PVI PV 6127b Manuel utilisateur

PV 6127b 6/01 1

SPECIFICATION FOR DOMESTIC WATER HEATERS

Atmospheric Combustion, Gas-Fired Water Heaters

with Polymer-Lined Storage Tanks

Furnish and install atmospheric gas water heater(s) as manufactured by PVI Industries, L.L.C.

of Fort Worth, Texas. Supply quantities and model numbers as indicated on the plumbing schedule.

Gas and Electrical Consumption

The water heater will operate at 80% thermal efficiency. The water heater will comply with paragraph 7.2.4.4, the

thermal efficiency, the standby loss, and all other requirements of ASHRAE 90.1-1999.

Pressure Vessel and Heating Surfaces

The water heater will be a vertical fire tube design that is constructed and stamped in accordance with Section IV,

Part HLW of the ASME code. Both the storage and heating sections of the water heater will be National Board

Registered for a working pressure of 150 psi and will be pressure tested at 1-1/2 times working pressure. The fireside of

the heating surfaces will be of boiler-grade steel. The waterside of the heating tubes will be sealed in copper. The

heating tubes will be rolled, beaded, and seal welded into the tube sheets. The combustion side of the tube sheet will be

insulated by a layer of ceramic fiber that will protect the tube sheet from both thermal stresses and failure that can result

from the accumulation of scale and precipitants.

Tank Lining

The lining will:

be applied only after the tank is completely fabricated and all welding is completed.

consist of multiple applications of high-temperature fluoropolymer.

be third-party tested to and comply with NSF 61standard.

be continuous and nonporous with no interruptions or discontinuities.

require no sacrificial anode rods for protection.

Burner and Venting

Combustion will be provided by an atmospheric burner with a gas train meeting the following agency requirement for

the input specified:

___ UL (standard) ____ FM ___ IRI ___ Other ______________________

Water heater will be a category 1, non-condensing appliance. It will be UL-listed for use with non-pressurized, type

B venting material.

Safety Controls

As a minimum, the heater will be equipped with the following:

•electronic flame monitoring

•two immersion operating thermostats

•an immersion temperature limiting device

•an ASME- or AGA-rated temperature and pressure relief valve

•and options as selected on form PV 6071

(continued)

PV 6127b 6/01 2

SPECIFICATION FOR DOMESTIC WATER HEATERS

Atmospheric Combustion, Gas-Fired Water Heaters

with Polymer-Lined Storage Tanks

(continued)

Warranty Summary

The burner and all heater parts will have a one-year warranty. Storage tank, heating surfaces, and combustion

chamber will have a five-year warranty covering manufacturing or material defects, leaks, and/or the production of rusty

water. Tank and heating surfaces will have a three-year warranty against failure due to scale buildup with no provisions

for periodic cleaning. The heater will have a _____ first year or ____ long-life service policy, which will cover replacement

labor and freight costs under certain conditions. Initiation and /or continuation of warranty coverage will not be

dependent upon annual inspections, regular replacement of anode rods, or water chemistry. Complete copies of all

warranties and service policies, including all exclusions and conditions, will be presented to the owner as part of the

submittal package. These summaries are not warranties. Consult warranty and policies for full details.

Finishing

The storage and heating sections will be completely factory packaged, requiring only job site hookup to utilities,

venting, and plumbing. The heater will be insulated, jacketed with enameled steel panels, and mounted on heavy-duty

channel skids. The heater will fit properly in the space provided and installation will conform to all local, state, and

national codes.

Start Up

Start up on the unit will be performed by factory trained and authorized personnel. A copy of the start up report will

be provided to the owner.

Quality Certification and Safety Standards

The heater will be have an independent test laboratory listing to safety standard UL 795 or ANSI Z21.10.3. The

water heaters will be manufactured by a company that has achieved certification to the ISO 9001 International Quality

System.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels PVI Chauffe-eau

PVI

PVI QuickDraw Manuel utilisateur

PVI

PVI PV 6126b Manuel utilisateur

PVI

PVI Durawatt CL Manuel utilisateur

PVI

PVI PV 6813 Manuel utilisateur

PVI

PVI QuickDraw Boiler Water PV 6347 Manuel utilisateur

PVI

PVI PV 6804 Manuel utilisateur

PVI

PVI PV 6319 Manuel utilisateur

PVI

PVI NICKELSHIELD PV 5369 Manuel utilisateur

PVI

PVI MAXIM Manuel utilisateur

PVI

PVI PV 413A Manuel d'installation

PVI

PVI Storage and Semi-instantaneous Steam Heaters... Manuel

PVI

PVI MAXIM Manuel utilisateur

PVI

PVI conquest 50 L 130 A-GCML Mode d’emploi

PVI

PVI Domestic Water Heater Manuel utilisateur

PVI

PVI PV 6112b Manuel utilisateur

PVI

PVI Durawatt Polymer-Plated Storage Tank Manuel utilisateur

PVI

PVI NickelShield Tank Series Manuel utilisateur

PVI

PVI CSX Single-Exchanger Manuel utilisateur

PVI

PVI MAXIM Manuel utilisateur

PVI

PVI Polyshield 119 Gallon Tank Series Manuel utilisateur

PVI

PVI Tank Series Manuel utilisateur

PVI

PVI PV 6150b Manuel utilisateur

PVI

PVI PVI DURAWATT Mode d’emploi

PVI

PVI QuickDraw PV500-24 Manuel

Manuels Chauffe-eau populaires d'autres marques

Kenmore

Kenmore 153.582400 Manuel utilisateur

Applimo

Applimo Edel AIR Manuel utilisateur

STIEBEL ELTRON

STIEBEL ELTRON Eltronom SHU 5 S Manuel utilisateur

clage

clage E-Mini Series Manuel utilisateur

Toyotomi

Toyotomi Oil Miser OM-180 Manuel utilisateur

Bradford White

Bradford White EF Series Manuel utilisateur

Eccotemp

Eccotemp 40-H Manuel utilisateur

Dimplex

Dimplex ECSd125-580 Mode d’emploi

Dux

Dux 32FCR6N Manuel utilisateur

Toyotomi

Toyotomi Oil Miser OM-148 (Type D) Guide de dépannage

Noritz

Noritz N-132M Manuel d'instructions

TESY

TESY GCV7/4S 10047 Fiche technique

A.O. Smith

A.O. Smith Gphe 50 Manuel utilisateur

Koryo

Koryo KWHZF15Y Manuel utilisateur

Pentair

Pentair PSC-14-4-02 Manuel utilisateur

GE 40M06AAG Instructions de montage

Thermor

Thermor AEROMAX SPLIT 2 Manuel utilisateur

American Hometec

American Hometec AHQ-B03X Manuel utilisateur