PowerPoint P154CZTC Manuel utilisateur
1
Ceramic Hob
P154CZTC & P154CZSS& P152CZTC
INSTRUCTIONS:
Please read and keep safe for future use.
2
Features ………………………………………………………………………………………………….. 3
Safety Instructions.........................................................................................5
Installation ....................................................................................................6
Electrical Requirements ………………………………………………………….…………..…...9
Using your Hob ………………………………………………………………………………….…….10
Cleaning and Care …………...……………………....................................................14
Top Tips .......................................................................................................15
Disposal/ Technical Specifications ………………………......................................16
Problem Solving .……..…………………………………………………………………………......17
Health & Safety ………………………………………………………….……….……………….....18
Warranty Information..................................................................................20
Customer Care ………………………………………………………………..……………………...22
Table of Contents
3
Ceramic TopWϭϱϰdΘWϭϱϰ^^
Control PanelWϭϱϰdΘWϭϱϰ^^
Features
1. 1200 W zone
2. 1800 W zone
3. 1200 W zone
4. 1800 W zone
5. Glass plate
6.Control panel
1.Zone selection
2.Timer control
3.Time and Power selection
4. Child lock
5.ON/OFF control
4
Ceramic TopWϭϱϮd
Control PanelWϭϱϮd
Features
1.1800 W zone
2. 1200 W zone
3.Glassplate
4.Control panel
1.Zone selection
2.Timer control
3.Time and Power selection
4. Child lock
5.ON/OFF control
5
The use of any electrical appliance requires the following common sense
safety rules. There is danger of injury or death to the person and damage to
the appliance.
Note: If the following instructions are not adhered to the warranty will not
be applicable
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities unless there is a
person responsible for their safety present
This appliance must be installed by a registered electrician
Never attempt to repair the appliance yourself
This appliance is intended to be used in a household only, it is not
suitable for commercial use
Keep the electrical cable away from any heat source and do not let the
cable touch the appliance
Ensure that the electric supply cable is not trapped or damaged during
Installation
Prior to installation ensure that the electricity voltage and frequency
are compatible with your appliance
If the cable becomes damaged, it must be replaced by an electrician
The materials surrounding the appliance (cabinets) must be able to
withstand a minimum temperature of 100°C
The appliance and its accessible parts become hot during use. Care
should be taken to avoid touching hot parts
Cooking on a hob with fat or oil can be dangerous and should not be
left unattended
NEVER try to extinguish a cooking fire with water. Instead switch off
the appliance and cover flame with a lid or a fire blanket
Do not allow children in the kitchen when cooking or while hob parts
may still be hot
Before starting to use your appliance ensure that curtains, paper or
flammable items are kept away from your appliance. Do not keep
flammable materials around your hob
Safety Instructions
6
Position pans over the centre of the burners and turn handles to a
safe position where they cannot be knocked or grabbed
Make sure the control knobs are all in the off position when not in use
If you do not intend to use your hob for a long period of time turn off
the electric supply
Do not operate the appliance using an external timer or remote
control system
Do not cook on a broken or cracked surface
A temperature sensor monitors the temperature inside the ceramic
hob. When an excessive temperature is monitored, the ceramic hob
will stop operation automatically
When the hob has been operating for some time, there will be some
residual heat. The letter “ H ”appears on the display to warn you that
the area is hot
Choosing Your Cookware
Do not use cookware with jagged edges or a curved base
Make sure that the base of your pan is smooth, sits flat against the
glass, and is the same size as the cooking zone. Always centre your
pan on the cooking zone
Always lift pans off the ceramic hob, do not slide as they may
scratch the glass.
This hob must be installed according to local regulations by a suitably
qualified electrician
Carefully unpack the hob and check for any external visible damage.
Do not install or use if it is damaged
Remove any protective film that may still be on your ceramic hob
Packaging materials should be collected together and disposed of
immediately as they may be harmful to children
If fitted, an extractor fan must be at least 65cm above the hob
Installation Instructions
7
The wall behind the hob and 450 mm above and across hob should be
made from an incombustible material, preferably an easy clean
surface, such as ceramic tiles
Cut out the work surface according to the sizes shown below
For the purpose of installation and use, a minimum of 50mm space
shall be preserved around the hole.
The thickness of the work surface must be at least 30mm and must be
heat-resistant
Model
L(mm)
W(mm)
H(mm)
D(mm)
A(mm)
B(mm)
X(mm)
P154CZTC
590
520
52
48
560
490
50mini
P154CZSS
590
520
52
48
560
490
50mini
P152CZTC
288
520
52
48
268
500
50mini
8
A(mm) B(mm) C(mm) D E
760 50 mini 20 mini Air intake Air exit 10mm
The ceramic hob should be placed horizontally as shown below:
·Ensure tha he ceramic hob is well venlated and tha he air inlet
and outlet are not blocked
·Before locang the fixing brackets the unit should be placed on a
stable, smooth surface ensuring that no pressure is put onto the
controls protruding from the hob
·Fix the hob to the work surface by screwing four brackets on the
boom o ob (see below) aer installaon.
A B C D
screw bracket Screw hole base
9
Warning: This appliance must be earthed
Warning: There is risk of electric shock
The appliance must be directly connected to the mains using an omni-
polar circuit-breaker with a minimum contact opening of 3 mm
installed between the appliance and the mains. The circuit-breaker
must be suitable for the charge indicated and must comply with
current electrical regulations (the earthing wire must not be
interrupted by the circuit-breaker)
All electrical connections should be made by a qualified Electrician
Check that the voltage on the rating plate of your appliance
corresponds with your house electricity supply which must be A.C.
(Alternating Current)
Connecting the hob to the mains power supply
The wires in the mains lead are coloured as follows:
GREEN AND YELLOW: EARTH
BLUE AND GREY: NEUTRAL
BROWN AND BLACK: LIVE
Release the cover plate by removing the cover screw
Loosen the cable clamp
Electrical Requirements
10
Connect the mains supply cable to the terminal block on the hob using
the colour code
Secure the cable clamp
Check the cable terminals for tightness and ensure that the terminal
links are in place, then replace the cover plate and cover screw
Using the Touch Controls
The controls respond to touch, so you don’t need to apply any pressure. Use
the ball of your finger, not its tip. You will hear a beep each time a touch is
registered. Make sure the controls are always clean and dry.
Before first use, clean the hob surface (see “Cleaning and Care” section).
Switch on one cooking zone at a time for 5 minutes at the maximum setting to
eliminate any smell. Place a saucepan half filled with cold water on each zone
as you burn it off.
To start cooking
After power on, the buzzer beeps once, indicators light up for 1 second then
go out, indicating that the hob is in standby mode.
1. Touch the ON/OFF control; all the indicators will show “-“.
2. Place a pan on the cooking zone that you wish to use.
3. Select a heat setting by touching the”+” or “-“ button. If you don’t choose a
Using Your Hob Top
Ce manuel convient aux modèles suivants
2
Table des matières
Autres manuels PowerPoint Plaque
