SPECIFIC SAFETY RULES FOR CHIPPER SHREDDER
WARNING: Do not operate your chipper shredder until it is completely assembled and
installed according to the instructions.
1. Before starting the chipper shredder, make sure that the hopper inlet is empty.
2. Keep your face and body away from the opening.
3. Do not allow hands or any other part of the body or clothing near the hopper or discharge chute.
4. Never put your hands into the hopper while the chipper shredder is running. Always use the paddle
supplied with your shredder to push items into the hopper.
5. Do not try to force objects larger than the recommended diameter of 1-5/8" into the hopper.
6. Keep proper balance and footing at all times. Do not overreach. Never stand at a higher level than the
base of the tool when feeding material into chipper shredder.
7. Always stand clear of the discharge zone when operating the chipper shredder. Never reach under the
shredder until it has come to a complete stop.
8. When feeding material into the chipper shredder be careful to remove pieces of metal, rocks, bottles,
cans or other foreign objects that may damage the blades.
9. If the cutting mechanism strikes a foreign object or if the chipper shredder should start making any
unusual noise or vibration, turn it off and allow it to come to a complete stop. Disconnect from power
supply and take the following steps:
- Inspect for damage;
- Check for and tighten any loose parts.
WARNING: Never reach into the hopper until the chipper shredder has come to a complete
stop and is unplugged. The blades will continue to rotate for a few seconds after the shredder
is turned off.
10. Do not allow processed material to build up in the discharge zone; this may prevent proper discharge
and can result in kickback of material through the hopper.
WARNING: Never put your hands near the discharge chute. Failure to heed the warning
could result in serious injury.
11. If the shredder becomes clogged, turn it OFF and disconnect from power supply before clearing
debris. Keep the power source clear of debris and other accumulations to prevent damage to the
power source.
12. Keep all guards and deflectors in place and in good working condition.
13. Do not operate the chipper shredder on a paved or gravel surface where ejected material could cause
injury.
14. Turn off the chipper shredder and disconnect it from the power supply whenever you leave the work
area.
15. Do not tilt the chipper shredder while it is running.
16. Never reach into the hopper until the chipper shredder has come to a complete stop and has been
disconnected from the power supply.
