Phasx S600B Manuel utilisateur
1
Phasx S600B Operations & Technical
Manual Version 1.1 August 11, 2016
2
1. MPORTANT Safety nformation and nstructions
Read the following safety instructions and operations manual before setting up
and using your S600B speakers!
Keep this manual for future reference.
Heed all the warnings and follow the instructions.
1.1. Listening Level Warning
• The S600B speakers are capable of producing very high
SPL levels!
• Permanent hearing damage may occur if exposed to high SPL
levels for a prolonged and or multiple periods of time.
• Extended periods of high SPL listening may allow mistakes in your mixes or
reduce your critical listening ability as your hearing tends to adapt and become
less sensitive over time allowing the missing of important and subtle sounds or
instrument layering in the mix
• Please use safe listening levels when playing back your music material.
1.2. mportant Enclosure Notice / Warning
Do not remove any back cover plate screws or open any part of the
S600B Speaker.
Hazardous Voltages exist inside the enclosure and a potential of severe
or fatal electrical shock!
The S600B Speaker has no user serviceable parts inside. Tampered
Seals Void All Warrantees.
To reduce the risk of failure, fire, or
electrical shock, do not expose the S 00B Speaker to rain, moisture,
high humidity, or use near water or other liquids.
The S 00B Speaker must not be exposed to dripping, splashing, or
spills of liquids.
Do not use in dusty environments as particles could enter
the enclosure or collect on the speaker diaphragms.
Refer all service to a Phasx Authorized Service Center Only
Servicing is required when the S 00B has been damaged
in any way, does not operate normally that cannot be solved with
technical support, has been dropped, or exposed to liquids that have
entered the speaker back panel or speakers.
3
1.3. Mains AC Power Connection
The S600B should only be operated when connected to an appropriate
AC mains power source and appropriate type of 3 pin connection that
provides a protective Earth ground connection. This includes any
extension cords or power distribution strips. Appropriate power cords
are supplied with each S600B Speaker.
Do not defeat the safety purpose of any 3 pin grounding
type AC mains power supply plug on the S 00B power cable or any
power distribution connection.
The S 00B can operate on 120VAC @ 0Hz or 220/240VAC @ 50Hz.
To completely disconnect from AC mains, disconnect the S 00B
Speaker AC power cord from the AC mains supply receptacle or the
back of the Speaker.
The S 00B Speaker should be installed using the shortest practical
wiring and disconnection of the device should be easily accessible.
Power-Cord Protection
Power-supply cords should be routed so that they are
not likely to be walked on or pinched by items placed upon or against
them.
Particular attention should be given to cords at plugs,
power strip receptacles, and power entry connector of the S 00B
Speaker.
Power Line Surges and Lightning
As with all sensitive electronic equipment, it is suggested
to use AC Main Power sources that have surge protection.
For additional protection during a lightning storm, or
when left unattended and unused for long periods of time, unplug it
from the AC Mains Power source.
Mains Power Source Overloading
Do not overload wall outlets, extension cords, or integral
convenience receptacles as this can result in a risk of fire or electric
shock.
4
1.4
General Cable Connection
Before making connections to S 00B Speaker, ensure that the power
switch is off and connecting components are in mute or stand-by mode.
Make sure all cables and connectors are of the highest
quality, and fully checked. Defective cables can harm your speakers.
They are a common source of noise, hum, crackling etc.
Always be careful when making connections which may
have hazardous voltages on them during operation.
Always switch off your entire system before connecting or
disconnecting any cables, or when cleaning any components.
1.5 Placement
The S 00B Speaker will get warm to the touch on its
back panel and has ventilation slots that must be left clear to allow air
flow for cooling. Do not place the speaker closer than inches to a rear
surface or wall to assure air flow.
Do not place the S 00B near high heat generating sources such as
radiant heaters, radiators, open flames, candles, or other devices that
generate high heat or flames.
Do not place flammable material behind, above, or
beneath the S 00B.
Never operate this product in an explosive atmosphere.
The S 00B is heavy and must be placed on a firm, level surface.
Do not place the speaker on an unstable cart, stand,
bracket, or table. The speaker may fall, causing serious injury and or
serious damage.
o When a cart or stand is used, use caution when
moving both together.
o Using Isolation dampers under the speaker to help decouple the
speaker cabinet from the stand that will help dampen vibration
noise and other objects which could fall.
Do not block the woofer port at the front bottom of the speaker.
5
1.6 Cleaning
Clean only with soft cotton dry cloth.
Never use liquid cleaners, aerosol cleaners, or
flammable / combustible chemicals for cleaning.
Avoid touching the speaker diaphragms.
Do not use a vacuum cleaner or high pressure air source on the
speaker diaphragms as damage may or will occur.
2.7
Magnetic Considerations:
S 00B Speakers have 3 drivers; woofer, mid-range, and
high frequency.
Please keep magnetically sensitive items at least 0.5 m
away from the speaker.
2.8 Caution
This device complies with Part 15 of the FCC Rules / Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
6
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
7
—Consult the dealer or an experienced radio/TV technician for help.
To satisfy FCC / IC RF exposure requirements, a separation distan e of 20 m or
more should be maintained between the antenna of this devi e and persons during
devi e operation.
To ensure omplian e, operations at loser than this distan e is not re ommended.
Les antennes installées doivent être situées de facon à ce que la population ne puisse
y être exposée à une distance de moin de 20 cm. Installer les antennes de facon à ce
que le personnel ne puisse approcher à 20 cm ou moins de la position centrale de l’
antenne.
La F des éltats-unis stipule que cet appareil doit être en tout temps éloigné d’au
moins 20 cm des personnes pendant son functionnement.
8
Table of Contents
1. Declarations of Approvals and Conformities ______________________________ page 2
2. Important Safety Information and Instructions _____________________________ page 3-
3. Introduction
4. Unpacking and what’s included in the Shipping Box
4.1. Unpacking instructions
4.2. Check list
4.3. Saving Shipping Box
5.
5a. Understanding the S 00B
Features Overview>>>>>>>>>>>>>>>>>>>>>>>>>. Pg. 7
Acoustic Pinpoint >>>>>>>>>>>>>>>>>>>>>>>>>>. Pg. 8
Rear View >>>>>>>>>>>>>>>>>>>>>>>>>>>>>. Pg. 9
Rear Panel Details >>>>>>>>>>>>>>>>>>>>>>>>>. Pg. 9
Tweeter adjustment >>>>>>>>>>>>>>>>>>>>>>>>> Pg. 9, 10
5b. Connecting the Speakers >>>>>>>>>>>>>>>>>>>>>>>. Pg. 9
. Speaker placement>>>>>>>>>>>>>>>>>>>>>>>>>>>>. Pg. 10
7. Controlling the S 00B
Stand Alone with no Controller >>>>>>>>>>>>>>>>>>>>. Pg. 12
Stand Alone with Bluetooth>>>>>>>>>>>>>>>>>>>>>... Pg. 13
8. Troubleshooting>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>. Pg. 23
f contents
3. ntroduction
To You, our newest Partner:
Thank you for choosing the Phasx S 00 Desktop Monitor System. We are very proud to
have created, in our humble opinion, one of the most advanced Desktop Monitors in the
9
world, and prouder still that you have chosen to agree with us and give our technologies a
try.
The Phasx team’s mission and ambition is to create a line of Best in Class “Mastering
Worthy” Audio Monitors that
Empower
Media Arts Professionals in ways never before
possible,
Excel
in every benchmark of performance and of sound quality, and
Exceed
user
expectations on every front.
The S 00B, our first product in this new line, has taken over eight years to develop, and
called on the skills, efforts, and inputs of dozens of Acoustics, DSP, and Recording
Engineering Professionals.
.
We hope that you will agree with us that the result was worth the wait!
Sincerely,
The Phasx Team
To receive important information and updates, as becomes available, please take a
moment to register your S 00B Monitor speakers. Go to
www.phasx.com/S600B/Register
FEATURES OVERV EW: 1) The Basics:
10
2) THE ShadoCaster
TM
ACOUST C Cabinet Construction:
The Patented
ShadoCaster
TM
system allows the small space over a desktop (or similar
size area) to behave as if it were a part of an acoustically corrected soffit-mount speaker
control room playback system, even though it is operating in a more or less standard
domestic room.
The effect is to deliver astonishing sound staging and even accurate elevation effect
reproduction, something that is nearly impossible in an acoustically untreated room.
You have to hear it to believe it --- and now you are about to!
3
) THE PHASX ACOUSTIC PINPOINTTM
(Possibly the Simplest Speaker Positioning System Ever Patented)
Panned too far Right
OK!
Panned too far Left
Table des matières
Manuels Intervenants populaires d'autres marques
Bowers & Wilkins
Bowers & Wilkins 4 Manuel utilisateur
Sonance
Sonance SONOS OUTDOOR Series Manuel utilisateur
Electro-Voice
Electro-Voice EVID FM4.2 Manuel utilisateur
Pioneer
Pioneer XW-HTD630 Manuel utilisateur
Onn
Onn BWA16AA002 Manuel utilisateur
HP
HP GL313AA - USB Speakers PC Multimedia Manuel utilisateur