Philips AQ 6345 Manuel utilisateur

Memo Recorder AQ 6345

TAPE SPEED

VOLUME

MIC REC

TAPE SPEED

VOLUME

MIC REC

COUNTER RESET

VOICE ACT

BNS

REC

COUNTER RESET

VOICE ACT

BNS

REC

MEMORECORDER

BACKGROUND NOISE SUPPRESSION

FLAT MIC

AQ6345

BNS

MEMORECORDER

BACKGROUNDNOISE SUPPRESSION

FLAT MIC

AQ6345

BNS

XP AQ 6345/00 02-02-2000 11:01 Pagina 1

INDEX

Ελληνικά

Suomi

Svenska

Dansk

Português

Italiano

Nederlands

Deutsch

Español

Français

English

nNorge

Advarsel: For å redusere faren for brann eller elektrisk støt;

skal apparatet ikke utsettes for regn eller fuktighet.

Typeskilt finnes på apparatens underside.

Observer: Nettbryteren er sekundert innkoplet. Den

innebygde netdelen er derfor ikke frakoplet nettet så lenge

apparatet er tilsluttet nettkontakten.

English ................................................................... 5

Français ............................................................. 10

Español ............................................................... 15

Deutsch .............................................................. 20

Nederlands ................................................... 25

Italiano ................................................................ 30

Portugûes ....................................................... 35

Dansk .................................................................... 40

Svenska ............................................................. 45

Suomi ................................................................... 50

Έλληνικά ...................................................... 55

XP AQ 6345/00 02-02-2000 11:01 Pagina 2

TAPE SPEED

VOLUME

MIC REC

COUNTER RESET

VOICE ACT

BNS

REC

MEMORECORDER

BACKGROUNDNOISE SUPPRESSION

FLAT MIC

AQ6345

BNS

R6/UM3/AA

BNS

VOICE ACT

9STOP

2PLAY

5REWIND

6 WIND

0 REC

COUNTER RESET

FLAT MIC

BATTERY

COMPARTMENT

DC 3V ->+

;PAUSE

TAPE SPEED

MIC

REC

EVOLUME

XP AQ 6345/00 02-02-2000 11:01 Pagina 3

NOTES

XP AQ 6345/00 02-02-2000 11:01 Pagina 4

POWER INDICATOR

Whether the set is operated on batteries or a mains adapter,

during playback or recording, the power indicator lights

up.

• The power indicator goes out when the set is switched off.

• If battery power is low, the power indicator lights up only

dimly and you will need to replace batteries.

Batteries (not included)

1. Open battery door and insert two alkaline batteries, type

R6, UM3 or AA as indicated inside the compartment.

2. Remove the batteries from the set if they are exhausted or

not to be used for a long time.

•Batteries contain chemical substances, so they

should be disposed of properly.

Mains Adapter (not included)

1. The voltage of the DC 3V adapter must match with the

local voltage. The 3.5 mm adapter plug's 1.3 mm centre pin

also must be set to the minus pole -.

2. Connect the mains adapter to the set's DC 3V ->+

socket and a wall socket.

3. Always disconnect the mains adapter if you are not using it.

POWER SUPPLY

English

XP AQ 6345/00 02-02-2000 11:02 Pagina 5

CASSETTE PLAYBACK

1. Open the cassette door and insert a tape (see fig. 2).

2. Press the door lightly to shut.

3. To start playback, press 1.

4. Adjust the sound with VOLUME.

• For personal mono sound listening, insert 3.5mm

headphones (preferably type ≥16 ohms) into the psocket.

The built-in speaker will then be disconnected.

5. To fast wind, press 5or 6.

6. Watch the tape counter display to find the point in the tape

you want to listen to. Press 9to stop fast winding at the

selected point.

•5or 6also allows you to fast cue or review during

playback. Using the tape counter to monitor passages, hold

down on 5or 6and release the key at the passage you

want. Tape playback continues from this point.

• To reset the tape counter display to 000, press the

COUNTER RESET switch.

7. You can also adjust TAPE SPEED to find or listen to

passages during playback. Set TAPE SPEED to:

•✚for high speed playback;

•0for normal speed playback;

•-for low speed playback.

Remember to set TAPE SPEED to 0for normal playback!

8. For brief interruptions, adjust PAUSE ;. To deactivate

pause, slide the switch back again.

9. To stop playback, press 9and the set is switched off.

•At the end of a tape, the 1key is automatically released

and the set switched off, unless PAUSE ;has been

activated.

GENERAL INFORMATION ON RECORDING

• This set is not suited for recording on CHROME (IEC II) or

METAL (IEC IV) type cassettes. You should only use

NORMAL type cassettes (IEC type I) on which the tabs have

not been broken.

• Altering the VOLUME and TAPE SPEED controls will not

affect the recording in progress with the exception of when

VOICE ACT is in use and VOLUME is adjusted.

• At the very beginning and end of the tape, no recording will

take place during the 7 seconds when the leader tape

passes the recorder heads.

• Recording is permissible insofar as copyright or other rights

of third parties are not infringed.

CASSETTE PLAYBACK RECORDING

English

XP AQ 6345/00 02-02-2000 11:02 Pagina 6

PROTECTING TAPES FROM ACCIDENTAL ERASURE

(see fig. 3)

To safeguard a particular cassette, simply break out the left

tab. Recording on this side is no longer possible. If, however,

you wish to record over this side or a tape with open tabs,

cover the tabs with a piece of adhesive tape.

VOICE ACT (ACTivation)

VOICE ACT is a sound level sensor system which enables you

to record only when the microphone receives sound at the

preset level. The VOLUME wheel acts as the control for the

microphone sensor. If sound stops or falls below the volume

adjusted for the preset level, recording will pause hence

preventing empty recording. To activate:

1. Push VOICE ACT to ON.

2. Turn VOLUME:

Anti-clockwise – the sound level sensitivity drops and

only sound near the microphone will be

recorded.

Clockwise – sound sensitivity is increased. Distant and

background sounds will be picked up.

Note: When the recording pauses and is resumed

automatically according to the preset sound level, the

beginning of the track can be lost due to the recording

cut off and starting points.

BACKGROUND NOISE SUPPRESSION (BNS)

When in noisy surroundings, to achieve a clearer and better

defined voice recording, activate the BNS switch. The BNS

system emphasizes the frequency range of the human voice

while reducing both the high and low frequencies that usually

comprise noise. If you like, use BNS with VOICE ACT during

recording.

MAKING YOUR RECORDING

1. Open the cassette door and insert a tape (see fig. 2).

2. Press the door lightly to shut.

3. Adjust BNS and VOICE ACT to ON /OFF to suit your

recording mode (see VOICE ACT and BNS chapters above).

• If you do not wish to use the FLAT MIC built-in

microphone, insert an external microphone with a 3.5 mm

plug into the MIC socket and point to the sound source.

Make sure that you direct the microphone away from the

set to avoid a howling sound. Once the MIC is connected,

the FLAT MIC will not pick up sound.

RECORDING

English

XP AQ 6345/00 02-02-2000 11:02 Pagina 7

• To monitor your recording, connect headphones to p.

4. To start recording, press REC 0.

• The REC indicator lights up.

•You can also start recording immediately during playback.

Press REC 0.

5. For brief interruptions, adjust PAUSE ;. To deactivate

pause, slide the switch back again.

6. To stop recording, press 9and the set is switched off.

• The REC indicator goes out.

•At the end of a tape, the 1and REC keys are automatically

released and the set switched off, unless PAUSE ;has

been activated.

7. To check your recording, use the 5or 6keys (see

CASSETTE PLAYBACK).

GENERAL INFORMATION

MAINTENANCE (see fig.4)

• Clean the tape heads every month with a cotton bud dipped

in alcohol, or by playing through a cleaning tape.

• Use a soft damp cloth to wipe off dust and dirt. Don't use

benzene or corrosives to clean the set.

• Don't expose the set or cassettes to rain, moisture, sand or

to excessive heat e.g. cars parked in direct sunlight.

• Don't use C-120 tapes.

TAKE CARE WHEN USING HEADPHONES

Hearing Safety: Listen at a moderate volume. Use at high

volume can impair your hearing!

Traffic Safety: Do not use headphones while driving or

cycling as you may cause an accident!

ENVIRONMENTAL NOTE

• The packaging has been minimized so that it is easy to

separate into two materials:- cardboard and plastic. Please

observe the local regulations regarding the disposal of

these packaging materials.

• Please inquire about local regulations on how to hand in

your old set for recycling.

This product complies with the radio interference

requirements of the European Community.

RECORDING GENERAL INFORMATION

English

XP AQ 6345/00 02-02-2000 11:02 Pagina 8

TROUBLESHOOTING

English

PROBLEM

– POSSIBLE CAUSE

• REMEDY

No sound/ power

– Wrong battery polarity

• Insert batteries correctly

– Batteries exhausted

• Replace batteries

–PAUSE ;has been activated

• Switch PAUSE ;off

– Volume is turned down

• Turn up volume

– Headphones still connected, speaker muted

• Disconnect headphones

Hum when using mains adapter

– Adapter used is unsuitable

• Use a Philips SBC6650 or other standard regulated DC 3V

adapters

Poor sound/sound from one channel only:

– Headphones plug not fully inserted

• Insert plug fully

Poor cassette sound quality

– Tape head dirty

• Clean tape head (see MAINTENANCE)

Tape playback too slow/ fast

– TAPE SPEED on wrong setting

• Set TAPE SPEED to 0

If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by

following these hints, consult your dealer or service centre.

WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the

guarantee.

The model number is found at the back of the set and the production number in the battery compartment.

XP AQ 6345/00 02-02-2000 11:02 Pagina 9

Table des matières

Autres manuels Philips Enregistreur vocal

Philips

Philips VoiceTracer DVT2015 Manuel utilisateur

Philips

Philips VOICE TRACER LFH0612 Manuel utilisateur

Philips

Philips VTR5160 Manuel utilisateur

Philips

Philips Pocket Memo LFH9380/27 Manuel utilisateur

Philips

Philips GoSure ADR800sp Manuel utilisateur

Philips

Philips Voice Tracer LFH0888 Manuel utilisateur

Philips

Philips Pocket Memo DPM8200 Manuel utilisateur

Philips

Philips LFH 0388 Manuel utilisateur

Philips

Philips VTR7610 Manuel utilisateur

Philips

Philips DPM 9350/00 Manuel utilisateur

Philips

Philips LFH 7780 Manuel utilisateur

Philips

Philips VOICE TRACER DVT1110 Manuel utilisateur

Philips

Philips Voice Tracer VTR8800 Manuel utilisateur

Philips

Philips Pocket Memo DPM8900 Manuel utilisateur

Philips

Philips VTR5103 Manuel utilisateur

Philips

Philips SPEECHMIKE AIR LFH3005 Manuel utilisateur

Philips

Philips LFH7177 - SpeechExec Transcription Set Manuel utilisateur

Philips

Philips VoiceTracer VTR7800 Manuel utilisateur

Philips

Philips VideoTracer DVT3120 Manuel utilisateur

Philips

Philips VOICE TRACER DVT1150 Manuel utilisateur

Philips

Philips SpeechMike II LFH5276 Manuel utilisateur

Philips

Philips VAD8031 Manuel utilisateur

Philips

Philips VTR5102Pro Manuel utilisateur

Philips

Philips LFH9398/00 Manuel utilisateur

Manuels Enregistreur vocal populaires d'autres marques

Sony

Sony ICD-UX533F Manuel utilisateur

RCA

RCA VR5230 Manuel utilisateur

Ramsey Electronics

Ramsey Electronics BULLSHOOTER ENDLESS LOOP BS2C Guide de l'utilisateur

Sony

Sony TCM-400DV Manuel utilisateur

LogTag

LogTag TREL30-16 Manuel utilisateur

SVAT

SVAT CVP800 Manuel utilisateur

Marantz

Marantz PMD620 Manuel utilisateur

Zoom

Zoom H4next Manuel utilisateur

Roland

Roland BR-900CD Manuel utilisateur

JVC

JVC ProHD GY-HMZ1U Manuel d'utilisation et d'entretien

Panasonic

Panasonic PQT8531-P Manuel utilisateur

Sanyo

Sanyo TRC-6400 Manuel utilisateur

Tascam

Tascam DR-07 Manuel utilisateur

Olympus

Olympus DW-90 Manuel utilisateur

Sanyo

Sanyo ICR-B150 Manuel utilisateur

Korg

Korg D4 Manuel utilisateur

Sony

Sony ICD-SX46 - Ic Recorder Manuel utilisateur

Olympus

Olympus DIGITAL VOICE RECORDER WS-200S Instructions de montage