5
ModifiedSineWave Safetyinstruction
―Faulty assembly or connection
―Damage to the appliance resulting from mechanical influences and excess voltage
―Alterations to the device without express permission from the manufacturer
―Use for purposes other than those described I the operating manual
―Use the device only as intended.
―Do not operate the device in a damp or wet environment.
―Maintenance and repair work may only be carried out by qualified personnel who are
familiar with the risk involved and the relevant regulations.
2.2 Safety when installing the device
● Ensure the device is standing firmly.
The device must be set up and fastened in such a way that it cannot tip over or fall down.
● Take the precautions necessary to ensure that children cannot interfere with operation.
Dangerous situations may occur which cannot be recognized by children!
● Do not expose the device to a heat source (such as direct sunlight or heating). Avoid
additional heating of the device in this way.
For installation on boats
● If electrical devices are incorrectly installed on boats, corrosion damage might occur.
Have the inverter installed by a specialist (marine) electrician.
Electrical cables
● If cables have to be fed through metal walls or other walls with sharp edges, use ducts or
wire bushings to prevent damage.
● Do not lay cables which are loose or bent next to electrically conductive material (metal).
● Do not pull on the cables.
● Do not lay the 230 V mains cable and the 12 V DC cable in the same duct.
● Fasten the cables securely.
● Lay the cables so that they cannot be tripped over or damaged.
