Panorama Antennas GPSB Series Manuel utilisateur

Installation Instructions

GPSB Series

SW3-606 - v1.3

1. Introduction

The GPSB series is a high performance quad function antenna in an OEM style shark fin housing. It incorporates an active GPS antenna with 30dB gain LNA,

a multi-band cellular antenna, a dual band WiFi antenna and mounting bush for external whip. The GPSB is suitable for fitment to standard vehicle panels of

up to 4mm (0.16”) thickness. Heat shrink tubes are included in the kit, to enable the coaxial connections to be sealed as an extra precaution if required.

2. Mounting requirements and selecting location

This antenna must be fitted on a conductive ground plane of minimum 1⁄2 wavelength diameter at the lowest frequency of operation; to calculate see below:

150 / frequency in MHz = 1⁄2 wavelength (m)

Examples: 150MHz =100cm (39.4”); 400MHz = 38cm (15”); 900MHz =16cms (6.3”).

When fitting on a non-metallic panel, a ground plane plate of suitable size should be fabricated and fitted under the mounting panel. The securing washer

and nut must make a low resistance electrical contact (< 0.2Ω) with the ground plane . Select a mounting location, checking for roof curvature to ensure that

the antenna base will have a flat mounting surface. The antenna should be located as far as possible from surrounding roof mounted items (e.g light bar, air

con unit). Ensure that there is adequate under panel clearance and that there is no double skin panel or cross brace present. Measure to check for central

position if applicable.

4. Fitting the antenna

Remove protective backing from underside of antenna, feed coaxial cable(s) through panel. Position the antenna over the hole ensuring correct orientation

and stick to panel by applying firm downward pressure. Assemble washer and nut from underside and tighten - recommended torque is 5Nm (3.7ft/lbs).

Remove blanking cap and screw comms antenna whip securely to mounting stud (if applicable).

3. Prepare and drill hole

Mask panel area around hole position to protect paintwork and headliner.

Drill a pilot hole, and then increase to 19mm (3/4”), ensuring that drill/cutter bit does not contact headliner. Clean area around

the hole, remove any burrs and carefully remove all swarf.

Remove paint and primer from under panel surface to ensure adequate earth contact by washer and nut. Apply some

petroleum jelly or paint around the hole to prevent corrosion.

Hole

∅19

Fig.1

Electrical Safety Note

This product contains an active GPS/GNSS antenna (part number SR8-HG30). Rated voltage: 3-5VDC Rated current: 20mA maximum.

The supply to this device must be provided with over-current protection of 1A maximum.

Waiver: This document represents information compiled to the best of our present knowledge. It is not intended to as a representation or warranty of fitness of the products described for any

particular purpose. This document details guidelines for general information purposes only. Always seek specialist advice when planning installations and ensure that antennas are always

installed by a properly qualified installer in compliance with local laws and regulations.

Head Oﬃce

61 Frogmore, Wandsworth, London, SW18 1HF, UK

Waste electrical products should not be disposed of with household waste. All electronic products with the WEEE logo must be collected and

sent to approved operators for safe disposal or recycling. Please recycle where facilities exist. Many electrical/electronic equipment retailers

facilitate “Distributor Take-Back scheme”for household WEEE. Check with your Local Authority or electronic retailers for designated collection

facilities where WEEE can be disposed of for free.

Directive 2011/65/EU (RoHS 2)

RoHS 2 compliance is declared per Directive 2011/65/EU and its subsequent amendments with exemption 6.c applied.

REACH (Registration, Evaluation, Authorisation and Restriction of Chemicals, EC 1907/2006)

This product contains Lead (CAS No. 7439-92-1) which is classifi ed as an SVHC (Substance of Very High Concern) as be-ing toxic to

reproduction under Article 57c. of REACH. Do not chew parts or put them in mouth, keep away from unsupervised

children. Dispose of parts as WEEE waste do not send to landfill.

EU Declaration of Conformity

Object Reference: GPSB

Object Description: Multi-band Sharkfin with GNSS Antenna

Manufacturer: Panorama Antennas Ltd 61 Frogmore, London, SW18 1HF, U.K.

Directive 2014/53/EU Radio Equipment Directive (RED)

Harmonised Standards and References:

EN 301 489-1 (V2.1.1): “Electromagnetic compatibility and Radio spectrum Matters (ERM); Electro Magnetic Compatibility (EMC) standard for

radio equipment and services; Part 1: Common technical requirements”.

Referencing EN 61000-4-2:2009 – Electrostatic Discharge Immunity and EN 61000-4-3:2006 +A1:2008 +A2:2010 – Radiated RF Immunity

EN 300 440-1 V1.6.1 (2010-08) – Electromagnetic compatibility and radio spectrum matters (ERM); short range devices; radio equipment to

be used in the 1GHz to 40GHz frequency range; Part 1: Technical characteristics and Test methods in accordance with EN 300 440-2 V1.4.1

(2010-8) - Electromagnetic compatibility and radio spectrum matters (ERM); short range devices; radio equipment to be used in the 1GHz to

40GHz frequency range

Low Voltage Directive: Directive 2014/35/EU (Electrical Equipment designed for use within certain voltage limits) of 26th February 2014.

EN62368-1: 2014 Audio/video, information and communication technology equipment. Safety requirements

RF Safety Note

This antenna should be mounted in such a way that no person is within 20cm (8”) of the antenna during use.

5. Routing and terminating coaxial cable(s)

If heat shrink tubes are to be used, slide onto antenna cable tails prior to connecting extension cables – it is recommended that these are heat shrunk only

after tests have been satisfactorily completed. Connect extension coaxial cables to antenna and route to equipment, taking care to avoid running adjacent to

existing vehicle wiring or fouling any moving vehicle com- ponent. The cables must not be routed in front of any airbag device. Fit correct coaxial connector

or adapter to cables as required.

6. Commission and test

Check GPS/GNSS cable (where applicable):

● Check the GPS cable with DC to measure high resistance.

● Connect the GPS cable to the GPS receiver and check for satellite acquisition.

Check comms cable(s)

● Earth continuity: connector body to vehicle ground should measure <0.2Ω;

● Connector body to centre pin should measure open circuit.

● Carry out VSWR check, should measure as specified in the antenna data sheet.

● Connect GSM / Cellular, LTE & WLAN cables or stow unused pigtails.

7. Notices

Table des matières

Autres manuels Panorama Antennas Antenne

Panorama Antennas

Panorama Antennas SW3-606 Manuel de service

Panorama Antennas

Panorama Antennas WMM4-7-49 Manuel utilisateur

Panorama Antennas

Panorama Antennas ODP Series Manuel utilisateur

Panorama Antennas

Panorama Antennas MiMo Manuel utilisateur

Panorama Antennas

Panorama Antennas SiSo CMSLP-038-4 Manuel utilisateur

Panorama Antennas

Panorama Antennas SW3-935 Manuel utilisateur

Panorama Antennas

Panorama Antennas GPS25 Series Manuel utilisateur

Panorama Antennas

Panorama Antennas SW3-689 Manuel de service

Panorama Antennas

Panorama Antennas LP[G]AM Series Manuel utilisateur

Panorama Antennas

Panorama Antennas WMM2G-6-60 Manuel utilisateur

Panorama Antennas

Panorama Antennas WMM9G Series Manuel utilisateur

Panorama Antennas

Panorama Antennas CMWB2-038-6-NJ Manuel utilisateur

Panorama Antennas

Panorama Antennas WM11 Series Manuel utilisateur

Panorama Antennas

Panorama Antennas WMM48G-17-42 Manuel utilisateur

Panorama Antennas

Panorama Antennas GPSCO Series Manuel utilisateur

Panorama Antennas

Panorama Antennas CM-7-60 Manuel utilisateur

Panorama Antennas

Panorama Antennas DMM-7-38 Manuel utilisateur

Panorama Antennas

Panorama Antennas TRNM Series Manuel utilisateur

Panorama Antennas

Panorama Antennas LPM2-7-27 Series Manuel utilisateur

Panorama Antennas

Panorama Antennas LPBEM-6-60 Manuel utilisateur

Panorama Antennas

Panorama Antennas SW3-665 WMMG Instructions originales

Panorama Antennas

Panorama Antennas SW3-875 LGMQM4 Series Manuel utilisateur

Panorama Antennas

Panorama Antennas FIND4/GPS D4/SHK 4 Series Manuel utilisateur

Panorama Antennas

Panorama Antennas SW3-159 Manuel utilisateur

Manuels Antenne populaires d'autres marques

Alfa Network

Alfa Network APA-L01 Manuel utilisateur

Naval

Naval PR-422CA Manuel utilisateur

Feig Electronic

Feig Electronic ID ISC.ANTH200/200 Series Manuel utilisateur

TERK Technologies

TERK Technologies TV44 Manuel utilisateur

Directive Systems & Engineering

Directive Systems & Engineering DSE2324LYRMK Manuel utilisateur

HP J8999A Manuel utilisateur

MobilSat

MobilSat MSP-S Manuel utilisateur

Steren

Steren ANT-UHF 13 Manuel utilisateur

Novatel

Novatel 600-G Manuel d'utilisation

Radio Shack

Radio Shack Amplified VHF/UHF/FM Indoor Antenna Manuel utilisateur

TRENDnet

TRENDnet TEW-AO12O Manuel utilisateur

Radio Shack

Radio Shack 15-1837 Manuel utilisateur

CommScope

CommScope CMAX-OMFX-43M-I53 Manuel utilisateur

Ramsey Electronics

Ramsey Electronics DAP25 Manuel utilisateur

COBHAM

COBHAM SAILOR 800 VSAT Manuel d'utilisation et d'entretien

Trango Systems

Trango Systems AD900-9 Manuel utilisateur

Steren

Steren ANT-100 Manuel utilisateur

Proxim

Proxim 5054-PA-23 Manuel utilisateur