buttons or three buttons together, but you need repeat the program/learn process if you want to use
more than one button.
Fig.12 Remote transmitter
Adding extra remote controls (Learn): Remove the cover, press the learn button AN1 (Fig.8), then
the 2 (Fig.8) will be on and turn off, then press the remote control button which you want to use,
the LED
LED
2 will turn on about 2 seconds and then turn off again. The learning process is finished.
Up to 25 remote controls may be used.
Erase remote controls: To erase all existing remote controls, press and hold learn button AN1 , the
LED2 turns on, release the button once LED2 turns off. This indicates that all the remote
controls have been erased completely.
Note: Press the OPEN button of external button switch or remote control button which has been
learned, the gate will open, the motor rotates clockwise, and the LED2 is turns on. The output
voltage between D1 and D2 (terminal X3) is AC220V, the voltage between V and U is AC220V
.Press STOP button or the same remote control button, the gate stops running. And the LED2
is turns off. Then press CLOSE button or the same remote control button again, the gate will close,
the motor rotates anticlockwise, and the LED2 is turns on. The output voltage between D1 and D2
(terminal X3) is AC220V, the voltage between V and W is AC220V .Press the STOP button or
the same remote control button, the gate stops running. And the LED2 is turns off.
Verify open direction: If the gate does not move in the desired direction, then you will need to
reverse the motor operating direction, open the black plastic cover, you can do this by exchanging
wires U and OPLT and CLLT .
Button 1
Button 2 Button 3
Button 4
