1
2
34
6
5
7
8
9
11
10
12
13 14
16 15
aaaaa
a
a
a
b
b
b
b
bbbb
c
c
d
d
20 cm
8 inch
Figure 4
Assembly Instructions Prismasonic Fixed Video Screen Prismasonic Fixed Video Screen
Assembly Instructions
STEP 4
Attach the screen to the framework (to the opposite side of L- and T-brackets) by using the staple gun. (FIG4)
Make sure the rectangular slots of screen matches the slots of the framework with a certain accuracy. Start
shooting the staples to the spots illustrated in the figure 4, with the order of the provided numbering. Firmly
pull the fabric with tongs (FIG 5) to the direction of the arrow every time before the staple is shot. Finally
shoot the staples in steps of ~20 cm (~8 inch) around the screen with the order of the alphabets (FIG 4).
The fabric should now have only small wrinkles around the staples, but no waves at all on the viewing area.
Wrinkles will stay below the velvet frames, and thus will be invisible after full assembly. If there still exist some
waves on the viewing area, it is possible to remove the staples with the screwdriver head and the tongs, as
illustrated in the FIG 6, thus getting the problem area tightened. (There is no limitation on how many times
the staples can be removed and re-shoot.)
NOTE! In order to achieve the best result, please follow the
proposed stapling order
NOTE! If the screen slots do not match the framework slots with
a certain accuracy, the framework is not rectangular and you have
to return back to the STEP 3
Figure 5 Figure 6
STEP 5
The final tightening of the fabric is done with the four screws located into the slots of framework (two on
horizontal bottom leg, one on each vertical leg; FIG 2, FIG 7), pointing away from the edges. The screen will
be tightened by turning the screws counterclockwise with the L-wrench, 6 mm. First tighten the horizontal
direction after which the both vertical sides.
NOTE! The staples may loose if the fabric is overtightened by the screws
Figure 7
Figure 8
STEP 6
Stand up the framework and prepare attaching the
velvet frames. Insert a Cap Screw, M6 x 40 with a
washer to every slot provided by the framework, and
tighten them with the L-wrench, 5 mm (FIG 8) to
the screw threads of velvet frames, first only to an
amount that the frames still are loosely held. Match
the each corner of frames perfectly to each other, and
tighten all the screws securely. You may have to flip
the framework vertically in order to get all frames
properly installed.
