Pro-Elec PELL0018 Manuel utilisateur
LED SOLAR MOTION SENSOR LIGHT
PELL0018
Please read these instructions carefully before use and retain for future reference.
• Avoid locations of high temperature or humidity.
• If the light output becomes less bright or ashes, place the light unit in a sunny
location to allow the batteries to recharge fully.
IMPORTANT SAFETY INFORMATION
INSTALLATION
• It is recommended to install the light at about 2.5M or higher above ground.
• Offer the light unit onto the surface to be mounted and mark the position of the two
mounting holes.
• Drill two holes the wall where marked with regard to any concealed wiring or
pipework. Fit wall plugs if required.
OPERATION
SPECIFICATION
• Press the function switch on the front panel to turn the light on ON.
• When set to ON and the ambient light is low, when the sensor detects movement it
will illuminate.
• When no further motion is detected, the light will extinguish after 18 seconds.
NOTE: please allow up to 12 hours charging time on
initial operation.
• Clean the unit only with a soft dry cloth. Do not use any chemicals, abrasives or
solvents that could damage the casing or lens.
Power supply: 1×18650 Li-ion (1200mAh) 3.7V battery non-replaceable
Solar Panel: Polycrystalline silicon, 0.5W (5.5V, 90mA)
Time Delay: 18 sec (auto delay function)
Working time: 2hrs continuous light (12hrs charging time)
Material: ABS
Light Source: 24 x SMD2835 LEDs
Output power high/low modes: 150 lumen
Ambient light: <10LUX
Sensor distance: 0-5m
Sensor angle: 110°
Product weight: 200g
Product size H x W x D: 48x133×115mm
IP rating IP44
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF
ELECTRICAL & ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical & Electronic
Equipment (WEEE). Any WEEE marked products must not be mixed with general household waste,
but kept separate for the treatment, recovery and recycling of the materials used. Contact your local
authority for details of recycling schemes in your area.
Made in China. PR2 9PP
Man Rev 1.0
5m
110o
• Attach the light unit using two screws through the two mounting holes on the top of
the light into the previously drilled holes.
• Ensure the light unit is securely attached.
MAINTENANCE
Table des matières
Autres manuels Pro-Elec Capteur de sécurité
