handle
6. Antenna
7. Low battery power indicator
8. Charging indicator
9. Amplifier power indicator
10. Wireless MIC RF indicator
11.Power switch and master
volume control
12. Tape volume control
13. Echo control
14. Tone control
15. MIC in jack
16. Line out jack
17. Line in jack
18. Phone out jack
19. DC in jack
AMPLIFIER
-1- -2-
ʹÓÃ˵Ã÷
1. Confirm the power:
A. When use AC power:
1) Please confirm the AC power is same as that marked on
(Near AC in jack). Or the device may not work
or be damaged.
2) Turn on the volume control in clockwise direction, power
indicator will light to indicate normal power.
B. When use the build-in DC 12V rechargeable battery:
1) Open battery compartment. Connect rechargeable battery
to DC connector with correct polarity(Red means +, Black
means -).
2) Turn on the volume control in clockwise direction, power
indicator will light to indicate normal power. If low battery
it means battery power is low. Please
the battery.
C. When use external DC power:
1) DC power can be input into by DC power jack directly.
2) When use car battery: voltage should be 12V-15V. Please
correct polarity.
2. Recharging the battery:
A. Plug the power cable into AC power jack for recharging.
time is about 10 hours.
B. When CHARGE indicator turns to GREEN from RED, it
means battery is fully charged.
C. Please recharge the battery every 2 months if you don't use
long time.
D. Battery will be charged either main power is off or on
3. Tape play:
Turn on the power/volume control in clockwise direction,
power indicator will light red. Press the STOP/EJECT key on
the cassette. Cassette door will open. Insert tape and close
the
the device
indicator lights,
connect AC power to charge
note the
Charging
it for a
cassette by pushing the top right corner of cassette door.
Press PLAY/PAUSE button to start playing of tape. The signal
PARTS DESCRIPTION OPERATION
WIRELESS TRANSMITTER
1
2
3
4
Handheld MIC
23
4
5
Body pack transmitter
6
7
1. Grille(capsule inside)
2. Power indicator
3. Power switch
4. Battery compartment
5. MIC in jack
6. Tie clip MIC
7. Headset MIC
-3- -4-
Remarks:
Body pack transmitter, headset MIC and tie clip MIC are
optional.
¼¼Êõ²ÎÊý
À©Òô»ú
·¢ÉäÆ÷
ʹÓÃ˵Ã÷ʹÓÃ˵Ã÷
OPERATION SPECIFICATIONS
AMPLIFIER
TRANSMITTER
VHF
600
165~270MHz
60dB
+/-0.005%(-20 ~40 )
120W
50M(line and sight area)
AC 120V 60Hz
Level indicator shows the signal strength. Use power/volume
control and TAPE volume control to adjust the volume. Adjust
tone control to achieve the best sound quality.
4. Tape record:
Open the cassette door and insert a blank tape. Press the
REC key and PLAY key simultaneously to start recording.
Signal from wireless microphone, MIC in jack and Line in jack
can be recorded.
5. Wireless Microphone:
A. Insert a 9V battery into the wireless transmitter. Turn on
transmitter power switch, power LED indicator will flash
once then off.
NOTE: When transmitter power indicator lights red, it
means the transmitter battery power is low. Please replace
with new battery.
B. RF indicator on amplifier will light.
C. Extend the antenna on the top of amplifier fully.
D. Adjust amplifier volume, tone, echo control to a suitable
Level.
E. Keep transmitter at least 1m from speaker of main unit to
Avoid feedback. If feedback happens, lower the volume
and move transmitter away from main unit.
6. Wired Microphone:
Plug wired microphone into MIC input jack. Keep MIC head
away from the speaker of main unit to avoid feedback.
7. External audio source:
You can play other audio device by connecting output of
other audio source to line input jack.
8. Line out:
Connect line out to external amplifier to amplify the sound.
9. Phone out: Connect phone out to earphone.
-5- -6-
Receiving Mode:
Output Impedance:
Frequency Range:
S/N Ratio:
Frequency Stability:
Power Output:
Effective Distance:
Power supply:
Frequency Range:
Dynamic Range:
Frequency Response:
Working Temperature:
Power Supply:
Battery Life:
VHF 165~270MHz
80dB
100~10KHz
-20 ~40
9V battery
10 hours
Autres manuels Pyle Intervenants
Pyle
Pyle PBMSPG144 Manuel utilisateur
Pyle
Pyle PMP561LTB Manuel utilisateur
Pyle
Pyle PWRC55BT Manuel utilisateur
Pyle
Pyle PLD63C Manuel utilisateur
Pyle
Pyle PLD64C Manuel utilisateur
Pyle
Pyle PG680A Manuel utilisateur
Pyle
Pyle PDICS6 Manuel utilisateur
Pyle
Pyle PDWR69BTB Manuel utilisateur
Pyle
Pyle PWMA-260 Manuel utilisateur
Pyle
Pyle PLMCA51BT Manuel utilisateur
Pyle
Pyle PPHD210 Manuel utilisateur
Pyle
Pyle PWPBTA70 Manuel utilisateur
Pyle
Pyle PPHP28AMX Manuel utilisateur
Pyle
Pyle PMP43iN Manuel utilisateur
Pyle
Pyle PSRB8 Manuel utilisateur
Pyle
Pyle PTVSP20BK Manuel utilisateur
Pyle
Pyle PPHP158BMA Manuel utilisateur
Pyle
Pyle PPHP 159WMU Manuel utilisateur
Pyle
Pyle PHP18DJT Manuel utilisateur
Pyle
Pyle PWMA-370 Manuel utilisateur
Manuels Intervenants populaires d'autres marques
Bowers & Wilkins
Bowers & Wilkins 4 Manuel utilisateur
Sonance
Sonance SONOS OUTDOOR Series Manuel utilisateur
Electro-Voice
Electro-Voice EVID FM4.2 Manuel utilisateur
Pioneer
Pioneer XW-HTD630 Manuel utilisateur
Onn
Onn BWA16AA002 Manuel utilisateur
HP
HP GL313AA - USB Speakers PC Multimedia Manuel utilisateur