Partner OT-100 Manuel utilisateur
OT-100
User Manual
i
Copyright
This publication, including all photographs, illustrations and software, is protected under international
copyright laws, with all rights reserved. Neither this manual, nor any of the material contained herein, may be
reproduced without written consent of PARTNER Tech Corp.
Disclaimer
The information in this document is subject to change without notice. The manufacturer makes no representa-
tions or warranties with respect to the contents hereof and specically disclaims any implied warranties of
merchantability or tness for any particular purpose. The manufacturer reserves the right to revise this publi-
cation and to make changes from time to time in the content hereof without obligation of the manufacturer to
notify any person of such revision or changes.
Trademark recognition
All product names used in this manual are the properties of their respective owners and are acknowledged.
Federal Communications Commission (FCC)
This equipment has been tested and found to comply with the limits for a Class Bdigital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment onto an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Shielded interconnect cables and a shielded AC power cable must be employed with this equipment to ensure
compliance with the pertinent RF emission limits governing this device. Changes or modications not ex-
pressly approved by the system’s manufacturer could void the user’s authority to operate the equipment.
Important Note
This device has been SAR-evaluated for use with Laptop/Notebook computers and meets the FCC RF exposure
guidelines for an uncontrolled environment. 0.255 W/kg.
Declaration of conformity
This device complies with part 15 of the FCC rules. Operation is subject to the following conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation.
ii
About this manual
This manual is intended for system administrators who are familiar with setting up a new system and install-
ing programs.
The manual consists of the following sections:
Chapter 1 Getting Started: This section covers unpacking and checking the
package contents, identifying components, charge the
battery, install the SD card and power it on..
Chapter 2 Learning The Basics: The chapter provides information how to use the basic
features.
Chapter 3 Using The Accessories: This section provides information how to use the
accessories.
Appendix: The appendix covers troubleshooting, information
on having the OT-100 serviced, and technical
specications.
Safety information
Before installing and using the OT-100, take note of the following precautions:
Request service for damaged products: Turn off the product, unplug it from the electrical outlet, and
request service from a service partner under the following conditions:
The power cord or plug is damaged.•
Liquid has been spilled into the product.•
An object has fallen into the product.•
The product has been exposed to rain or water.•
The product has been dropped or damaged.•
The product does not operate normally when you follow the operating instructions.•
Avoid hot areas: The product should be placed away from heat sources such as radiators, heat registers,
stoves, and other products (such as ampliers) that produce heat.
Allow the product to cool: Allow the product to cool before removing covers and touching internal compo-
nents.
Avoid wet areas: Never use the product in a wet location.
Avoid inserting objects into product: Never insert objects of any kind into slots or other openings in the
product.
Clean the product properly: Unplug the product from the wall outlet before cleaning it. Do not use liquid
cleaners or aerosol cleaners. Use a soft cloth dampened with water for cleaning exterior components, but
NEVER apply water directly to the product or to an LCD screen.
Use recommended mounting accessories: Do not use the product on an unstable table, cart, stand, tripod,
or bracket. Mount the product according to the manufacturer’s instructions, and use a mounting accessory
recommended by the manufacturer.
Use the product with approved equipment: Use your product only with the computers and accessories
identied as suitable for use with your product.
Adjust the volume: Turn down the volume before using headphones or other audio devices.
Revision history
Version 1.0, April 2009
iii
TABLE OF CONTENTS
CHAPTER 1 GETTING STARTED................................................ 1
Unpacking the OT-100 ..................................................................................1
Checking the package contents ....................................................................2
Identifying components .................................................................................4
Charge Cradle................................................................................................8
Setup the OT-100...........................................................................................9
Charging the OT-100 / battery in the cradle.................................................12
Battery Handling Precaution ....................................................................13
Using SD cards ............................................................................................14
Install a SD card...........................................................................................14
Viewing content of a SD card.......................................................................16
CHAPTER 2 LEARNING THE BASICS ...................................... 17
Entering text.................................................................................................17
Shortcut menus............................................................................................17
Performing a reset........................................................................................17
Opening and closing programs ....................................................................18
Program switch ............................................................................................18
Windows CE help.........................................................................................18
Adjusting the volume....................................................................................18
Changing the device name ..........................................................................20
Recalibrating the screen ..............................................................................23
Setting the date and time .............................................................................24
Install and remove programs........................................................................32
Upgrading OS Image or Bootloader.............................................................34
CHAPTER 3 USING THE ACCESSORIES ............................... 37
Using the leather pouch ...............................................................................37
Attaching the stylus cord..............................................................................38
Attaching the hand strap ..............................................................................39
Using the shoulder strap ..............................................................................40
APPENDIX .................................................................................. 41
Troubleshooting ...........................................................................................41
Tips for Troubleshooting...............................................................................41
General Problems .......................................................................................41
iv
Having the OT-100 Serviced .......................................................................42
Guidelines for care and maintenance ..........................................................43
Using the device ......................................................................................43
Cleaning the device .................................................................................43
Carrying or storing the device..................................................................43
Specications...............................................................................................44
1
CHAPTER 1
GETTING STARTED
This chapter describes the procedures from unpacking the OT-100, to powering it on. The following topics are
described.
Unpacking the OT-100 on page• 1
Checking the package contents on page• 2
Identifying components on page• 4
Charge Cradle on page• 8
Setup the OT-100 on page• 9
Charging the OT-100 / battery in the cradle on page 1• 2
Using SD cards on page 1• 4
Install a SD card on page 1• 4
Viewing content of a SD card on page 1• 6
Unpacking the OT-100
The device and accessories are packed in a cardboard carton with foam padding for protection during ship-
ping.
Figure 1.1 Unpacking the OT-100
Carefully unpack the machine and keep the packing materials. If you need to ship it in the future, repack it as
shown in Figure 1.1.
OT-100
Accessories
package
Cradle
Adapter
CD-ROM
2 CHAPTER 1 GETTING STARTED
Checking the package contents
After you unpack the device check that the following items are included.
OT-100 Stylus
Battery
High quality stylus
AC adapter
Cradle
need the
picture
3
If any item is missing or appears damaged, contact your dealer immediately.
Leather pouch Leather pouch cord Stylus cord
2 screws Plastic bit
Hand strap Shoulder strap
CD-ROM Quick start guide
mini-USB to USB cable
need the
picture need the
picture
need the
picture
need the
picture
need the
picture
QSG
4 CHAPTER 1 GETTING STARTED
Identifying components
This section describes the parts and connectors on the OT-100.
Front panel components
1
234
Figure 1.2 Front view
Component Description
1 4.3-inch touch screen
2Power indicator (Green: power on, Red: charging)
3Bluetooch indicator (Light: Bluetooth is functional)
4WiFi indicator (Light: WiFi is functional)
Autres manuels pour OT-100
1
Table des matières
Autres manuels Partner Comprimé
Partner
Partner OT-100 Manuel utilisateur
Partner
Partner EM-70 Manuel
Partner
Partner PAT-120 Manuel utilisateur
Partner
Partner EM-200 Manuel utilisateur
Partner
Partner EM-200 Manuel utilisateur
Partner
Partner ART101 Manuel utilisateur
Partner
Partner EM-100 Manuel utilisateur
Partner
Partner EM-70B Manuel utilisateur
Partner
Partner EM-220 Manuel utilisateur
