Philips GC2006/02 Manuel utilisateur

Read manual before use

Mistral

GC2030, GC2025, GC2020, GC2016, GC2015,

GC2010, GC2006, GC2005

ENGLISH 6

BAHASA MELAYU 15

INDONESIA 24

TI”NG VI◊T 33

 42

GC2030, GC2025, GC2020, GC2016, GC2015, GC2010, GC2006, GC2005

General description

ASpray nozzle

BFilling opening

CSteam-boost button 9

DSpray button T

ESteam control

O= no steam

q= minimum steam

w= maximum steam

1= Calc-Clean function

FExtra-steam function

GAutomatic shut-off light (GC2030 only)

HTemperature dial

ITemperature light

JMains cord

KType plate

LSoleplate

MWater tank

Important

Read these instructions for use carefully before using the appliance and

save them for future reference.

◗Check if the voltage indicated on the type plate corresponds to

the local mains voltage before you connect the appliance.

◗If the appliance is provided with an earthed plug, it must be

plugged into an earthed wall socket.

◗Do not use the appliance if the plug, the cord or the appliance

itself shows visible damage, or if the appliance has been dropped

or is leaking.

◗Check the cord regularly for possible damage.

◗If the mains cord is damaged, it must be replaced by Philips, a

service centre authorised by Philips or similarly qualified persons

in order to avoid a hazard.

◗Never leave the appliance unattended when it is connected to the

mains.

◗Never immerse the iron and the stand, if provided, in water.

◗Keep the appliance out of the reach of children.

◗Young children should be supervised to ensure that they do not

play with the appliance.

◗This appliance is not intended for use by young children or infirm

persons without supervision.

◗The soleplate of the iron can become extremely hot and may

cause burns if touched.

◗Do not allow the cord to come into contact with the soleplate

when it is hot.

◗When you have finished ironing, when you clean the appliance,

when you fill or empty the water tank and also when you leave

ENGLISH6

the iron even for a short while: set the steam control to position

O, put the iron on its heel and remove the mains plug from the

wall socket.

◗Always place and use the iron and the stand, if provided, on a

stable, level and horizontal surface.

◗Do not put perfume, vinegar, starch, descaling agents, ironing aids

or other chemicals in the water tank.

◗This appliance is intended for household use only.

Before first use

1Remove any sticker or protective foil from the soleplate.Also

remove the storage cover, if provided.

2Let the iron heat up to maximum temperature and pass the

iron over a piece of damp cloth for several minutes to remove

any residues from the soleplate.

The iron may give off some smoke when you use it for the first time.

This will cease after a short while.

Preparing for use

Filling the water tank

1Remove the mains plug from the wall socket.

C2Set the steam control to position O (= no steam).

C3Tilt the iron and fill the water tank up to maximum level.

Do not fill the water tank beyond the MAX indication.

If the tap water in your area is very hard, we advise you to use distilled

water.

ENGLISH 7

Setting the temperature

C1Put the iron on its heel and set the required ironing

temperature by turning the temperature dial to the

appropriate position.

- Check the laundry care label for the required ironing temperature.

-1Synthetic fabrics (e.g. acrylic, viscose, polyamide, polyester)

-1Silk

-2Wool

-3Cotton, linen

- If you do not know what kind or kinds of fabric an article is made of,

determine the right ironing temperature by ironing a part that will

not be visible when you wear or use the article.

- Silk, woollen and synthetic materials: iron the reverse side of the

fabric to prevent shiny patches. Avoid using the spray function to

prevent stains.

- Start ironing the articles that require the lowest ironing temperature,

such as those made of synthetic fibres.

2Put the mains plug in an earthed wall socket.

3When the temperature light has gone out, wait a while before

you start ironing.

BThe temperature light will go on from time to time during ironing.

Automatic shut-off (GC2030 only):

If the automatic shut-off function has been activated (automatic shut-

off light blinks), move the iron slightly to deactivate it.The automatic

shut-off light goes out.

Using the appliance

Steam ironing

◗Make sure that there is enough water in the water tank.

1Select the recommended ironing temperature (see chapter

'Preparing for use').

C2Select the appropriate steam setting. Make sure that the steam

setting you select is suitable for the ironing temperature

selected:

-qfor minimum steam (temperature settings 2to 3)

-wfor maximum steam (temperature settings 3to MAX)

BThe iron will start steaming as soon as the set temperature has been

reached.

ENGLISH8

◗GC2016/2015/2010/2006/2005: water may leak from the soleplate

if the set ironing temperature is too low (MIN to 2).

Ironing without steam

1Set the steam control to position O ( = no steam).

2Select the recommended ironing temperature (See chapter

'Preparing for use').

Features

Spray function

You can use the spray function to remove stubborn creases at any

temperature.

Make sure that there is enough water in the water tank.

C1Press the spray button a number of times to moisten the

article to be ironed.

Extra steam (GC2020/2006/2005 only)

This function provides extra stream to remove very stubborn creases.

The extra-steam function can only be used at temperature settings

between 3and MAX.

C1Set the steam control to the extra-steam position w.

C2Press and hold the steam control for max. 5 seconds.

3Wait at least 1 minute before you use the extra-steam function

again to prevent water from dripping out of the soleplate.

Steam boost (GC2030/2025/2016/2015/2010 only)

A powerful steam boost helps to remove very stubborn creases.

The steam-boost function can only be used at temperature settings

between 2and MAX.

ENGLISH 9

C1Press and release the steam-boost button.

Vertical steam boost (GC2030/2025/2016/2015 only)

C1The steam-boost function can also be used when you hold the

iron in vertical position.

Never direct the steam at people.

Drip stop (GC2030/2025/2020 only)

This iron is equipped with a drip-stop function: the iron automatically

stops producing steam when the temperature is too low, to prevent

water from dripping out of the soleplate.When this happens you will

hear a click.

Automatic shut-off (GC2030 only)

C◗The electronic shut-off function automatically switches off the

iron if it has not been moved for a while.

◗The red auto-off light starts blinking to indicate that the iron has

been switched off by the automatic shut-off function.

To let the iron heat up again:

1Pick up the iron or move it slightly.

2The red auto-off light goes out. If the temperature of the

soleplate has dropped below the set ironing temperature, the

temperature light goes on.

3If the temperature light goes on after you move the iron, wait

for it to go out before you start ironing.

ENGLISH10

Ce manuel convient aux modèles suivants

Table des matières

Langues :

Autres manuels Philips Fer

Philips

Philips DST5010/10 Manuel utilisateur

Philips

Philips GC3581 Manuel utilisateur

Philips

Philips Azur Pro GC4800 Series Manuel utilisateur

Philips

Philips GC6026/03 Manuel utilisateur

Philips

Philips GC4800 series Manuel utilisateur

Philips

Philips GC650 SERIES Manuel utilisateur

Philips

Philips EasyCare GC3230 Manuel utilisateur

Philips

Philips Elance GC3106 Manuel utilisateur

Philips

Philips PerfectCare Aqua GC8600 Series Manuel utilisateur

Philips

Philips GC140 Series Manuel utilisateur

Philips

Philips GC9655 Manuel utilisateur

Philips

Philips GC9400 SERIES Manuel utilisateur

Philips

Philips GC2652 Manuel utilisateur

Philips

Philips GC9315/30 Manuel utilisateur

Philips

Philips PerfectCare Expert GC9200 Series Manuel utilisateur

Philips

Philips GC9550 Manuel utilisateur

Philips

Philips GC8721/30 Manuel utilisateur

Philips

Philips GC6540/02 Manuel utilisateur

Philips

Philips GC4529 Manuel utilisateur

Philips

Philips Azur GC4560 Series Manuel utilisateur

Philips

Philips ComfortCare GC8500 series Manuel utilisateur

Philips

Philips GC4900 Manuel utilisateur

Philips

Philips GC6420/27 Manuel utilisateur

Philips

Philips GC8460 Manuel utilisateur

Manuels Fer populaires d'autres marques

Clatronic

Clatronic DB 3703 Manuel utilisateur

TEFAL

TEFAL FV4093Z0 Manuel utilisateur

Gorenje

Gorenje SIH 2200 BS Manuel utilisateur

Bosch

Bosch 2 Series Manuel utilisateur

Riffel

Riffel Catena KB-819 Manuel utilisateur

Texi

Texi Hestia Manuel utilisateur

Maxwell

Maxwell MW-3010 Manuel utilisateur

TREVIDEA

TREVIDEA Girmi ST60 Manuel utilisateur

Primula

Primula Vapormat Manuel utilisateur

Magio

Magio MG-541 Manuel utilisateur

Scarlett

Scarlett SC-1334S Manuel utilisateur

Bosch

Bosch Sensixx B22L Manuel utilisateur

Vitek

Vitek VT-1247 VT Manuel utilisateur

Cleanmaxx

Cleanmaxx 3397 Manuel utilisateur

dyras

dyras ESI-2400AC Manuel utilisateur

GE 169061 Manuel utilisateur

Gorenje

Gorenje SIH 2200 GC Manuel utilisateur

AEG

AEG DBS 5591 Manuel utilisateur