Primos 62704 Manuel utilisateur

Sit’N Spin Crazy Critter™Instructions

Model# 62704

BATTERY INSTALLATION:

Step 1 - Unscrew the bottom housing cap as shown in Fig. 1, then

remove and set aside the exposed screw in the center of the battery

compartment cover.

Step 2 - Remove the battery compartment cover (you may need a

small at screwdriver or pocketknife tip to li up an edge of the

cover). Insert 4 AA batteries (not included) in battery compartment,

following the polarity marks (at “-” ends facing springs)-see Fig. 2.

Step 3 - Replace battery compartment cover and screw at center of

cover.

Step 4 - Replace bottom housing cap.

SETUP:

Step 1 - Attach Fur Critter:

a) Remove fur critter with spring wire from its storage clips.

b) Loosen thumb screw on critter connection.

c) Insert spring wire into critter connection and tighten

thumb screw.

Step 2 - Attach Ground Stake:

a) Remove ground stake from its storage clip.

b) read ground stake into bottom housing.

OPERATION:

Turn On – Turn speed dial (Fig. 3) clockwise.

a) Increase variable Speed – Turn speed dial clockwise.

b) Decrease variable Speed – Turn speed dial counter clockwise.

Turn O – Turn speed dial counter clockwise until it clicks to o

position.

USING SIT’N SPIN CRAZY CRITTERTM:

Insert Sit’N Spin Crazy CritterTM ground stake rmly into ground along eld edges, in elds or in

wooded areas so it can be seen by predators. Set desired motion speed and start hunting.

e new and improved Sit and Spin Crazy CritterTM includes a remote control 3.5mm jack. is jack and

included 3.5mm cable can be used to connect your decoy to your Primos Electronic Caller and control the

decoy with the caller remote. Compatible with Primos Alpha DoggTM, Turbo DoggTM and Boss DoggTM.

Check the Primos website for the most recently updated list of compatible electronic callers.

Primos® Hunting

604 First St., Flora, MS 39071

(601) 879-9323

www.primos.com

Fig. 1

Fig. 2

Fig. 3

rev110716

WARRANTY

Up to 1 YEAR LIMITED WARRANTY

Primos® Hunting (“Primos”) warrants the Sit’N Spin Crazy CritterTM to be free from defects in workmanship and materials, under normal use and conditions, for the time periods and terms as

set forth below. According to this LimitedWarranty Primos® will, at its discretion, (a) repair the production using new or refurbished parts or (b) replace the product with a new or refurbished

product (product that has been returned to its original specications). In the event of a defect, these are the exclusive remedies available to the original consumer purchaser only and is not

assignable or transferable.

Keep the“Proof of Purchase”to receive warranty protection on your product.

** visit primos.zendesk.com for FAQ, PDF manuals and product support.

Limitations: This warranty is valid only if the product is used for the purpose for which it was designed. It does not cover: 1) products which have been damaged by negligence/misuse

(including, but not limited to, improper storage, battery leakage and water damage caused by submersion), accident or which have been modied or repaired by unauthorized persons; 2)

cracked or broken housing of units damaged by excess heat or impact/force; 3) damage caused by wild animals 4) the cost of shipping this product to the factory for service and its return to you.

Instructions:

In the event warranty service is needed, please contact Primos® Customer Service via email (ser[email protected]) or call (601) 879-9323.You will need to:

1. Remove batteries from product and pack in well-padded or highly protective box. Primos® Hunting will NOT be responsible for damage incurred in returning product for repair.

2. Include Return Form and“Proof of Purchase”in with return.

3. Send product prepaid to: Primos Returns/Repairs

9200 Cody

Overland Park, KS 66214

DISCLAIMER

Primos® makes no representations or warranties, either expressed or implied, by or concerning any content of these written materials or software, or for damages resulting from the use of the

information contained therein. Primos® reserves the right to alter the features and contents of this publication, hardware or software without obligation or advance notice.

Warranty does not extend to any accessories used with the product. Primos® is not responsible if you use the product for illegal purposes. Primos® shall not be obligated to perform preventative

maintenance, installation, deinstallation, or maintenance. The illustrations in this manual are for instructional purposes only and may not represent actual product exactly.

FCC Compliance Statement:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation.

Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on,the user is encouraged to try to correct

the interference by one or more of the following measures:

· Reorient or relocate the receiving antenna.

· Increase the separation between the equipment and receiver.

· Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.

· Consult the dealer or an experienced radio/TV technician for help.

The device does not contain any user-serviceable parts. Repairs should only be made by an Authorized Primos repair center. Unauthorized repairs or modications could result in permanent damage to the equipment, and will void your

warranty and your authority to operate this device under Part 15 regulations.

The shielded interface cable which is provided must be used with the equipment in order to comply with the limits for a digital device pursuant to Subpart B of Part 15 of FCC Rules.

For further questions or additional information please contact:

Primos Customer Service

(601) 879-9323

[email protected]

Disposal of Electric and Electronic Equipment

(Applicable in the EU and other European countries

with separate collection systems)