5
3 Installation
Phase 1 of 6 - preparing the installation
Wait about 10 minutes before acting, in this way all the electrical equipment will be
deactivated.
•
•
•
•
•
1
2
Let the engine cool down before installing the Proracing ECU, you could burn yourself.
Open the bonnet and keep the doors locked.
Normally, no special tools are required for installation, a wire cutter is sucient to remove
the remains of the clamps. In some cases a torx key to open the control unit and change
to Bosch or Siemens / delphi.
With, Keyless Go or electronic key, be careful to keep the car key at a distance
about 10 meters from the car to be out of radio coverage.
In the event of an anti-theft device, it must be deactivated before starting the installation.
In some rare cases it is possible that the car with the hood open keeps the sensors
active, therefore it is advisable to disconnect the battery positive to avoid generating
an error.
If you have any questions or problems during installation, you can nd answers on
Error removal.
Our customer support is also available - You can open a Ticket
on our website.
