Proteus EEC-1500 Manuel utilisateur

Owner's manual

EEC-1500/5550

ELLIPTICAL

Features of product with GS-TUV mark :

Mechanical safety.

Symbol of high quality.

Reliability assurance.

Testing specification :

EN 957-1+A1, EN 957-9.

INDEX . . . . . . . . . . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Introduction / Safety Guideline

Information EEC-1500 / 5550

Assembly

Exploded View

Parts List

01~03

04~06

- 1 -

INTRODUCTION/SAFETY GUIDELINE

A. Introduction

Thank you very much for choosing PROTEUS products. To ensure your safety, please read the

manual and all suggestions carefully before using this product. While you get everything ready,

believe that you could enjoy the pleasure of exercise and healthy.

B. Safety guideline

a. Read the owner's manual and all accompanying literature. Follow it carefully before using your

machine.

c. Inspect your exercise machine prior to exercising to ensure that all nuts and bolts are fully

tightened .

d. Make sure machine is stable on the floor. Avoid uneven surfaces.

e. Most exercise equipment is not recommended for small children.Children should not use the

machine. Keep unsupervised children away from the equipment.

f. Exercise equipment has moving parts. Keep others, especially children, at a safe distance

while exercising.

g. Make sure all devices are fully adjusted before use to avoid injury.

h. Remove all jewelry, including rings, chains and pins before exercising.

i. Always wear suitable clothing and footwear during exercise. Do not wear loose fitting clothing

that could become caught in the moving parts of your exercise machine.

j. Warm up 5 to 10 minutes before each workout and cool down 5 to 10 minutes afterward. This

allows your heart rate to gradually increase and decrease and will help prevent muscle strain.

k. Never hold your breath while exercising. You should breathe at a normal rate in conjunction

with the level of exercise being performed.

l. Rest adequately between workouts. Muscles tone and develop during these rest periods.

Beginners should work out twice a week and increase gradually to 4 or 5 times per week.

m.Do not "over train". Incorrect or excessive training may result in Injury.

This machine is intended for indoor home use only. It is not designed for commercial use.

Information on braking system:

Speed-dependent : With increasing speed more power is required to drive

the bike and vice versa.

Important : Read all instructions carefully. Assemble the unit in accordance with the steps in

the manual. Lay out all parts on the floor and check if you have all the parts

included completely before begin assembly. In case of a discrepancy, please call

customer service of the store for help.

Note : Some parts may be factory pre-assembled.

Warning : Before beginning any exercise program, please consult your physician. If at any

time you feel faint, dizzy or are experiencing pain, stop and consult your physician.

The manufacturer may use same as a defense to any claim for injuries, damage or

loss. The above warnings are in no way intended to limit or modify the consumer's

remedies for breach of warranties pursuant to applicable federal and state laws

of regulations. They are being supplied strictly to ensure the safety of the

individuals using this product.

The appliances are not for children under 14 years of ages.

The safety level of the equipment can be maintained only if it is examined regularly for

damaged and wear.

Safe distance : Front and back : 50cm

Left and right sides : 30cm

Replace defective components immediately and keep the equipment out of use

until repaired.

BEFORE YOU BEGIN

- 2 -

IMPORTANT : THE MAXIMUM RECOMMENDED WEIGHT CAPACITY FOR YOUR

EQUIPMENT IS 125 KG ( 275 LB ). ALL OF THE TEST STIPULATE

TO THE EN 957-1+A1 / -9, CLASS HC.

CLASS H: ( HOME ) DOMESTIC USE.

CLASS C: MINIMUM ACCURACY.

NOTE :THE EQUIPMENT IS SPEED-DEPENDENT ON BRAKING SYSTEM.

Bearing / Belt

C. Information EEC-1500 / 5550

- 3 -

We enclose with three simple assembling tools for your assembly convenience

One spanner, one allen key & one screwdriver.

THE MOST SUSCEPTIBLE TO WEAR PARTS ARE

TOOLS REQUIRED FOR ASSEMBLY

Note : If your model no. Is EEC-5550, do not plug to power supply before

machine is fully assembled. Input power supply specification

depends on local electricity supply , and a proper transformer may

be needed.

DC transformer spec. : Input : 220-240V (100-120V) ~ 50HZ

Output : 6V 500 mA

INFORMATION EEC-1500/5550 SERVICE INFORMATION

Resistance External Magnetic Wheel External Magnetic Wheel

Driving Industrial Poly-V Belt 1549-J-6 Industrial Poly-V Belt 1549-J-6

Hub Industrial Double Sealed Industrial Double Sealed

Bearing 6203ZZ Bearing 6203ZZ

Axle / Crank Three-Piece Type Three-Piece Type

Max User Weight 125 kg 125 kg

Machine Size 139 x 73 x 160 cm 139 x 73 x 160 cm

Carton Size 123 x 37 x 91.5 / 39.5 cm 123 x 37 x 91.5 / 39.5 cm

NW / GW 53.4 / 59.0 kg 54.4 / 59.3 kg

EEC-1500 EEC-5550

Step 1 : Assemble handlebar post

Fold up the handlebar post ( 17 ) to the

upright position, fix with bolts ( 34 / 35 )

and washers ( 36 ). Then fully tighten

them with spanner.

Step 2 : Assemble protective cover

Step 3 : Assemble stabilizer

Attach front stabilizer ( 02 ) & rear

stabilizer ( 03 ) to main frame ( 01 ) , fix

with carriage bolts ( 40 ) , washers ( 42 )

and nuts ( 41 ). Then fully tighten them

with spanner.

Step 4 : Assemble adjust tube ( for EEC-5550 )

a. Insert adjust tube ( 52 ) to the

connecting arms ( 13 / 14 ) and fix

with knob ( 54 ).

b. Connecting arms adjust :

Adjust the height of the pedal arm

( 04 / 05 ) by the knob ( 54 ).

Tightened the knob ( 54 ) firmly after

adjustment.

Fix the protective cover ( L )( 37 ) to the

main frame ( 01 )with screw ( 39 ).

Repeat same procedure on protective

cover ( R )( 38 ). Then tighten them

with screwdriver.

ASSEMBLY

- 4 -

40 19

42 41

41 42

STEP 4 14

15 53

STEP 3

STEP 2

STEP 1

1 36

- 5 -

Step 5 : Assemble pedal

a. Fix pedal ( L )( 10 ) to pedal arm

( L )( 04 ) with screws ( 43 ) &

washers ( 44 ), then tighten them with

spanner. Repeat same procedure on

the right pedal then assemble pedal

arm assembly left & right ( 04 / 05 ).

b. Insert the shaft ( at rear side of pedal

arm ) to the cross joint-rear ( 16 )( at

the main frame ) then insert the other

shaft ( at front side of pedal arm ) to

the cross joint-front ( 15 ) at

connecting arms ( 13 / 14 ).

Step 6 : Assemble handlebar

Connect pulse wire ( 28 ) and extension

pulse wire ( 29 ), then insert the

handlebars ( 06 / 07 ) to the connecting

arms ( 13 / 14 ) and fix with bolts ( 46 ),

cone washers ( 48 ) & nuts ( 47 ). Then

fully tighten them with spanner.

Step 7 : Assemble cycle monitor

Connect extension monitor cable ( 26 ) &

extension grip pulse wire ( 29 ) to the

monitor ( 12 ) then fix the monitor to

mounting plate ( located on top of

handlebar post ) with screws ( 49 ). Then

tighten them with screwdriver.

NOTE : THE PEDAL ARMS ARE NOT

FIXED WITH BOLTS. DO NOT

HOLD THE PEDAL ARMS FOR

MOVING THE MACHINE.

NOTE : THE PEDAL ARMS ARE NOT

FIXED WITH BOLTS. DO NOT

HOLD THE PEDAL ARMS FOR

MOVING THE MACHINE.

28 29 47

STEP 6

STEP 5-b

STEP 5-a

12 29

STEP 7

EEC-1500

EEC-5550

- 6 -

Step 8 : ASSEMBLE HANDLE

Insert connect bracket ( 55 ) into rest

handlebar ( L )( 08 ), fix with screw ( 50 )

without tighten it. Insert rest handlebar

( L )( 08 ) into handlebar post ( 17 ), fix

with bolt ( 46 ), cone washers ( 48 ) and

nut ( 47 ), without tighten it. Insert rest

handlebar ( R )( 09 ) into handlebar post

( 17 ), and attach top of bar with connect

bracket ( 55 ), fix with screw ( 50 ), bolt

( 46 ), cone washers ( 48 ) and nut ( 47 ).

Then fully tighten 2 sets of screw ( 50 )

and bolts ( 46 ) with spanner and

/screwdriver.

Step 9 : INSTALL POWER SOURCE.

EEC-1500 => step 9-a

Put battery into back of cycle monitor

( 07 ).

Battery spec. :

1.5V UM-3 ( or AA ) x 2 PCS

EEC-5550 => step 9-b

Connect DC transformer to socket.

DC transformer spec. :

Output DC 6V/500mA

Note : Tension adjust

EEC-1500 =>

Adjust the tension ( 1 to 8 level ) by the

tension control ( 51 ).

Turn clockwise tension increases

from 1 ( low ) to 8 ( high ).

Turn counter-clockwise tension

decreases from 8 ( high ) to 1 ( low ).

EEC-5550 =>

Tension adjustment operating by the

motor. Please refers to the operating

instruction of monitor.

STEP 9-a

EEC-1500

STEP 8

8,32

48 46

9,33

STEP 9-b

EEC-5550

NOW YOUR EEC-1500 / 5550 HAS BEEN FULLY ASSAMBLED.

THANK YOU FOR CHOOSING PROTEUS PRODUCT !

EXPLODED VIEW

- 7 -

8,32 55 50 45

9,33

1 15

26 29 46

2 40

42 38

56 18

EEC-1500

EEC-5550

Autres manuels pour EEC-1500

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Proteus vélo elliptique

Proteus

Proteus EEC-7000 Manuel utilisateur

Proteus

Proteus EEC - 1850 Manuel utilisateur

Proteus

Proteus EEC-1500 Manuel utilisateur

Proteus

Proteus Focus EEC-5550 Manuel utilisateur

Proteus

Proteus EEC-1550 Manuel utilisateur

Proteus

Proteus EEC - 3000 Manuel utilisateur

Proteus

Proteus EEC-1800 Manuel utilisateur

Proteus

Proteus Focus EEC-5550 Manuel utilisateur

Proteus

Proteus Century E5 Manuel utilisateur

Manuels vélo elliptique populaires d'autres marques

Weslo

Weslo Momentum 4.0 Elliptical Manuel d'utilisation et d'entretien

Progear Fitness

Progear Fitness Air elliptical pro 1307 Manuel utilisateur

Torque Fitness

Torque Fitness XPLLP Manuel utilisateur

Octane Fitness

Octane Fitness PRO3700C Manuel utilisateur

Xterra

Xterra FS5.8e Manuel utilisateur

Bodyguard

Bodyguard E-40 Manuel utilisateur

Bonn Germany

Bonn Germany Concept 2.2 Manuel utilisateur

Precor

Precor Resolute RSL 620 Manuel utilisateur

NordicTrack

NordicTrack E 9.2 Elliptical Manuel utilisateur

Vision Fitness

Vision Fitness X6600iNetTV Manuel utilisateur

Matrix

Matrix MX-A5x Manuel utilisateur

SportsArt Fitness

SportsArt Fitness ECO-NATURAL Elite E874 Manuel utilisateur

Sears

Sears FREE SPIRIT C249 30737 0 Manuel utilisateur

True

True FS-64 Manuel utilisateur

Sport-thieme

Sport-thieme ST 310 Manuel utilisateur

VIRTUFIT

VIRTUFIT CTR 1.1 Manuel utilisateur

Kettler

Kettler GIRO C 1 Manuel utilisateur

CIRCLE FITNESS

CIRCLE FITNESS E7 Manuel utilisateur