Pilot Communications Trainer Manuel utilisateur

Trainer Assembly

Trainer

Assembly

Manual

il t

www.p

-rc.com

-Pilot Trainer- 1

-Pilot Trainer- 2

-Pilot Trainer- 3

Plii i &tb bl

nary w

assem

1-) Locate both Plywood wing

joiners (Large and small one) 2-) Insert both wing joiners inside

one wing panel.

3-) Slide the other wing panel

over the plywood joiners. 4-) Bring both wing panels

together and verify for proper fit.

-Pilot Trainer- 4

5-) Fit the complete wing over 6-) Locate the 4 wing mounting

the fuselage as shown. screws and washers from the

enclosed hardware bag.

7-) Insert the 4 screws and washers in the pre-cut holes in the wing,

securing them into the pre-installed “Blind-Nuts” inside the fuselage.

-Pilot Trainer- 5

) Measure the width of the

) Insert the stab into the

)

Measure

the

width

the

fuselage and insert a “modeling

pin” in the middle as shown.

)

Insert

the

stab

into

the

fuselage. Measure from the pin up

to the stab tip. See next picture.

10-) Measure from the other

side and equally space the stab

onto the fuselage.

11-) Once the stab is centered,

draw a line on both side of the

stab as shown, both top and

btt fth tb

om o

e s

-Pilot Trainer- 6

13-) Repeat on the bottom of the

stab.

12-) Using a modeling knife, cut

along the marked lines and

stab.

along

the

marked

lines

and

remove the covering.

-Elevator control horn assembly-

15-) Using a sanding bar, sand

the horn section (on both sides)

th t ill b i t d i t th

14-) Locate the control horns for

the hardware bag.

ill

nser

elevator for better glue adhesion.

-Pilot Trainer- 7

16-) Locate the pre-cut slot on the 17-) Mix some “30-minute epoxy”

-FRONT-

bottom of the elevator and cut to

remove the covering. and glue the elevator horn. NOTE:

The horn must face the front of the

leading edge of the elevator.

18-) Apply 30-minute epoxy to

both the stab and fuselage

sections and slide the stab into

19-) Before the epoxy cures, align

the stab by equally measuring

from each win

s as reference.

position.

-Pilot Trainer- 8

STAB

-WING-

) While the epoxy is curing align the stab to the wing by

STAB

)

While

the

epoxy

curing

align

the

stab

the

wing

looking from the front of the fuselage. Adjust if required.

Tail group assembly

21-) Cut and remove the covering

from the bottom of the fin

ost. 22-) Mix some 30-minute epoxy

and a

to both the fin and

-FIN POST-

pp y

fuselage inner sections. Secure

with masking tape.

-Pilot Trainer- 9

23-) While the epoxy is curing,

align the fin to the stab at 90- 24-) Set the tail wheel bracket

over the fuselage as shown. Drill

degrees. small holes and secure with the

supplied wood screws.

21mm

25-) You will need to make a 90-

degree bend into the steel wire,

21mm from the top of the stab.

NOTE: The bend must be parallel

26-) The rudder as a pre-cut slot

in it’s leading edge. Cut and

remove the covering and trial fit

the steel wire into it

NOTE:

The

bend

must

parallel

to the rubber tail wheel.

the

steel

wire

into

-Pilot Trainer- 10

Autres manuels Pilot Communications Jouet

Pilot Communications

Pilot Communications J-10 Jet 107" Manuel utilisateur

Pilot Communications

Pilot Communications 50CC Manuel utilisateur

Pilot Communications

Pilot Communications Pitts Challenger Manuel utilisateur

Pilot Communications

Pilot Communications 100-170cc Manuel utilisateur

Pilot Communications

Pilot Communications Katana Manuel utilisateur

Pilot Communications

Pilot Communications Viper Jet 78 Manuel utilisateur

Pilot Communications

Pilot Communications Sbach 342 Manuel utilisateur

Pilot Communications

Pilot Communications Predator Sport Jet 90" Manuel utilisateur

Pilot Communications

Pilot Communications 50CC Manuel utilisateur

Pilot Communications

Pilot Communications Decathlon 180 Manuel utilisateur

Pilot Communications

Pilot Communications Viper Jet 73" Manuel utilisateur

Pilot Communications

Pilot Communications COLUMBIA 400 Manuel utilisateur

Pilot Communications

Pilot Communications 30cc Manuel utilisateur

Pilot Communications

Pilot Communications 30cc Manuel utilisateur

Pilot Communications

Pilot Communications Skyline 182 Manuel utilisateur

Pilot Communications

Pilot Communications Dolphin Jet Manuel utilisateur

Pilot Communications

Pilot Communications Predator Sport Jet 90" Manuel utilisateur

Pilot Communications

Pilot Communications Bergfalke II-55 Glider Manuel utilisateur

Manuels Jouet populaires d'autres marques

marklin

marklin 37321 Manuel utilisateur

Canon

Canon PAPER CRAFT Manuel utilisateur

GREAT PLANES

GREAT PLANES Pitts M-12S Manuel utilisateur

NOCH

NOCH 14261 Manuel utilisateur

Hausler

Hausler 450 SE V2 Manuel utilisateur

Dynaflite

Dynaflite Daydream Manuel utilisateur

MiniacRC

MiniacRC MIGHTY MINI P40 WARHAWK Manuel

Kenner

Kenner Batman 63651 Manuel utilisateur

LEGO

LEGO 8527 Manuel utilisateur

iKarus

iKarus ECO 8 Manuel utilisateur

Multiplex

Multiplex EasyStar II Mode d’emploi

Walkera

Walkera 38 Mode d’emploi

Hasbro

Hasbro TRANSFORMERS BUMBLEBEE Manuel utilisateur

MD MXION SWD Manuel utilisateur

Mattel

Mattel Disney Pixar Cars Cozy Cone Spiral Rampway Manuel utilisateur

marklin

marklin 39671 Manuel utilisateur

Meccano

Meccano 15103 Manuel utilisateur

LEGO

LEGO TECHNIC 8735 Manuel utilisateur