International pbi S.p.A Instruction Manual 29/08/05 Rev. 12
INSTRUCTION MANUAL
READ THIS BOOK CAREFULLY
It is intended to help you operate and maintain your new instrument properly.
Keep it handy for answers to your questions.
IMPORTANT SAFETY INSTRUCTIONS
When using this appliance, always exercise basic safety precautions, including the following:
•Use this appliance only for its intended purpose as described in this Use and Care book.
•This instrument must be properly installed in accordance with the Installation Instructions before it is used.
•Never unplug your instrument by pulling on the power cord.
•Always grip plug firmly and pull straight out from outlet.
•Repair or replace immediately all electric service cords that have become frayed or otherwise damaged. Do not
use cord that shows cracks or abrasion damage along its length or at either the plug or connector end.
•When moving your instrument away from wall, be careful not to roll over or damage the power cord.
•Unplug your instrument:
A. Before making any repair.
Note: We strongly recommend that any servicing be performed by a qualified individual.
B. Before cleaning.
C. Before replacing any accessories.
•Do not operate your instrument in the presence of explosive fumes.
When a standard two-prong wall outlet is encountered, it is your personal responsibility and obligation to have it
replaced with a properly grounded three-prong wall outlet.
Warning
Fire or electric shock hazard, do not expose this product to rain or moisture.
This unit contains dangerous voltages. NEVER remove cover unless qualified to do so
CAUTION DURING INSTALLATION
CAUTION
This unit must be grounded.
The power cord set provided is of the pattern often found in the market area, although
this is by no means universal, but many other patterns are used around the world.
If the plug is not compatible with the socket outlet available, it will be necessary to
obtain a suitable alternative cord set with the correct colour cables connection. The
mains lead coloured green-and yellow must be connected to the ground terminal on the
new plug which is marked with the letter or the earth symbol ⊥or coloured green-and-
yellow.
CAUTION
Before connecting the instrument to a power supply check that the voltage and
frequency details shown on the rear identification label are compatible with your main
supply.
N.B. The equipment must only be connected to a protectively grounded mains supply.
In the event of any uncertainty it is recommended that a qualified electrician be
consulted.
CAUTION
If using a maine supply without a protective earth. Before plugging in the unit, the
ground terminal close to the mains cable on the rear of the apparatus, must be connected
via a 2,5 mm2stranded wire to a safe earth. This work must be done by an authorised
electrician.
Prior to operation always ensure that the ventilation grids of the instrument are not
obstructed and that it is not positioned directly against a wall.
