Protech Systems SG-G151 Manuel utilisateur

USER

MANUAL

SG-G151

15” Intel®AtomTM x7-E3950 /

Celeron®J3455 Processor

Fanless and all-around IP66

Panel PC

SG-G151 M1

SG-G151

15” Intel®AtomTM x7-E3950 / Celeron®J3455

Processor Fanless and all-around IP66

Panel PC

All trademarks and registered trademarks mentioned herein are the

property of their respective owners.

This manual is copyrighted in Jan. 2023. You may not reproduce or

transmit in any form or by any means, electronic, or mechanical,

including photocopying and recording.

DISCLAIMER

This user’s manual is meant to assist users in installing and setting up

the system. The information contained in this document is subject to

change without any notice.

CE NOTICE

This is a class A product. In a domestic environment this product may

cause radio interference in which case the user may be required to take

adequate measures.

FCC NOTICE

This equipment has been tested and found to comply with the limits for

a Class A digital device, pursuant to part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference when the equipment is operated in a commercial

environment. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is

likely to cause harmful interference in which case the user will be

required to correct the interference at his own expense.

You are cautioned that any change or modifications to the equipment

not expressly approve by the party responsible for compliance could

void your authority to operate such equipment.

CAUTION: Danger of explosion may occur when the battery

is incorrectly replaced. Replace the battery

only with the

same or equivalent type recommended by the manufacturer.

Dispose of used batteries according to the manufacturer’s

instructions.

WARNING: Some internal parts of the system may have

high electrical voltage. We strongly recommend that only

qualified engineers are allowed to service and disassemble

the system. If any damages should occur on the system and

are caused by unauthorized servicing, it will not be covered

by the product warranty.

Contents

Revision History .............................................................................................. i

1Introduction ......................................................................................... 1-1

1.1 About This Manual ..................................................................... 1-2

2Getting Started .................................................................................... 2-1

2.1 Package List............................................................................... 2-2

2.2 System Overview ....................................................................... 2-3

2.3 System Specifications ................................................................ 2-5

2.4Safety Precautions ..................................................................... 2-7

3System Configuration......................................................................... 3-1

3.1 External I/O Ports Diagram ........................................................ 3-2

3.1.1 Rear I/O Ports Diagram ...................................................... 3-2

3.2 Jumper & Connector Quick Reference Table............................. 3-3

3.3 Component Locations Of System Main Board........................... 3-4

3.3.1 Top View of System Main Board ......................................... 3-4

3.3.2 Bottom View of System Main Board ................................... 3-5

3.4 How To Set Jumpers .................................................................. 3-6

3.5 Setting Main Board Connectors and Jumpers ........................... 3-8

3.5.1 COM3 and COM4 PIN9 Definition Selection Guide ........... 3-8

3.5.2 COM PORT......................................................................... 3-9

3.5.3 VGA PORT........................................................................ 3-11

3.5.4 HDMI PORT ...................................................................... 3-11

3.5.5 LAN PORT ........................................................................3-12

3.5.6 Dual USB 3.0 PORT (USB1) ............................................ 3-13

3.5.7 USB 3.0 PORT (USB2).....................................................3-13

3.5.8 USB 2.0 PORT (USB3).....................................................3-14

3.5.9 Programmable GPIO PIN HEADER ................................. 3-14

3.5.10 I2C WAFER....................................................................... 3-14

3.5.11 MCU FW Rewrite Connector ............................................ 3-15

3.5.12 SYSTEM FAN CONNECTOR ........................................... 3-15

3.5.13 DC POWER INPUT CONNECTOR ..................................3-15

3.5.14 MINI PCI EXPRESS SLOT ...............................................3-16

3.5.15 mSATA Connector............................................................. 3-17

3.5.16 LVDS CONNECTOR.........................................................3-18

3.5.17 SLIDE SWITCH FOR LVDS RESOLUTION SELECTION3-19

3.5.18 FRONT PANEL CONNECTOR .........................................3-22

3.5.19 HD AUDIO CONNECTOR ................................................3-22

3.5.20 PANEL INVERTER CONNECTOR ................................... 3-23

3.5.21 SATA 3.0 CONNECTOR ...................................................3-23

3.5.22 SATA Power CONNECTOR..............................................3-23

3.5.23 BIOS RESET CONNECTOR ............................................ 3-24

3.5.24 LVDS BACKLIGHT CONTROL SELECTION ................... 3-24

3.5.25 LVDS VCC VOLTAGE SELECTION ................................. 3-25

3.5.26 CLEAR CMOS DATA SELECTION...................................3-26

3.5.27 USB POWER SOURCE SELECTION .............................. 3-26

3.6 External M12 Waterproof Connector........................................ 3-27

3.6.1 USB 2.0 Connectors .........................................................3-27

3.6.2 Power Button .................................................................... 3-27

3.6.3 LAN1, LAN2 Ports............................................................. 3-28

3.6.4 COM Connector ................................................................ 3-29

3.6.5 DC Power Input Connector ...............................................3-29

4Software Utilities................................................................................. 4-1

4.1 Introduction................................................................................. 4-2

4.2 Installing Intel®Chipset Software Installation Utility................... 4-4

iii

4.2.1 Intel®Chipset Software Installation Utility........................... 4-4

4.2.2 Installing Servicing Stack Update for Windows 10 Version

1607 .................................................................................... 4-5

4.2.3 Installing Graphics Driver Utility.......................................... 4-6

4.2.4 Installing Sound Driver Utility.............................................. 4-7

4.2.5 Installing LAN Driver Utility ................................................. 4-8

4.2.6 Installing Intel®Serial I/O Driver Utility................................ 4-9

4.2.7 Intel®Trusted Execution Engine Driver Installation ..........4-10

5BIOS SETUP ........................................................................................ 5-1

5.1 Introduction................................................................................. 5-2

5.2 Accessing Setup Utility............................................................... 5-4

5.3 Main............................................................................................ 5-7

5.4 Advanced ................................................................................... 5-9

5.4.1 Advanced - ACPI Settings ................................................ 5-10

5.4.2 Advanced – Onboard Device Configuration ..................... 5-11

5.4.3 Advanced – Hardware Monitor .........................................5-12

5.4.4 Advanced – F81964 Watchdog Configuration .................. 5-13

5.4.5 Advanced - S5 RTC Wake Settings.................................. 5-14

5.4.5.1 S5 RTC Wake Settings [Fixed Time] ...............................5-15

5.4.5.2 S5 RTC Wake Settings [Dynamic Time].......................... 5-16

5.4.6 Advanced - CPU Configuration......................................... 5-17

5.4.6.1 Socket 0 CPU Information............................................... 5-18

5.4.6.2 CPU Power Management Configuration ......................... 5-19

5.4.7 Advanced - F81964 Super IO Configuration ....................5-20

5.4.8 Advanced - USB Configuration......................................... 5-22

5.5 Chipset ..................................................................................... 5-23

5.5.1 Chipset –North Bridge ...................................................... 5-24

5.5.2 Chipset – South Bridge ..................................................... 5-25

5.5.2.1 Chipset – South Bridge- PCI Express Configuration....... 5-26

5.5.2.2 Chipset – South Bridge- SATA Drives ............................. 5-30

5.5.2.3 Chipset –South Bridge- Miscellaneous Configuration..... 5-31

6.5 Security .................................................................................... 5-32

6.6 Boot .......................................................................................... 5-34

6.7 Save & Exit............................................................................... 5-36

Appendix A System Diagrams....................................................A-1

System Exploded Diagram .......................................................................A-2

Front Panel Module Exploded Diagram ...................................................A-3

Heatsink Cover Exploded Diagram ..........................................................A-4

Stand installation and Wall Mount Exploded Diagram .............................A-6

Packing Exploded Diagram ......................................................................A-7

Appendix B Technical Summary ................................................B-1

BE-0986 Block Diagram ...........................................................................B-2

Interrupt Map ............................................................................................B-3

I/O MAP ..................................................................................................B-16

Memory Map...........................................................................................B-18

Configuring WatchDog Timer .................................................................B-20

Flash BIOS Update.................................................................................B-22

Revision History

The revision history of SG-G151 User Manual is described below:

Version No.

Revision History

Date

Initial Release

2023/01/16

SG-G151 USER MANUAL

Page: 1-1

1 Introduction

This chapter provides the introduction for the SG-G151

system as well as the framework of the user manual.

The following topic is included:

•About This Manual

Chapter 1 Introduction

SG-G151 USER MANUAL

Page: 1-2

1.1 About This Manual

Thank you for purchasing our SG-G151 system. The SG-G151 is an updated system

designed to be comparable with the highest performance of IBM AT personal

computers. The SG-G151 provides faster processing speed, greater expandability and

can handle more tasks than before. This manual is designed to assist you how to

install and set up the whole system. It contains 5 chapters and 2 appendixes. Users can

configure the system according to their own needs. This user manual is intended for

service personnel with strong hardware background. It is not intended for general

users.

The following section describes the structure of this user manual.

Chapter 1 Introduction

This chapter introduces the framework of this user manual.

Chapter 2 Getting Started

This chapter describes the package contents and system specifications, and illustrates

the physical appearances for SG-G151 system. Read the safety reminders carefully on

how to take care of your system properly.

Chapter 3 System Configuration

This chapter describes the locations and functions of the system motherboard

components. You will learn how to properly configure the connectors and system

configuration jumpers on the motherboard and configure the system to meet your own

needs.

Chapter 4 Software Utilities

This chapter contains helpful information for proper installations of the Intel Chipset

Software Installation Utility, Servicing stack update for Windows 10 Version 1607,

Graphics Driver Utility, Sound Driver Utility, LAN Driver Utility, Serial I/O Driver

Utility and Intel Trusted Execution Engine Driver Utility.

Chapter 5 BIOS Setup

This chapter provides BIOS setup information.

Appendix A System AssemblyDiagrams

This appendix provides the exploded diagrams and part numbers of SG-G151.

Appendix B Technical Summary

This appendix provides the information about the block diagram, allocation maps for

system resources, Watchdog Timer Configuration and Flash BIOS Update.

Table des matières

Autres manuels Protech Systems Écran tactile

Protech Systems

Protech Systems SP-6205 Manuel utilisateur

Protech Systems

Protech Systems SP-6140 Manuel utilisateur

Protech Systems

Protech Systems PPC-7400 Manuel utilisateur

Protech Systems

Protech Systems SP-6157 Manuel utilisateur

Protech Systems

Protech Systems PPC-7365F Manuel utilisateur

Protech Systems

Protech Systems SP-6558 Manuel utilisateur

Protech Systems

Protech Systems PPC-1208F Manuel utilisateur

Protech Systems

Protech Systems SG-S156 Manuel utilisateur

Protech Systems

Protech Systems SP-6130 Manuel utilisateur

Protech Systems

Protech Systems SG-S151 Manuel utilisateur

Protech Systems

Protech Systems SP-7755 Manuel utilisateur

Protech Systems

Protech Systems SP-7256 Manuel utilisateur

Protech Systems

Protech Systems SP-6110 Manuel utilisateur

Protech Systems

Protech Systems PPC-7528F Manuel utilisateur

Protech Systems

Protech Systems SP-7117 Manuel utilisateur

Protech Systems

Protech Systems SP-6555 Manuel utilisateur

Protech Systems

Protech Systems SP-7165 Manuel utilisateur

Protech Systems

Protech Systems SP-7155 Manuel utilisateur

Protech Systems

Protech Systems SP-S214 Manuel utilisateur

Protech Systems

Protech Systems SP-6565 Manuel utilisateur

Protech Systems

Protech Systems SP-6267 Manuel utilisateur

Protech Systems

Protech Systems SP-6265 Manuel utilisateur

Protech Systems

Protech Systems SP-S211 Manuel utilisateur

Manuels Écran tactile populaires d'autres marques

FlowLine

FlowLine Data loop Manuel utilisateur

ALPEX

ALPEX AEx-8 P Series Manuel utilisateur

Ltech

Ltech E5S Manuel utilisateur

Harman

Harman AMX MODERO S MSD-701-L2 Manuel utilisateur

Acnodes

Acnodes PC 1150 Manuel utilisateur

AIS

AIS IP10IA99 series Manuel utilisateur

IBASE Technology

IBASE Technology ASTUT-152-RE1S Manuel utilisateur

YASKAWA

YASKAWA TP 610C Manuel utilisateur

B&R

B&R Power Panel C Series Manuel utilisateur

Beijer Electronics

Beijer Electronics X2 control Manuel utilisateur

AXIOMTEK

AXIOMTEK GOT321W-521 Manuel utilisateur

TRIDONIC.ATCO

TRIDONIC.ATCO x-touchBOX Manuel utilisateur

Qomo

Qomo QIT1386 Manuel utilisateur

DFI

DFI KS104-CD Manuel utilisateur

AMX

AMX AXP-PPC Mode d’emploi

Sartorius

Sartorius X3 PR 5410 Manuel utilisateur

AMX

AMX Modero X Series Manuel utilisateur

Advantech

Advantech TPC-30 Series Manuel utilisateur