peerless-AV SS560G Mode d’emploi
Installation and Assembly: Display Stand for 32" - 65"
Flat Panel Displays
Models: SS560G
ISSUED: 02-25-11 SHEET #: 009-9051-2 09-14-11
2300 White Oak Circle • Aurora, Il 60502 • (800) 865-2112 • Fax: (800) 359-6500 • www.peerlessmounts.com
Max UL Load Capacity:
150 lb (68 kg) display
50 lb (22.7 kg) per shelf
2 of 41 ISSUED: 02-25-11 SHEET #: 009-9051-2 09-14-11
NOTE: Read entire instruction sheet before you start installation and assembly.
Table of Contents
Parts List............................................................................................................................................................................ 3, 4
Assembling Cart .....................................................................................................................................................................5
Attaching Universal Adapter Plate or Dedicated Adapter Plate........................................................................................... 10
Installing Adapter Brackets ..................................................................................................................................................11
Cord Management............................................................................................................................................................... 13
Tools Needed for Assembly
• level
• phillips screwdriver
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings
contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, for US
customers please call Peerless customer care at 1-800-865-2112, for all international customers, please contact
your local distributor.
• This product should only be installed by someone of good mechanical aptitude, and fully understands
these instructions.
• Never exceed the Maximum UL Load Capacity on page 1.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power.
• The stand is not affixed or secured to the floor, and may therefore tip over and/or fall if display and/or stand is
shaken or hit. Always monitor children and do not let children play alone around stand as they could get hurt by a
falling display. Not recommended for use in areas with heavy traffic.
• This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal
injury.
WARNING
3 of 41 ISSUED: 02-25-11 SHEET #: 009-9051-2 09-14-11
Before you begin, make sure all parts shown are included with your product.
Parts may appear slightly different than illustrated.
Description Qty. Part Numbe
r
A
screen mount bracket 1 201-1156
Bhook plate 1 201-1157
Cshelf support 1 201-1158
Dshelf clamp bracket 1 201-1159
Ebase 1 009-1223
Funiversal plate 1 201-1110
Gadapter bracket 2 201-1510
Hupright 1 580-1180
Iglass shelf 1 590-1208
Jtop cover 1 590-1210
Kbutton bumper 9 590-1209
L1/4-20 x 12 mm decorative screw 14 520-2325
M1/4-20 nut 12 530-1022
O3/8-16 x 2.5" socket screw 3 520-9550
P7/32" allen wrench 1 560-9715
Q4 mm allen wrench 1 560-9646
R6 mm allen wrench 1 560-9716
Sleft leg 1 009-1287
Tright leg 1 009-1288
U
ft
4
600 1025
Parts List
Ufoot 4 600-1025
Wjoint connector nut 4 530-1037
X
3/8-16 x 1.5" bolt 4 520-1329
Y
M10 x .402 ID washer 3 540-9424
A
A
1/4-20 x 20 mm screw 2 520-2326
BB 3/16" allen wrench 1 560-0071
CC M4 x 12 mm serrated washer head socket pin screw 6 510-1079
DD M4 x 25 mm serrated washer head socket pin screw 4 510-1082
EE M5 x 12 mm socket pin screw 4 520-1064
FF M5 x 25 mm socket pin screw 4 520-1122
GG M6 x 12 mm socket pin screw 4 520-1050
HH M6 x 25 mm socket pin screw 4 520-1211
II M8 x 15 mm socket pin screw 6 520-1068
JJ M8 x 40 mm socket pin screw 4 520-1152
KK 1/2" x 1/2" spacer 4 540-1057
LL 3/4" x 1/2"spacer 4 540-1059
MM multi washer 6 580-1036
NN M6 x 20 mm socket pin screw 4 520-9554
OO M6 x 30 mm socket pin screw 4 520-1067
PP M8 x 25 mm socket pin screw 4 520-1101
QQ M10 x 15 mm socket screw 4 520-9262
4 of 41 ISSUED: 02-25-11 SHEET #: 009-9051-2 09-14-11
R
Q
BB
H
E
ABC
W
J
Y
P
X
O
QQ
L M
Parts List continued D
K
I
AA
S
T
OO
II
Some parts may appear slightly different than illustrated.
CC DD EE JJFF HH
GG
MM
LL
KK NN PP G
F
U
5 of 41 ISSUED: 02-25-11 SHEET #: 009-9051-2 09-14-11
Insert right leg (T) into base housing (E) as shown in fig.1.1. Then line up holes of right leg with holes in bas
housing (E). Fasten base housing to right leg using two 3/8-16 x 1.5" bolts (X)and two joint connectors (W), tighten
using 3/16"allen wrench (BB) and 7/32"allen wrench (P) as shown in fig.1.2.
NOTE: Left and right legs can be identified by looking at the cart from the front.
Repeat for left side with left leg (S).
1
T
X
fig. 1.2
W
fig. 1.1
E
T
FRONT OF CART
FRONT OF LEG
Insert feet (U) into holes of support legs (S&T) and hand thread to secure.
S
U
T
2
6 of 41 ISSUED: 02-25-11 SHEET #: 009-9051-2 09-14-11
Attach upright (H) to base (E), as shown in fig 3.1 using three 3/8-16 x 2.5" socket screws (O) and M10 x .402ID
lock washers (Y). Tighten screws using 7/32" allen wrench (P).
NOTE: Be sure cord management holes are in the configuration shown in fig 3.2.
3
Loosely attach four 1/4-20 x 12 mm screws (L) and 1/4-20 nuts (M) to shelf support (C).
4
C
LM
fig. 3.2
CORD
MANAGEMENT
HOLES
O
E
H
Y
fig. 3.1
7 of 41 ISSUED: 02-25-11 SHEET #: 009-9051-2 09-14-11
SLOT
fig 5.1
C
Slide shelf support (C)onto upright (H) so that 1/4-20 nuts (M) slide into slots of upright (H) as shown in
figure 5.1 and detail 1. Slide shelf support to desired position, level, then tighten 1/4-20 x 12 mm screws (L)
using 4 mm allen wrench (Q).
NOTE: MAXIMUM OF TWO SHELVES
Max height of top shelf is 34" from base.
Max height of second shelf is 28" from base.
DETAIL 1
5
M
H
8 of 41 ISSUED: 02-25-11 SHEET #: 009-9051-2 09-14-11
Insert three button bumpers (K) into bottom of shelf clamp bracket (D).
Attach shelf clamp bracket (D) to shelf support (C) using two 1/4-20 x 20 mm screws (AA) and two
1/4-20 nuts (M).
For additional shelf installation, repeat steps 4 through 6.
Insert six button bumpers (K) into shelf support (C). Place glass shelf (I) on shelf support.
I
K
C
6
6-1
K
6A
6-2
Attaching Glass Shelf
D
C
AA
M
• Do not overtighten, may cause glass to shatter or
crack.
• This shelf is intended for use with equipment
weighing NO more than 50 lbs. (22.7 kg) that fits
evenly accross the surface of glass shelf (I). Use
with other equipment may result in instability and
cause personal injury or property damage.
WARNING
9 of 41 ISSUED: 02-25-11 SHEET #: 009-9051-2 09-14-11
Insert two 1/4-20 x 12 mm screws (L) into display
mount bracket (A), leaving 3/16" of exposed thread
as shown in figure 10.1 and detail 3.
J
H
Snap top cover (J) onto upright (H). 109
fig. 10.1
DETAIL 3
L
A
Loosely attach six 1/4-20 x 12 mm screws (L) and
1/4-20 nuts (M) to display mount bracket (A).
7Slide display mount bracket (A) onto upright (H) so
that 1/4-20 nuts (M) slide into slots of upright (H) as
shown in figure 8.1 and detail 2. Slide display mount
bracket to desired position, level, then tighten 1/4-
20 x 12 mm screws (L) using 4 mm allen wrench
(Q).
8
LA
MA
H
SLOT
fig. 8.1
L
DETAIL 2
M
H
3/16"
10 of 41 ISSUED: 02-25-11 SHEET #: 009-9051-2 09-14-11
Attach Universal Plate (F) or Dedicated Adapter
Plate to hook plate (B) using four M10 x 15 mm
socket screws (QQ). Tighten screws using 6 mm
allen wrench (R).
Attaching Universal Adapter Plate or Dedicated Adapter Plate
Attach hook plate (B) to display mount bracket (A).
L
LL
2° Backward Tilt 5° Forward TiltNo Tilt
Insert two 1/4-20 x 12 mm screws (L) into holes indicated below for desired display orientation. Tighten all screws
using 4 mm allen wrench (Q).
11 12
13
F
B
QQ
B
A
Table des matières
Langues :
Autres manuels peerless-AV Moniteur
peerless-AV
peerless-AV Smart City KOP2555-XHB Manuel utilisateur
peerless-AV
peerless-AV XHB554 Feuille d'instructions
peerless-AV
peerless-AV XTREME XHB432 Manuel utilisateur
peerless-AV
peerless-AV KIPC2549B-WHL Manuel utilisateur
peerless-AV
peerless-AV XTREME Manuel utilisateur
peerless-AV
peerless-AV XTREME XHB553 Manuel utilisateur
peerless-AV
peerless-AV XTREME XHB432-EUK Manuel utilisateur
peerless-AV
peerless-AV KIPC2555B-S-3 Manuel utilisateur
peerless-AV
peerless-AV XTREME XHB554-EUK Manuel utilisateur
peerless-AV
peerless-AV CL-4765 Manuel utilisateur
peerless-AV
peerless-AV KIPC2540 Manuel utilisateur
peerless-AV
peerless-AV CL-42PLC68-OB Manuel utilisateur
peerless-AV
peerless-AV XHB754 Feuille d'instructions
peerless-AV
peerless-AV KOF555-1 Manuel utilisateur
peerless-AV
peerless-AV XTREME XHB652 Manuel utilisateur
peerless-AV
peerless-AV Xtreme High Bright Manuel utilisateur
peerless-AV
peerless-AV CL-42PLC68-OB Manuel utilisateur
peerless-AV
peerless-AV KIPC2549S-S Manuel utilisateur
peerless-AV
peerless-AV KIPC2540-EUK Manuel utilisateur
peerless-AV
peerless-AV CL-49PLC68-OB Manuel utilisateur
