Pioneer AVIC-505 Manuel utilisateur
ENGLISH
Mobile Navigation Unit
Unité de navigation automobile
AVIC-505
Installation Manual
Manuel d’installation
NAVIGATIONCOMMANDER
ESPAÑOL DEUTSCH FRANÇAIS ITALIANO NEDERLANDS
1
IMPORTANT INFORMATION
ABOUT YOUR NEW MOBILE NAVIGATION SYSTEM AND THIS MANUAL……
• The Pioneer Mobile Navigation System is intended solely as an aid to you in the
operation of your vehicle. It is not a substitute for your attentiveness, judgement
and care while driving.
• Do not use your navigation system to route you to emergency services such as
hospitals or police stations. Not all emergency service facilities are contained in
the map data.
•Do not operate the mobile navigation system if doing so will divert your attention
from the safe operation of your vehicle. Always observe safe driving rules and
follow all existing traffic regulations.
• Use our navigation system in the area only where PIONEER permitted.
• This manual explains how to install this mobile navigation unit in your vehicle.
Operation of this mobile navigation system is explained in the separate Owner’s
Manual that also came with this system.
IMPORTANT SAFEGUARDS .................... 3
PLEASE READ ALL OF THESE
INSTRUCTIONS REGARDING
YOUR MOBILE NAVIGATION
SYSTEM AND RETAIN THEM
FOR FUTURE REFERENCE. .................. 3
Connecting the system .............................. 5
CAUTION ........................................................ 5
Before installing the unit .................................. 6
To prevent damage ............................................ 6
Parts supplied .................................................... 6
Connecting the system ...................................... 7
Connecting the power cord (1) .......................... 8
Connecting the power cord (2) .......................... 9
Installation ................................................ 11
CAUTION ...................................................... 11
To guard against electromagnetic
interference ................................................12
Before installing and fixing ............................ 12
Before using the adhesive tape ........................ 12
Installing the main unit .................................... 13
-Installation notes
-Parts supplied
-Installing the main unit inside the boot,
on the floor under a seat, etc.,
using tapping screws
Installing the GPS antenna .............................. 16
-CAUTION
-Installation notes
-Parts supplied
-When installing the antenna inside the
vehicle (on the dashboard or rear shelf)
-When installing the antenna outside the
vehicle (on the body)
Installing the commander ................................ 19
-Parts supplied
-Loading the batteries
-Battery notes
-Installing the commander with velcro tape
-Commander handling notes
Installing the microphone ................................ 21
-Installation notes
-Parts supplied
-When installing the microphone on the
sun visor
-When installing the microphone on the
steering column
After installing the unit .......................... 24
2
ENGLISH ESPAÑOL DEUTSCH FRANÇAIS ITALIANO NEDERLANDS
Contents
IMPORTANT SAFEGUARDS
3
PLEASE READ ALL OF THESE INSTRUCTIONS REGARDING YOUR MOBILE
NAVIGATION SYSTEM AND RETAIN THEM FOR FUTURE REFERENCE.
1. Read this manual fully and carefully before installing your mobile navigation sys-
tem.
2. Keep this manual handy for future reference.
3. Pay close attention to all warnings in this manual and follow the instructions care-
fully.
4. This navigation system is intended solely as an aid to you in the operation of your
vehicle. It is not a substitute for your attentiveness, judgement and care while dri-
ving. Do not operate your navigation system if doing so will divert your attention
from the safe operation of your vehicle. Always observe safe driving rules and
follow all existing traffic regulations.
5. This navigation system may in certain circumstances display erroneous informa-
tion regarding the position of your vehicle, the distance of objects shown on the
screen, and compass directions. In addition, the system has certain limitations,
including the inability to identify one-way streets, temporary traffic restrictions
and potentially unsafe driving areas. Please exercise your own judgement in light
of actual driving conditions.
4
ENGLISH ESPAÑOL DEUTSCH FRANÇAIS ITALIANO NEDERLANDS
6. As with any accessory in your vehicle’s interior, the navigation system should not
divert your attention from the safe operation of your vehicle. If you experience
difficulty in operating the system or reading the display, please make adjustments
while safely parked.
7. Do not attempt to install or service your mobile navigation unit by yourself.
Installation or servicing of the Mobile Navigation Unit by persons without train-
ing and experience in electronic equipment and automotive accessories may be
dangerous and could expose you to the risk of electric shock or other hazards.
8. Please remember to wear your seat belt at all times while operating your vehicle.
If you are ever in an accident, your injuries can be considerably more severe if
your seat belt is not properly fastened.
5
Connecting the System
CAUTION
• Pioneer does not recommend that you install or service your navigation unit
yourself. Installing or servicing of the product may expose you to risk of elec-
tric shock or other hazards. Refer all installation and servicing of your navi-
gation unit to authorised Pioneer service personnel.
• Secure all wiring with cable clamps or electrical tape. Do not allow any bare
wiring to remain exposed.
• Do not drill a hole into the engine compartment to connect the orange lead of
the unit to the vehicle battery. Engine vibration may eventually cause the
insulation to fail at the point where the wire passes from the passenger com-
partment into the engine compartment. Take extra care in securing the wire
at this point.
• It is extremely dangerous to allow the GPS antenna lead or microphone lead
to become wound around the steering column or gearstick. Be sure to install
the unit in such a way that it will not obstruct driving.
• Make sure that wires will not interfere with moving parts of the vehicle, such
as the gearstick, hand brake or seat sliding mechanism.
• Do not route wires where they will be exposed to high temperatures. If the
insulation heats up, wires may become damaged, resulting in a short circuit
or malfunction.
• Do not cut the GPS antenna lead to shorten it or use an extension to make it
longer. Altering the antenna cable could result in a short circuit or malfunc-
tion.
• Do not shorten any leads. If you do, the protection circuit may fail to work
properly.
• Never feed power to other electronic products by cutting the insulation of the
power supply lead of the navigation unit and tapping into the lead. The cur-
rent capacity of the lead will be exceeded, causing overheating.
Before installing the unit
• This unit is designed for vehicles with a 12-volt battery and negative grounding. Before
installing the system (especially in a recreational vehicle, lorry, or bus), check the bat-
tery voltage.
To prevent damage
• When disconnecting a connector, pull the connector itself. Do not pull the lead, as you
may pull it out of the connector.
Parts supplied
ConnectorPink lead extension cord
Power cord
Purple lead extension cordRGB cable
No ACC position
Fig. 2
ACC position
Fig. 1
O
N
S
T
A
R
T
O
F
F
A
C
C
O
N
S
T
A
R
T
O
F
F
• When the unit is installed in vehicles
that do not have an ACC (accessory)
position on the ignition (as shown in
Fig. 2), be sure to connect the red lead
of the unit to the terminal controlled by
the ignition switch ON/OFF position. If
you do not, the vehicle battery may be
drained.
• Disconnect the negative (–) terminal of
the battery to avoid the risk of a short
circuit.
6
ENGLISH ESPAÑOL DEUTSCH FRANÇAIS ITALIANO NEDERLANDS
7
Connecting the System
Connecting the system
Mobile Navigation Unit
AVIC-505
RGB cable (supplied)
Color Display
AVD-505
Microphone
GPS antenna
Power cord
See Pages 8-10.
COLORDISPLAY
8
ENGLISH ESPAÑOL DEUTSCH FRANÇAIS ITALIANO NEDERLANDS
Connecting the power cord (1)
Mobile Navigation Unit
AVIC-505
+ Battery
To the terminal always supplied with power regardless of
ignition switch position.
Fuse holder (6 A)
ACC
To the electric terminal controlled by the ignition switch
(12 V DC) ON/OFF.
Do not connect this lead to power source terminals to
which power is continuously supplied. If the lead is
connected to such terminals, the battery may be drained.
ILL
To lighting switch terminal.
GROUND
To vehicle (metal) body. To keep electromagnetic noise
from the vehicle body out of the mobile navigation system,
attach this lead near the main unit.
Black
Fuse resistor
Orange
Fuse resistor
Red
Yellow
Note: The orange, red, and yellow leads should be
connected to the opposite side of the fusebox terminals
from the battery.
Yellow/Black, Purple, Pink, Blue/Yellow
Note: When replacing the fuse, be
sure to use only a fuse of the rating
prescribed on the fuse holder.
Power cord
See next page.
9
Connecting the System
Connecting the power cord (2)
PARKING BRAKE
Used to detect the ON/OFF status of the parking brake.
This lead must be connected to the power supply side of
the parking brake swich. If this connection is made
incorrectly or omitted, certain functions of your
navigation system will be unusable.
Clamp firmly with
needle-nosed pliers.
Close the cover.
Pass the extension cord
and the lead for the
speed detection circuit
through this hole.
Connection method
Connection method
Clamp firmly with
needle-nosed pliers.
Clamp the parking brake
switch power supply side
lead.
Pink lead extension
cord
Connector
CAR SPEED SIGNAL INPUT
The mobile navigation system is connected here to detect
the distance the vehicle travels. Always connect the
vehicle's speed detection circuit or the ND-PG1 speed
pulse generator, sold separately. Failure to make this
connection will increase errors in the location display.
Vehicle injection computer
Speed detection circuit lead
Pink Pink
Power supply side
Ground side
Parking brake switch
Blue/Yellow
Note: The position of the speed detection circuit
depends on the vehicle model. For details,
consult the relevant documents from Pioneer.
When making connections for a model not listed
in those documents or for which connection to
the speed detection circuit is too difficult,
connect the separately sold ND-PG1 speed pulse
generator to the pink lead.
Note: The position of the parking brake switch
depends on the vehicle model. For details,
consult the vehicle owner's manual or dealer.
Autres manuels pour AVIC-505
3
Table des matières
Langues :
Autres manuels Pioneer GPS
Pioneer
Pioneer AVIC-6200NEX Manuel utilisateur
Pioneer
Pioneer AVIC-5201NEX Manuel utilisateur
Pioneer
Pioneer AVIC-F310BT Manuel utilisateur
Pioneer
Pioneer AVIC-S1 Manuel utilisateur
Pioneer
Pioneer AVIC-8000NEX Manuel utilisateur
Pioneer
Pioneer AVIC-F310BT Manuel utilisateur
Pioneer
Pioneer AVIC-Z150BH Manuel utilisateur
Pioneer
Pioneer AVIC-HD1BT Manuel utilisateur
Pioneer
Pioneer AVIC-S2 Manuel utilisateur
Pioneer
Pioneer AVIC-W8500NEX Manuel utilisateur
Pioneer
Pioneer CNDV-60M Manuel utilisateur
Pioneer
Pioneer AVIC-F700BT/XS/UC Instructions de construction
Pioneer
Pioneer AVICF500BT - CD-VM1 Optional Microphone Manuel utilisateur
Pioneer
Pioneer AVIC-S2 Guide de démarrage rapide
Pioneer
Pioneer CNDV-700HD Instructions d'installation et d'utilisation
Pioneer
Pioneer AVIC-U220 Manuel utilisateur
Pioneer
Pioneer AVIC-W8500NEX/XNUC Manuel utilisateur
Pioneer
Pioneer AVIC-8200NEX Manuel d'utilisation
Pioneer
Pioneer CNDV-1000HD Instructions d'installation et d'utilisation
Pioneer
Pioneer AVIC-F3210BT Manuel utilisateur
