6
OPERATING INSTRUCTIONS
BEFORE USE
Before use, remove all packaging and insect the appliance
for any damages. If there are appears to be any damages,
please contact place of purchase for a replacement.
-
Ensure that all the accessories are included as per diagram
above before you continue with installation.
-
Ensure that the location of the heater is not directly under a
power socket and that a power socket is available to power
the appliance for use.
-
Plug the unit in and turn on the main power switch at the
back of the unit.
Press the Standby button to turn on the unit, this will enter Fan
Mode. Press again to turn off.
Press once to activate Low Heat (1100W). Press again to
activate High Heat (2000W)
Press to increase the desired room temperature.
+
Press to decrease the desired room temperature.
-
Temperature can be set between 10 - 49°C
-
When the heater has reached the desired set temperature,
the fan mode will continue to blow until the temperature has
dropped to 2°C below the et temperature (the heater will
automatically turn on the low heat setting, if the temperature
drops 4°C below the set temperature the heater will
automatically choose the high heat setting.)
-
Press to activate oscillation. Press again to stop oscillation.
Press until you reach the desired number of hours (up to
8hrs) before you want the heater to turn OFF.
PLEASE NOTE: When the heater has been turned off, the fan will continue
to work for 30 - 60 seconds to cool the appliance.
Note: temperature set using the + / - buttons will not be reached if it is
less than the current room temperature.
