Panorama Antennas L[G]M[X] Series Manuel utilisateur

Installation Instruction – SW3-771

L[G]M[X] Series

Introduction

The L[G]M[X]-24-58 range has been designed to provide MiMo

dual band WiFi coverage in an ultra low proﬁle package. The

compact, robust low-proﬁle housing contains up to four antenna

elements with effective isolation and low correlation covering

2.4-2.5/4.9-6GHz.

The antenna is designed to be panel mounted on vehicles or

devices and can be ﬁtted on a conductive or non- conductive

panel. Supplied with integral ﬂame retardant CS32 cables

(Compliant to UNECE 118.01 and EN45545-2) and a halogen

free ﬂame retardant radome, the antenna is suitable for many

environments and applications.

The LGM variants have an integrated GPS/GNSS module with

26dB LNA gain.

SW3-771 - Document Version 1.0

Electrical Safety Note

Versions of this product contains an active GPS antenna (part number SR8-HG26). Rated volt-

age: 3-5VDC Rated current: 20mA maximum

The supply to this device must be provided with overcurrent protection of 1A

maximum.

Mounting requirements and selecting location

This antenna range can be deployed with or without a conductive ground plane.

Ensure that there is adequate under panel clearance and that there is no double skin panel or cross brace

present. Measure to check for central position if applicable. For optimal performance the antenna should, if

possible, be mounted at least 300mm (1ft) away from other conductive objects on the mounting panel.

Prepare and drill hole

Mask panel area around hole position to protect paintwork and headliner.

Drill a pilot hole, and then increase to 19mm (3/4”), ensuring that drill/cutter

bit does not contact headliner. Clean area around the hole, carefully removing

all swarf. Do not mount to a hole larger than 19mm diameter.

If mounting to a conductive ground plane remove paint and primer from under

panel surface to ensure adequate earth contact by washer and nut. Apply

some petroleum jelly or paint around the hole to prevent corrosion.

Hole

∅19

10.0 MAX. PANEL

THICKNESS

2.3

ADHESIVE PAD

M18 x 1

THREAD

30mm

1.18in

SLOTTED NUT AND

SHAKEPROOF WASHER

Routing and terminating coaxial cable(s)

Connect the coaxial cables to antenna and route to equipment, taking care to avoid fouling any moving vehicle

component. The cables must not be routed in front of any airbag device.

Commission and test

Check comms cables:

• Earth continuity: connector body to vehicle ground should measure <0.2Ω;

• Using a suitable antenna analyser, carry out a VSWR test in each freq. band.

• The VSWR should comply with values shown in the data sheet.

• Connect the antenna to the coaxial cable and carry out a system check.

Check GPS cable:

• Check the GPS cable with DC to measure high resistance.

• Connect the GPS cable to the GPS receiver and check for satellite acquisition.

European Waste Electronic Equipment Directive 2002/96/EC

Please ensure that your old Waste Electricals and Electronics are recycled do not throw them

away into standard waste.

RF Safety Note

This antenna should be mounted in such a way that no person is within 20cm (8”) of the

antenna during use.

Notices

Directive 2014/53/EU: Radio Equipment Directive (RED)

Harmonised Standards and References:

EN 301 489-1 (V2.1.1): “Electromagnetic compatibility and Radio spectrum Matters (ERM);

Electro Magnetic Compatibility (EMC) standard for radio equipment and services; Part 1: Common

technical requirements”.

Referencing EN 61000-4-2:2009 – Electrostatic Discharge Immunity and EN 61000-4-3:2006

+A1:2008 +A2:2010 – Radiated RF Immunity

EN 300 440-1 V1.6.1 (2010-08) – Electromagnetic compatibility and radio spectrum matters

(ERM); short range devices; radio equipment to be used in the 1GHz to 40GHz frequency range;

Part 1: Technical characteristics and Test methods in accordance with EN 300 440-2 V1.4.1

(2010-8) - Electromagnetic compatibility and radio spectrum matters (ERM); short range devices;

radio equipment to be used in the 1GHz to 40GHz frequency range

Low Voltage Directive: Directive 2006/95/EC (Electrical Equipment designed for use within

certain voltage limits) of August 2007. Compliance is declared according to:

EN60950-1: Safety of information technology equipment – according to test speciﬁcation EN

60950-1:2006 +A11:2009 +A1:2010 +A12:2011.

Directive 2011/65/EU (RoHS 2)

This product is fully compliant with the RoHS 2 directive. Exemption 6.c applies

Waiver: This document represents information compiled to the best of our present knowledge. It is not intended to as a representation or warranty of ﬁtness

of the products described for any particular purpose. This document details guidelines for general information purposes only. Always seek specialist advice

when planning installations and ensure that antennas are always installed by a properly qualiﬁed installer in compliance with local laws and regulations.

SW3-771 -www.panorama-antennas.com

Fitting the antenna

Remove protective backing from underside of antenna, feed coaxial cable(s) through panel. Position the antenna

over the hole and stick to panel by applying ﬁrm downward pressure. Assemble nut from underside and tighten.

IMPORTANT: Do not exceed a torque of 5Nm (3.6ft/lbs) when tightening the mounting nut.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Panorama Antennas Antenne

Panorama Antennas

Panorama Antennas LPB-6-60 Manuel utilisateur

Panorama Antennas

Panorama Antennas BAT M4-6-60 Series Manuel utilisateur

Panorama Antennas

Panorama Antennas CMWB2-038-6-NJ Manuel utilisateur

Panorama Antennas

Panorama Antennas CM-36-55 Series Manuel utilisateur

Panorama Antennas

Panorama Antennas SW3-689 Manuel de service

Panorama Antennas

Panorama Antennas CMSLP-038-4 Manuel utilisateur

Panorama Antennas

Panorama Antennas WM11 Series Manuel utilisateur

Panorama Antennas

Panorama Antennas SW3-875 LGMQM4 Series Manuel utilisateur

Panorama Antennas

Panorama Antennas DMM4-6-60 Manuel utilisateur

Panorama Antennas

Panorama Antennas FIND4/GPS D4/SHK 4 Series Manuel utilisateur

Panorama Antennas

Panorama Antennas ODP Series Manuel utilisateur

Panorama Antennas

Panorama Antennas TRNM Series Manuel utilisateur

Panorama Antennas

Panorama Antennas GPSP Series Manuel utilisateur

Panorama Antennas

Panorama Antennas WMM4G-6-60 Manuel utilisateur

Panorama Antennas

Panorama Antennas WMM2G-6-60 Manuel utilisateur

Panorama Antennas

Panorama Antennas LPB-6-60-NJ Manuel utilisateur

Panorama Antennas

Panorama Antennas LG-SX Series Manuel utilisateur

Panorama Antennas

Panorama Antennas MiMo CMM-6-60 Manuel utilisateur

Panorama Antennas

Panorama Antennas BSM-6-60 Manuel utilisateur

Panorama Antennas

Panorama Antennas DMM-6-60 Manuel utilisateur

Panorama Antennas

Panorama Antennas SW3-159 Manuel utilisateur

Panorama Antennas

Panorama Antennas WMM48G-17-42 Manuel utilisateur

Panorama Antennas

Panorama Antennas DMM-7-38 Manuel utilisateur

Panorama Antennas

Panorama Antennas MiMo CMM-6-60 Manuel utilisateur

Manuels Antenne populaires d'autres marques

Alfa Network

Alfa Network APA-L01 Manuel utilisateur

Naval

Naval PR-422CA Manuel utilisateur

Feig Electronic

Feig Electronic ID ISC.ANTH200/200 Series Manuel utilisateur

TERK Technologies

TERK Technologies TV44 Manuel utilisateur

Directive Systems & Engineering

Directive Systems & Engineering DSE2324LYRMK Manuel utilisateur

HP J8999A Manuel utilisateur

MobilSat

MobilSat MSP-S Manuel utilisateur

Steren

Steren ANT-UHF 13 Manuel utilisateur

Novatel

Novatel 600-G Manuel d'utilisation

Radio Shack

Radio Shack Amplified VHF/UHF/FM Indoor Antenna Manuel utilisateur

TRENDnet

TRENDnet TEW-AO12O Manuel utilisateur

Radio Shack

Radio Shack 15-1837 Manuel utilisateur

CommScope

CommScope CMAX-OMFX-43M-I53 Manuel utilisateur

Ramsey Electronics

Ramsey Electronics DAP25 Manuel utilisateur

COBHAM

COBHAM SAILOR 800 VSAT Manuel d'utilisation et d'entretien

Trango Systems

Trango Systems AD900-9 Manuel utilisateur

Steren

Steren ANT-100 Manuel utilisateur

Proxim

Proxim 5054-PA-23 Manuel utilisateur