Pet Stop PowerWizard Manuel utilisateur
Owner’s Manual
PowerWizard
®
Emergency Power Supply
Congratulations on your purchase of the Pet Stop® PowerWizard™ battery back-up
system. When used with the Pet Stop transmitter, it will provide a safe and secure alter-
native power source should your transmitter sustain a loss of electricity for a period of
time. It is designed to be used to charge a lead acid battery that was supplied by your
authorized Pet Stop Dealer. The amount of time the unit can keep a transmitter running
depends on the size of the battery used with the system.
Introduction
2
CAUTION:
DO NOT use this product with any battery other than a 12 volt
acid battery.
DO NOT allow a metallic object to contact both battery terminals
at the same time. Doing so can present a fire hazard.
A.
Small jack (denoted J1) located
on the bottom left of the circuit
board. This is where the 12VAC
wall adapter is connected.
B.
The power cord connects to
the transmitter. This connec-
tion takes the place of a wall
transformer connecting to the
transmitter.
C.
The final connection point is a
terminal block in the bottom
right of the board. This is where
the battery will be connected.
Connection Identification
Connecting the battery:
1. Place the red wire under the far left screw (denoted with a “+”) and tighten.
2. Place the black wire under the far right screw (denoted with a “-”) and tighten.
3. There is no connection to the center screw.
4 Connection the red wire to the battery terminal (denoted with a “+”)
5. Connect the black wire to the battery terminal (denoted with a “-”)
These connections are made by pressing the crimped terminals onto the
battery terminals
Instructions
3
PRECAUTION:
It is important that the battery connections be made correctly. Crossing
the polarities (connecting battery “+” to battery back-up “-”) will cause
the fuse on the battery back-up unit to blow.
The fuse is to protect the unit from incorrect installation. If you acciden-
tally connect the battery incorrectly, you will need to replacve the fuse
after making all the correct connections
IMPORTANT
The PowerWizard battery back-up must operate from a 12VAC wall trans-
former. A 12VDC wall trasformer will not charge the battery!
1. Plug the wall transformer into the jack (J1) on the lower left side of the
PowerWizard board.
2. Plug the PowerWizard battery back-up cord into the Pet Stop transmitter. The
transmitter will now have power.
Connecting the Transformer
Our products are covered by U.S. Patent Numbers: 5,460,124 - 5,682,839 - 6,296,776.
Pet Stop, Comfort Contacts, Flash Alert, Safety Stop, Pet Fence Systems, The Best
Fence You’ll Never See, TriScann, Zapp Alert, UltraElite Receiver, Ultramax Receiver,
PowerWizard, RoomWizard and The Dog Fence People are registered trademarks of
Perimeter Technologies, Inc.
13010002 REV A. powerwizard emanual_610
Perimeter Technologies, Inc - Morgantown, PA 19543
©2008 Perimeter Technologies, Inc. All Rights reserved.
www.petstop.com
Table des matières
Autres manuels Pet Stop Alimentation
