- 2 -
When using an electrical device, basic safety precautions should always be followed,
including the following:
Read all instructions before using the PrintDry filament dryer (hereinafter
referred as the "dryer").
DO NOT touch hot surfaces and always use a heat resistant surface.
To protect against electrical hazards, DO NOT immerse cord, plug or the dryer
in water or any other liquid. DO NOT switch the dryer ON if surfaces are wet.
DO NOT allow children under age 12 or any person with reduced physical
sensory or mental capabilities to use the dryer. Close supervision is necessary
when the dryer is used near children or any persons with reduced physical
sensory or mental capabilities.
Unplug from outlet when not in use and before cleaning. Allow to cool before
putting on or taking off any parts.
DO NOT operate the dryer with a damaged cord or plug or after the dryer
malfunctions, or has been damaged in any manner. Return the dryer to the
manufacturer for examination, repair or adjustment. See Warranty section.
The use of accessories/attachments not recommended may cause hazards.
DO NOT use outdoors.
DO NOT let cord hang over edge of table or counter, or touch hot surfaces.
DO NOT place on or near a hot gas or electric burner, or in a heated oven.
DO NOT block the air intakes or exhaust in any manner.
DO NOT use for other purposes other than the intended use.
To disconnect, turn the power switch to ‘OFF’, then unplug from wall outlet.
DO NOT pour liquids into the dryer.
ONLY turn ‘ON’ the power after the lid is closed.
TURN ‘OFF’ the power switch before opening the lid
DO NOT leave the dryer unattended while in use at any time.
DO NOT operate near combustible or pressurized spray cans.
DO NOT use the dryer more than 48 continuous working hours. After a
maximum of 48 hours in use, turn OFF and unplug the dryer for at least 1 hour.
Leave a minimum 250 mm (12") open space all around the exterior of dryer.
The use of unauthorized accessories may cause injuries.
