Prem-I-Air HT2007 Manuel utilisateur

Service & Warranty

•Do not operate any product with a damaged cord or plug, or after the

product malfunctions, or is dropped or appears damaged in any way.

Return the complete product to the place of purchase for inspection,

repair or replacement.

•For your convenience, record the complete Model/Type Number

(located on the Product Identification Plate) and the date you

received the product below, and attach your purchase receipt docket

as proof of purchase.

•To ensure your product is covered by warranty, the complete faulty

product together with your purchase receipt should be returned to

your retailer.

ONE (1) YEAR LIMITED WARRANTY

SAVE THIS WARRANTY INFORMATION

EHS (International) Ltd. guarantees this product free from

defects in materials and workmanship for a period of one (1)

year.

Should this unit be operated under conditions other than those

recommended or at voltages other than the voltage indicated

on the unit, or any attempts made to service or modify the unit,

this will render WARRANTY VOID. The product you buy may

sometimes differ slightly from illustration.

Should you have a problem with this product, please contact to

our service desk, Tel: (0870) 742 5021

EHS, Manchester M17 1RN

EHS09/03

MODEL HT2007

THANK YOU FOR CHOOSING THIS EHS

PRODUCT. BEFORE USING IT, PLEASE

READ THIS INSTRUCTION MANUAL

A. Important Safety Instructions

PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE USING

THE PRODUCT.

WARNING –This appliance is intended for domestic use only. Any other

use is not recommended by the manufacturer and may cause fire,

electrical shocks or other injury to persons or property.

When using electrical appliances, basic safety precautions should

always be followed:

1. This heater is hot when in use. To avoid burns DO NOT touch the

air outlet grills during use. If provided, use handles when moving

this heater.

2. DO NOT direct the heater towards curtains furniture or other

flammable objects and ensure that they are at least 3 feet (0.9m)

from the front and 1 feet (0.3m) away from the sides and rear.

3. Extreme care should be taken when any heater is used by, or near

children and the elderly, and whenever the heater is left operating

and unattended.

4. Before operating the heater remove the unit from its packaging and

check it is in good condition.

5. DO NOT operate any heater with a damaged cord or plug, or after

the heater malfunctions, has been dropped, or damaged in any

manner. Return the heater to an authorised service facility for

examination and repair.

6. DO NOT attempt to repair or adjust any electrical or mechanical

functions on this unit as this may void warranty.

7. DO NOT let children play with the packaging, for example plastic

bags.

8. Check the household voltage to ensure it matches the appliance’s

rated specification.

9. DO NOT sit the fan heater on soft surfaces, like a bed, where

openings may become blocked. DO NOT cover.

10. Always unplug the heater when not in use. To disconnect heater, turn

switches to OFF position (O) and remove plug from the power socket.

When unplugging pull the plug and not the cord.

11. This heater is not intended for use in wet or damp locations. Never

locate the heater where it may fall into a bathtub or other water

container. DO NOT use in bathrooms or outdoors. When not in use

always store in a dry area.

12. DO NOT run power cord under carpeting, or cover with rugs or

runners. Arrange the cord away from areas where it may be tripped

over.

13. Avoid the use of an extension cable as this may overheat and

cause a fire.

14. DO NOT insert or allow objects to enter any ventilation or

exhaust opening as this may damage the heater and could cause

an electrical shock or fire.

15. DO NOT use the heater in areas where gasoline, paint, or

flammable liquids are used or stored.

B. BS Plug Wiring

Wiring Instructions: Should it be necessary to change the plug please

note the wires in the mains lead are coloured in accordance with the

following code: BLUE -NEUTRAL

BROWN -LIVE

As the colours of the wires in the mains lead of this appliance may not

correspond with the coloured markings identifying the terminals in your plug,

proceed as follows:

1. The BLUE wire is the NEUTRAL and must be connected to the terminal

which is marked with the letter Nor coloured BLACK.

2. The BROWN wire is the LIVE and must be connected to the terminal

which is marked with the letter Lor coloured RED.

4. Always ensure that the cord grip is positioned and fastened correctly.

If a 13A (BS 1363) fused plug is used it must be fitted with a 13A fuse. If in

doubt consult a qualified electrician.

Wiring for a 13 Amp Plug (BS1363)

READ & SAVE THESE IMPORTANT

INSTRUCTIONS

C. Product Description

(1) Air Inlet (2) Power On Light

(3) Air Outlet (4) Control Switch

(5)Thermostat Control

D. Pre-Operation Instructions

1. Carefully remove your heater from the box (please save the carton

for off-season storage).

2. Before plugging the heater into the power socket, ensure the unit is

in the OFF (O) position.

3. Place the heater on a firm level surface.

4. Avoid overloading your circuit by not using other high wattage

appliances in the same power socket.

E. Operation

CONTROL SWITCH

The fan heater incorporates a rotation switch. You can select the

different settings by turning the switch clockwise to:

Minimum

Anti-Freeze

Maximum

Off

Cool Fan

Low (1000W)

High (2000W)

1. Plug the supply cord into a convenient power socket.

2. For heater operation, please turn the Thermostat knob in a

clockwise direction to the maximum position.

3. Turn the Control Switch to the desired heat setting.

4. For fan-only option, without any heat output, turn the Control Knob

to the cool fan setting.

CAUTION: AIR OUTLET GRILL BECOMESHOT WHEN

HEATER IS SWITCHED ON.

THERMOSTAT

When the appliance is switched on:

1. Before setting the thermostat turn the thermostat knob in a

clockwise direction to the maximum position.

2. Once the room has reached the desired temperature, turn the

thermostat knob slowly in an anti-clockwise direction until the fan

heater stops. The temperature is now set. The power indicator light

will switch off.

3. The heater will automatically maintain the set temperature and

switch on when the room temperature is low and switch off if it is too

high. The red indicator light indicates the heater is switched on.

4. It is normal for the heater to turn ON and OFF as it maintains the

pre-set temperature, to prevent this you need to change the

thermostat setting.

ANTIFREEZE FUNCTION –Turn the unit on and put the thermostat

on the antifreeze position. When the ambient temperature drops to

0º C, this function will maintain the room temperature at about 5º C.

F. Wall Mounting

This heater is wall mountable. Please read following

instructions:

1. The heater must be securely fitted to the wall, which must be 10cm

minimum thickness and 60cm above floor level.

2. Position the installation template sheet in the place where you wish to

wall mount your heater, and drill 3 holes, as indicated on the diagram

below. (Fig 1)

3. Remove the template sheet before mounting the heater.

4. Insert wall (screw) plugs into the three holes and fasten the three

screws into the holes. (Fig. 2)

5. Turn heater OFF and unplug before mounting onto the wall.

6. Hang the heater (air outlet face down) onto the screws through the

mounting holes in the base. (Fig. 3)

7. Slide the heater to the right along hanging slot than slide it down to

mount securely. (Fig. 4)

WARNING: Ensure heater is securely mounted on the wall before

plugging in.

Please put the paper in the place where you prefer in

the wall and drill three holes respective the distance

among three holes shown.

!!ATTENTION:Take away the paper after drilled.

> 50cm > 50cm

> 60cm

Plug_Screw

Screw

Fig. 1 Fig. 2

Fig. 3 Fig. 4

G. Safety Overheat Shut Off

A thermal overload protector is built into the heater to prevent

overheating. When a potential overheat temperature is reached

the heater will automatically shut off and the power indicator light

will go out. If this occurs inspect and remove any objects on or

adjacent to the heater that may have caused a high temperature.

The unit needs to be reset to start.

RESET THE HEATER

1. Turn the Control Setting to the OFF (O) position

2. Unplug the heater and wait 5-10 minutes for the unit to cool down.

3. After 5-10 minutes, plug the unit in again and operate normally.

If the fault reoccurs remove the plug from the socket and have the unit

service by authorised service engineers.

H. Specification

Voltage : 230-240V~ 50Hz

Power :2000W

Weight : 1.37kg

Dimensions : 27 (L) x 25 (W) x 14 (H) cm

I. Maintenance

1. Before you clean the unit turn the switch to OFF (O), disconnect

the plug from the power socket and wait for it to cool down.

2. DO NOT use detergents, abrasive cleaning liquids or other

chemicals (alcohol, gasoline, etc.) to clean the unit.

3. Wipe the exterior surfaces of the heater occasionally with a damp

cloth (not wet), using a solution of mild detergent and water. Dry

the case thoroughly before operating the heater.

4. Light accumulated dust may be removed from air outlet grilles with

a soft cloth or vacuum cleaner.

5. The fan motor is factory lubricated for life and will require no further

lubrication.

6. Store heater in a clean dry place when not in use. Remember

portable electric heaters are designed for spot heating or as a

supplemental heat source. They are not intended to be main

sources of heat during the normal heating season.

CAUTION: DO NOT allow water to run into the interior of the

heater as this could cause an electrical shock or fire.

Table des matières

Autres manuels Prem-I-Air Chauffage

Prem-I-Air

Prem-I-Air EH1710 Manuel utilisateur

Prem-I-Air

Prem-I-Air EH1434 Manuel utilisateur

Prem-I-Air

Prem-I-Air EH1369 Guide de l'utilisateur

Prem-I-Air

Prem-I-Air PCH0501 Manuel utilisateur

Prem-I-Air

Prem-I-Air EH0291 Manuel utilisateur

Prem-I-Air

Prem-I-Air EH1712 Manuel utilisateur

Prem-I-Air

Prem-I-Air EH1644 Manuel utilisateur

Prem-I-Air

Prem-I-Air EH1668 Manuel utilisateur

Prem-I-Air

Prem-I-Air C307 Manuel utilisateur

Prem-I-Air

Prem-I-Air EH1846 Manuel utilisateur

Prem-I-Air

Prem-I-Air EH0154 Manuel utilisateur

Prem-I-Air

Prem-I-Air EH1710 Manuel utilisateur

Prem-I-Air

Prem-I-Air EH1558 Manuel utilisateur

Prem-I-Air

Prem-I-Air EH1674 Manuel utilisateur

Prem-I-Air

Prem-I-Air EH1422 Manuel utilisateur

Prem-I-Air

Prem-I-Air N10Turbo Manuel utilisateur

Prem-I-Air

Prem-I-Air HQH2000H Manuel utilisateur

Prem-I-Air

Prem-I-Air EH1436 Manuel utilisateur

Prem-I-Air

Prem-I-Air EH0153 Manuel utilisateur

Prem-I-Air

Prem-I-Air EH1566 Manuel utilisateur

Prem-I-Air

Prem-I-Air EH1890 Manuel utilisateur

Prem-I-Air

Prem-I-Air PECCB3200 Manuel utilisateur

Prem-I-Air

Prem-I-Air EH1404 Manuel utilisateur

Prem-I-Air

Prem-I-Air EH1842 Manuel utilisateur

Manuels Chauffage populaires d'autres marques

oventrop

oventrop Regucor Series Manuel utilisateur

Blaze King

Blaze King CLARITY CL2118.IPI.1 Manuel utilisateur

ELMEKO

ELMEKO ML 150 Manuel utilisateur

BN Thermic

BN Thermic 830T Manuel utilisateur

KING

KING K Series Mode d’emploi

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Guide de démarrage rapide

Well Straler

Well Straler RC-16B Manuel utilisateur

EUROM

EUROM 333299 Manuel utilisateur

Heylo

Heylo K 170 Manuel utilisateur

Eterna

Eterna TR70W Manuel utilisateur

Clarke

Clarke GRH15 Mode d’emploi

IRSAP

IRSAP The Radiator Company Ovali Manuel utilisateur

Empire Heating Systems

Empire Heating Systems WCC65 Manuel utilisateur

Wetekom

Wetekom 92 86 43 Manuel utilisateur

Desa

Desa SPC170-F Manuel utilisateur

Watlow

Watlow Watrod Electric Tubular Heaters Manuel utilisateur

Haverland

Haverland ECO-DRY GPS Series Manuel de la liste des pièces

Stelpro

Stelpro ASILVC2060 Series Manuel utilisateur