Helpline No. UK / Northern Ireland 0870 7323023 • Rep. Ireland 1800 481005
Web support: www.omegawolf.com/powercraft
Model Number: PSC-360/2L
09
Safety instructions
(b) Wear your safety equipment and always put on safety goggles. Wearing
personal protective gear, such as a dust mask, anti-skid safety shoes, hard
hat and ear protection, depending on the use of the electric tool, will
reduce the risk of injury.
(c) Avoid unintentional operation. Make sure that the switch is in the “OFF”
position before you remove the plug from the socket. If you have your
finger on the switch when carrying the machine or if you connect the
running machine to the socket, this may lead to accidents.
(d) Remove the adjusting tools or the spanners before switching on the
machine. A tool or a key which is located in a revolving part of the
machine may lead to injuries.
(e) Concentrate and keep your balance at all times as you will be able to
control the machine better in unexpected situations.
(f) Wear suitable clothing. Do not wear any loose clothing or jewellery. Keep
your hair, clothing and gloves clear of any moving parts.
(g) If dust extraction or collection devices can be mounted, make sure that
they are connected properly and are used in the proper way. The use of
these pieces of equipment reduce hazards caused by dust.
4) Careful handling and use of electric tools
(a) Use the correct tool for the job at hand.
(b) Do not use an electric tool, if the switch is defective. An electric tool,
which cannot be switched on or off, is dangerous and has to be repaired.
(c) Remove the plug from the socket before setting down the machine,
changing accessories or putting the machine aside. This precautionary
measure prevents the unintentional start of the machine.
(d) Keep unused electric tools out of reach of children. Do not permit persons
to use the machine who are not familiar with it or who have not read
these instructions. Electric tools are dangerous, if they are used by an
inexperienced person.
(e) Maintain the machine with care. Please check whether the movable parts
are perfectly operational and do not jam, whether parts have broken or
have been damaged in such a way that the function of the machine is
impaired. Have damaged parts repaired prior to using the machine. Many
accidents are caused by electric tools which are poorly maintained.
(f) Keep all cutting tools sharp and clean.
(g)Use the electric tool, the accessories, the insert tools, etc according to these
instructions, and in the way described for this special type of apparatus. In
the process, take the working conditions and the work to be carried out into
consideration. Only use this tool for the purpose for which it is intended.
Helpline No. UK / Northern Ireland 0870 7323023 • Rep. Ireland 1800 481005
Web support: www.omegawolf.com/powercraft
Model Number: PSC-360/2L
12
Operation
Always observe the safety instructions and applicable regulations.
Firmly hold the machine and fasten the bit with even pressure into the
workpiece. Do not force the machine. Use only bits that do not yet show any
signs of wear. Worn bits have a negative effect on the efficiency of the
machine.
Locking the screwdriver
Fig. 8
The screwdriver is fitted with an automatic spindle lock feature. When the
On/Off switch (2) is not pressed, the spindle is locked. Now it is possible to use
the screwdriver (even when the battery is empty) as a manual tool.
Screwdriving
Fig. 6 (page 5)
To switch the tool on, press the On/Off switch (2).
-Press the tumbler switch (R) for clockwise rotation (tightening screws)
- Press the tumbler switch (L) for counterclockwise rotation (loosening
screws)
To switch the tool off, release the on/off switch.
The white LED will illuminate when the tumbler switch is pressed.
