PTS-G5K13M PTS Co., Ltd. 8
2-2 Control Specification
The RF Generator is Analog mode and Manual Mode by which RS-232C
output control is possible (on request, Device-net control would be available
as optional specification).
①Analog Mode
Via D-sub 25 pin terminal on the back of Generator, power can be
controlled through interlock confirmed by Analog Voltage.
②Manual Mode
Connect the Handy Controller provided on the front of the Power Control.
Setting Parameters can be various to make the Interlock OK.
③RS-232C Mode(Device-net option available up on selection): Power Control
can be controlled via RS-232C terminal (Device-Net Selectable) on the rear of
Generator.
2-3 Installation site
①Please maintain the ambient temperature to 5 ~ 40 ℃ when the generator
is in operation( Power output ON)
②Please keep in storage area of temperature -25 ~ 55 ℃ when it is not under
operation.
③Do not install in places with high humidity, dusty, where there is a direct
sunlight or places where there is any risk of water or other liquid leakage.
Getting the product wet with water or other liquid may cause damage that
cannot be repaired.
④Use and store in a level and stable place.
2-5 Installation Requirements
①Fill out the front and rear of the cooling fan blower of the product smoothly.
②Rack 적재시 전면부(＞15cm), 측면부(＞15cm), 후면부(＞30cm)여공간과
Rack의전면부, 후면부에 배기구를 설치해 주십시요.
Generator 후면부의 열기가 축적되지 않게 해주십시요.
③Generator Rack에6㎥/min이상의 배기팬을 설치하여 주십시요.
