FITTING INSTRUCTION
VVA, VVN
V1.0 (15.1.2013)
1 (2)
Produal
Oy
Keltakalliontie 18, 48770 Kotka FINLAND Tel: +358-5-230 9200 / Fax: +358-5-230 9210 [email protected]i www.produal.com
By help of this document you can install VVA and VVN water leakage sensors properly.
VVA 1
Place the sensor on the floor as shown in the
picture. Make sure that between the floor
and the lower surface of the sensor remains
about 15 mm gap.
VVA 2
Place the sensor on the floor as shown in the
picture. Make sure that between the floor
and the lower surface of the sensor remains
about 3 mm gap.
VVA 3
Place the sensor on the floor (or correspond-
ing surface) as shown in the picture. Use
glue to attach the sensor. Make sure the
sensing surface is placed upward.
