Page 5 of 48
1. Introduction
THIS DOCUMENT CONTAINS INFORMATION TO BE USED BY QUALIFIED PERSONNEL ONLY
1.1 Receiving Inspection
All materials relative to supply are delivered to the shipper in perfect condition after thorough final
testing and packaging. Inspect goods immediately upon receipt and check:
oThe goods received correspond to the order made
oThe packaging has not undergone damage due to transport or has not been tampered with
oThe actual condition of goods
If anomalies or damage are found immediately issue a complaint with the courier and inform
Pulsafeeder aftermarket service at Proservice@idexcorp.com or call Pulsafeeder at 585-292-8000.
1.2 General Information
The purpose of these instructions is to refer information deemed necessary for understanding as
much as possible about and facilitating the installation, commissioning, use and maintenance of
hydraulic diaphragm metering pumps.
1.3 Personnel Responsible for Pump Operation
Anyone operating the pump should have read and understood the instructions set forth within this
manual. The employer must instruct all staff on the risks of accidents and on devices and clothing
to be used for individual safety.
1.4 Testing
Each Pulsafeeder metering pump is a reliable quality product, subject to careful final inspection to
ensure their proper functioning and found compliance with the specified performance. The final test
results, if specifically requested by contract, are registered and made available to the customer.
Pulsafeeder offers many different tests available with your PulsaPro pump.
1.5 Warranty
PulsaPro metering pumps are guaranteed for a period of eighteen (18) months from the date of
shipment. Drive assemblies (gearing, shafts, eccentric, and related components within gearbox)
are guaranteed for a period of sixty (60) months from the date of shipment. The guarantee covers
replacement, free of charge, of any component found to be defective in material or processing by
the Aftermarket Service Group at Pulsafeeder, Inc.
The Warranty is NOT valid in the following cases:
oComponents subject to normal wear (gaskets, seals, O-rings)
oInstallation and/or use do not meet the technical conditions of sale and instruction
oIf the pump has been tampered with or disassembled
oMotor (drive) is covered by the motor manufacturer
1.6 Requesting Spare Parts
For preventative maintenance, Pulsafeeder recommends the installation of a KOPkit (Keep-On-
Pumping), which includes the recommended spare parts needed. The part number for this kit can
be located on the pump nameplate as well as the specification data sheet provided with your
metering pump.
For other needed components, find and study the sectional drawings of the pump in use, if
necessary, contact Pulsafeeder to obtain a copy. For drawings and bill of materials for your
pump(s)
please
s
end
an
email
to
Pro[email protected]. Using the nomenclature of the sectional drawing, make a list of the parts needed and send to your local Pulsafeeder sales representative,
always specify the pump serial number.
