78/
Rev 0 3 10./
CARE AND MAINTENANCE
WARNING:Before attempting to perform any maintenance on this unit turn all controls to,
the position and unplug A.""OFF
llow the unit to be for at""OFF
least 10 minutes before any
maintenance applied in order to allow all components to cool down properly.
Cleaning:
1 To remove dust fingerprints or other marks from glass window use clean damp cloth Do not., , .
spray glass cleaner or other liquids directly onto the glass.
2 Clean metal surfaces with a clean damp cloth making sure not to push dust or debris into any.
air intake or exhaust vents.
3 Do not use abrasive cleaners or spray liquids on any part of the appliance. .
4 Periodic cleaning vacuuming of the fan heater unit is strongly recommended to ensure that no./ /
dirt or foreign objects build up.
Replacing Remote Control Battery
If the remote controls stops functioning or operate poorly the battery should be replaced with new,
one model CR2025(# ).
1 The battery compartment can be found on the back side of the remote control. .
2 Press and slide the battery door to open and remove the old battery..
3 Insert a new CR2025 coin battery making sure that the polarity a atches properly as.,"+" "-"nd
illustration showing.
4 Close the battery door..
LEDBulbReplacement
Note: The flameeffect onthis electric fireplace is created by LED Bulbs.
The life of these LED bulbs will be 100,000 hours. The users are not recommended to
replace the LEDBulbs. For any reason should the bulbs stop working properly, contact a
qualifiedtechnician.
Warning:
Like with any remote control unit, the remote control unit included with your
fireplace may unwantedly affect or control other electric products such as TVs.
If this occurs, you can change the encryption on your fireplace remote so that it
will not affect other products. To change the settings on your fireplace remote,
hold down the Timer button on the fireplace remote for 3 seconds. To test, use
your fireplace remote and see if your other products are still affected. If so, you
may change your fireplace remote to a third encryption by again holding down
the Timer button on the remote for 3 seconds. To test this third encryption
setting, use your fireplace remote and see if your other products are still
affected. To get back to the original encryption setting, hold down the Timer
button on the fireplace remote for 3 seconds.
