Philips HP4648/37 Manuel utilisateur

SalonStraight ION

HP4648

ENGLISH 6

 13

 20

 26

 33

 39

 46

 54

 61

 67

 74

 81

 89

 96

 102

 108

Introduction

This new Philips SalonStraight ION straightener provides ultra-fast and

super-smooth straightening results.The ioniser generates streams of ions

which surround and condition your hair. Ions reduce frizz and static

electricity and leave your hair looking soft, smooth and shiny.The

adjustable temperature enables you to personalise the straightener to

obtain optimal results for your hair.

General description (Fig. 1)

APilot light

green: selected temperature has been reached

red: selected temperature has not yet been reached

BDisplay: shows the selected temperature and the usage time

CSelected temperature

DUsage time

E+ button to increase the temperature

F- button to decrease the temperature

GOn/off button

HHanging loop

IClosing lock

JIon output holes

KCeramic-coated plates

LRubber strips

Important

Read these instructions for use carefully before using the appliance and

save them for future reference.

Check if the voltage indicated on the appliance corresponds to the

local mains voltage before you connect the appliance.

Check the condition of the mains cord regularly. Do not use the

appliance if the plug, the cord or the appliance itself is damaged.

If the mains cord is damaged, it must be replaced by Philips, a

service centre authorised by Philips or similarly qualied persons in

order to avoid a hazard.

ENGLISH

Keep this appliance away from water! Do not use this product near

or over water contained in baths, washbasins, sinks etc.When used

in a bathroom, unplug the appliance after use since the proximity of

water presents a risk, even when the appliance is switched off.

For additional protection, we advise you to install a residual current

device (RCD) with a rated residual operating current not

exceeding 30mA in the electrical circuit supplying the bathroom.

Ask your installer for advice.

Keep the appliance out of the reach of children.

Only use the appliance on dry or damp hair.

The plates and the surrounding plastic parts of this appliance will

become hot during use! Prevent contact with the skin.

For safety reasons, the straightener automatically switches off after

having been on for 1 hour.

Always unplug the appliance after use.

Do not wind the mains cord round the appliance.

Wait until the appliance has cooled down before storing it.

Keep the straightening plates clean and free of dust, dirt, styling

spray and gel. Never use the appliance in combination with styling

mousse, styling spray, gel etc.

Always return the appliance to a service centre authorised by

Philips for examination or repair. Do not attempt to repair the

appliance yourself, otherwise your guarantee will become invalid.

When using this appliance you may notice a characteristic smell.

This is caused by the ions that are generated and it is not harmful

to the human body.

The plates have a ceramic coating.This coating will wear in the

course of time.When this happens, the appliance will still function

normally.

Do not probe the ioniser with metal objects.

Styling your hair

Step 1: washing your hair

Everybody wants shiny and beautiful hair. A good hair-washing routine can

help to achieve this.

ENGLISH 7

When washing your hair, wet your hair thoroughly for 30-60

seconds.

Pour some shampoo into the palm of your hand. Spread it between

your hands and distribute it evenly through the hair.

Gently massage your hair and scalp. Do not rough up the hair or

pull long hair up onto the scalp, as this may cause tangles.

Massage your scalp with your ngertips. This stimulates blood

circulation and is gentler to the hair cuticles.

Rinse your hair thoroughly, as poor rinsing can result in dull hair.

Finish with a cold rinse for extra shine.

Step 2: drying your hair

To get super-smooth results, it is essential to prepare your hair for

straightening. Dry you hair properly with a hairdryer to ensure a

professional, smooth nish.

After washing, squeeze excess water out of the hair with your

hands and then towel-dry the hair. Use a comb to disentangle hair

gently from the roots to the tips.

Divide the hair into sections by means of clips, starting at the back.

Dry each section by pulling a straightening brush down the hair

length while following the brush with the hairdryer, with its nozzle

pointing towards the hair ends.

When you have nished drying each section, set the hairdryer to

the cold setting for a nal cold shot. This closes the cuticles and

leaves your hair glossier.

Note:Tip: Philips Protect hairdryers have a lower drying temperature and a

stronger airow than regular dryers. Thanks to this combination, they dry just

as quickly as regular hairdryers but in a gentler way.

Step 3: straightening your hair

Straighteners are powerful styling tools and should always be used with

care.

If you use the straightener incorrectly or if you use it at the wrong

temperature, you could overdry your hair or even burn it.Always

follow the four steps below to select the right temperature for you

hair type! (Fig. 2)

ENGLISH8

Always select a low heat setting when you start using the straightener

for the rst time.

For coarse, curly or hard-to-straighten hair, selected a medium

(120 cC) to high heat setting (160 cC).

For ne, medium-textured or soft waved hair, select a medium

(120 cC) to low heat setting (100 cC)

Take extra care with pale, blonde, bleached or colour-treated hair,

since it will be susceptible to damage at high temperatures.

The display shows the selected temperature and the remaining

time of the straightening session.

Look at the display to see the temperature you have selected.

The bars on the display show the remaining usage time of the

straightener.The total usage time is 60 minutes. Every ten minutes

one of the six bars will disappear.

1 Insert the plug into the wall socket.

2 Press the on/off button.

The pilot light burns red to indicate that the straightener is heating up.

Ions are generated as soon as the straightener is switched on and are

released through the ion output holes.

3 Let the appliance heat up.The default heat setting is 100 °C.

Never leave the appliance unattended when it is plugged in. Never put

the appliance on a surface that is not heat-resistant when it is heating

up and when it is hot.

4 When the pilot light turns green the default temperature of 100 cC

has been reached.When the appliance has reached this

temperature, you can adjust the temperature to your preference.

(Fig. 2)

Press the + button to increase the temperature or press the - button

to decrease the temperature.The display tells you which temperature

you have selected.The pilot light turns red to indicate that the

appliance is adjusting the temperature.

The pilot light turns green when the selected temperature has been

reached.

ENGLISH 9

5 Comb or brush your hair so that it is disentangled and smooth.

(Fig. 3)

Use a comb to divide the hair into sections. Do not put too much hair in

one section.

Note: it is better to section off the crown area and to straighten the hair

underneath rst. Then straighten the top area.

6 Take a section that is not wider than 5 cm. Place it between the

straightening plates and press the handles of the appliance rmly

together.

7 Slide the straightener down the length of the hair in 5 seconds,

from root to hair end, without stopping to prevent overheating.

(Fig. 4)

8 Repeat this process after 20 seconds until you have achieved the

desired look.

9 Allow your hair to cool down. Do not comb or brush it before it

has cooled down, as this would ruin the hairstyle you have just

created.

Reducing frizz and static electricity

The ioniser inside the hairstyler generates streams of ions that surround

and condition your hair. Ions reduce frizz and static electricity and leave

your hair looking soft, smooth and shiny.

The ioniser starts working as soon as the appliance is switched on.

Cleaning

1 Make sure the appliance is switched off and unplugged.

2 Let the appliance cool down completely on a heat-resistant surface.

3 Clean the appliance with a damp cloth.

ENGLISH10

Ce manuel convient aux modèles suivants

Table des matières

Langues :

Autres manuels Philips Fer à coiffer

Philips

Philips Essence 5000 Series Manuel utilisateur

Philips

Philips HP4648/27 ProCeramic Breeze Manuel utilisateur

Philips

Philips HP8346 Manuel utilisateur

Philips

Philips TRESemme HP4668/27 Manuel utilisateur

Philips

Philips HP4681 Manuel utilisateur

Philips

Philips SALONSTRAIGHT ION HP4648 Manuel utilisateur

Philips

Philips HP8341 Manuel utilisateur

Philips

Philips HP4661 Manuel utilisateur

Philips

Philips SalonStraight Seduce HP4668 Manuel utilisateur

Philips

Philips HP4686/22 Manuel utilisateur

Philips

Philips HP8383 Manuel utilisateur

Philips

Philips SalonStraight Want2Move HP4646 Manuel utilisateur

Philips

Philips HP8361/07 Manuel utilisateur

Philips

Philips HP8325 Manuel utilisateur

Philips

Philips SalonStraight Pro XL HP4667/00 Manuel utilisateur

Philips

Philips HPS950 Manuel utilisateur

Philips

Philips HP8302 Manuel utilisateur

Philips

Philips HP8600/00 Manuel utilisateur

Philips

Philips Duometricks straight HP4645/01 Manuel utilisateur

Philips

Philips HP8363 Manuel utilisateur

Philips

Philips HP4667 Manuel utilisateur

Philips

Philips HP4667/05 Manuel utilisateur

Philips

Philips HP8343 Manuel utilisateur

Philips

Philips SalonStraight ProProtect 230 Manuel utilisateur

Manuels Fer à coiffer populaires d'autres marques

Vitek

Vitek VT-2505 Manuel utilisateur

Morphy Richards

Morphy Richards IB22063 Fiche d'information produit

TZS First AUSTRIA

TZS First AUSTRIA Ida FA-5670-3 Manuel utilisateur

izzy

izzy LN-112 Manuel utilisateur

Vitek

Vitek VT-2310 Manuel utilisateur

Okoia

Okoia HS23 Manuel utilisateur

Arzum

Arzum TRENDCARE AR 5042 Manuel utilisateur

SOLAC

SOLAC PP7251 Manuel utilisateur

VS Sassoon

VS Sassoon VSLE330A Manuel utilisateur

Vitek

Vitek VT-8291 Manuel utilisateur

VS Sassoon

VS Sassoon miniPRO Wave Envy Manuel utilisateur

Arzum

Arzum SUPERSTAR TOUCH Manuel utilisateur

Remington

Remington S2880ZBA Manuel utilisateur

cecotec

cecotec Bamba RitualCare 900 Wet&Dry Max Manuel utilisateur

Andis

Andis Gold CSI-1E Manuel utilisateur

Jata

Jata Marco Aldany JBPP5570 Mode d’emploi

Koenic

Koenic KHC 502 P Manuel utilisateur

hairway

hairway 04104 Manuel utilisateur