Profelmnet WF-16 Manuel utilisateur
Proedrou Drakaki 11, 17341 Agios Dimitrios
Call center: 210 9850 244, Fax: 210 9823 264
www.profelmnet.com
Configuration
Connection and power supply 230VAC:
Based on the diagram, connect the power supply N+L terminals
230VAC to the control board and L1+L2 contact to the button
input.
Ν&L: Wire black and red. Power supply 230VAC.
L1: Yellow and blue wires. Contact 1 Ν/Ο.
L2: Red and white wires. Contact 2 Ν/Ο.
L2 is the second channel of the receiver.
DIP SWITCH Diagram:
Choose through dipswitch which program is suitable for the installation.
Channels
1+2 Dipswitch
3 Dipswitch
4 Dipswitch
One channel
ΟΝ (dip 1)
OFF (dip -2)
ΟΝ: 3 seconds delay contact -
PUSH ON function
ΟFF:ON-OFF contact
ON recommended
OFF recommended
Two channels
OFF (dip 1)
ON (dip 2)
WF-16
WIFI RECEIVER
ON => UP position
OFF => DOWN position
Proedrou Drakaki 11, 17341 Agios Dimitrios
Call center: 210 9850 244, Fax: 210 9823 264
www.profelmnet.com
MOBILE APPLICATION
1. Download the application through Applestore or Playstore
2. Choose the country
3. Select Config, right down. Write the WIFI network name and the
password. After the installation of the WIFI network, press the button of the
receiver for 10 seconds, until the BLUE LED flashes. Then, press START
connecting from the mobile application.
4. After connecting mobile application with the WIFI receiver, select DEVICE.
See the devices have been connected. Press the icons to give commands.
NOTE: In order to make any change in the initial installation, delete the device form the
application and power off the receiver. Make all the steps from the beginning and then
power on the receiver.
Name of application
WIFI Smart switch
lanbon
Initial installation: The WF-16 receiver needs to be connected in the WIFI
network. Also, the mobile phone needs to be connected in the same WIFI
network.
Power the receiver after the mobile
application is installed.
Table des matières
Autres manuels Profelmnet Récepteur
