2 PRIMETECH ENGINEERING
2/30
Thank you for your purchase of the Primetech Engineering product.
We ensure that you will enjoy this and other products from Primetech Engineering for many years.
Keep this manual and warranty card handy for future reference.
F
Fo
or
r
S
Sa
af
fe
e
U
Us
se
e
o
of
f
t
th
he
e
P
Pr
ro
od
du
uc
ct
t
To ensure the safe use of this product, carefully read the warnings and cautions provided below prior to use:
Failure to follow the warning message may result in death or serious injury.
Failure to follow the caution message may result in injury or property damage.
W
Wa
ar
rn
ni
in
ng
g
–
–
S
Sa
af
fe
et
ty
y
P
Pr
re
ec
ca
au
ut
ti
io
on
ns
s
–
–
Never disassemble or modify the product.
Do not touch the connection cable pins or metal parts with wet hands.
Do not use the product in a place exposed to rain or water droplets or where toxic gases (liquids) are generated
nearby.
If the product will not be used for an extended period of time, unplug the connection cable from the camera.
When installing, inspecting or handling the product in a high place, implement sufficient measures beforehand to
prevent the device and parts from falling.
If you see smoke, smell a bad odor or hear an abnormal noise, immediately turn off the power supply and
unplug the cable from the product.
Do not use this product in a system that may cause a serious accident if the product exhibits an abnormality.
C
Ca
au
ut
ti
io
on
n
–
–
P
Pr
re
ec
ca
au
ut
ti
io
on
ns
s
o
on
n
U
Us
se
e
–
–
■Use the product within the operating temperature range (-5 to +45°C).
■Use the product at the specified power-supply voltage (+12 VDC).
■Avoid any strong impact or vibration to the product.
■Provide sufficient space around the installed product to prevent the product's internal temperature from rising.
■If the product is used in a dusty environment, be sure to implement dust-protection measures.
■Be sure to turn off the power supply after the cable has been unplugged and then plugged in again with the
power on.
■Dust and smudges on the surface of the cover glass will appear as black stains on the image. Blow away any
dust with air, etc., and wipe off any smudges using a cotton swab moistened with ethyl alcohol.
When cleaning smudges, be careful not to scratch the surface of the cover glass.
■It is recommended to use a daylight-color fluorescent lamp or other light source that is free from infrared light.
When using a halogen lamp or other light source containing infrared light, use an infrared cutoff filter.
■Do not share the power supply with a motor or other type of noise-generating device.
■The SG (signal ground) and FG (frame ground) are connected inside the camera. Design the system in such a
way as to prevent the looping caused by ground potential difference.
Supplemental Note
■A period of 10 to 20 minutes of aging after turning on the power allows more stable images to be captured.
