Panasonic SA-PM10E Manuel utilisateur

ORDERNO. MD0303075C2

CD Stereo System

SA-PM10E / SA-PM10EB / SA-PM10EG

Colour

(S)... Silver Type

TAPE SECTION

AR2MECHANISM SERIES

SPECIFICATIONS

Specification

Amplifier Section

RMS Power output

THD 10%, bothchannelsdriven 15 Wper channel (6)

Output impedance

Headphone 16-32

FM Tuner Section

Frequencyrange 87.50-108.00 MHz

(50 kHz step)

Sensitivity 2.0V (IHF)

S/N 26 dB 1.5V

Antennaterminals 75 unbalanced

AM Tuner Section

Frequencyrange 522-1629 KHz (9kHz steps)

520-1630 KHz (10 kHz steps)

Sensitivity

S/N 20 dB (at 999 kHz) 560 V/m

CassetteDeck Section

Track system 4 track, 2channel

Heads

Record/playback Solidpermalloyhead

Erasure AC erase head

Motor DC servomotor

Recording system AC bias 100 kHz

Erasing system AC erase 100 kHz

Tapespeed 4.8cm/s

Overall frequencyresponse (+3to-6dB at DECK OUT)

NORMAL(TYPE I) 35 Hz - 14 kHz

S/N 50 dB (Aweighted)

Wowand flutter 0.15%(WRMS)

Fast forwardand rewind time Approx. 120 secondswithC-60

cassettetape

CD Section

Sampling frequency 44.1kHz

Decoding 16 bit linear

Beam source Semiconductorlaser

Wavelength 780 nm

Number of channels 2channelsstereo

Wowand flutter Belowmeasurablelimit

Digital filter 8 fs

D/Aconverter MASH (1bit DAC)

General

Power supply AC 220-230V, 50Hz

Power consumption 48 W

Power consumption (Standby

mode) 0.8W

Dimensions(WxH xD) 165 x228 x313 mm

Mass 3.9kg

Notes :

1. Specificationsare subject tochangewithout notices. Mass

and dimensionsare approximate.

2. Total harmonicdistortion ismeasuredbythedigital spectrum

analyzer.

System : SC-PM10 (E) Musiccenter: SA-PM10 (E)

Speaker: SB-PM10 (P)

System : SC-PM10 (EB) Musiccenter: SA-PM10 (EB)

Speaker: SB-PM10 (P)

System : SC-PM10 (EG) Musiccenter: SA-PM10 (EG)

Speaker: SB-PM10 (EG)

Unauthorized copying and distribution isaviolation of law.

1. Before Repair and Adjustment

Disconnect AC power, discharge PowerSupplyCapacitors C501, C604, C608, C906 & C908

through a 10 , 5W resistortoground.

DO NOTSHORT-CIRCUITDIRECTLY (witha screwdriverblade, forinstance), as this may

destroysolidstate devices.

Afterrepairs are completed, restore powergraduallyusing a variac, toavoidovercurrent.

-Current consumption at AC 230V, 50 HzinNO SIGNALmode

shouldbe ~150 mA.

2. Protection Circuitry

The protection circuitrymayhave operatedif eitherof the following conditions are noticed:

-Nosound isheard when the power isturned on.

-Sound stops during aperformance.

The function of this circuitryis toprevent circuitrydamage if, forexample, the positive and

negative speakerconnection wires are "shorted", orif speakersystems withanimpedance less

thanthe indicatedratedimpedance of the amplifierare used.

If this occurs, followthe procedure outlines below:

1. Turn off the power.

2. Determine the cause of the problem and correct it.

3. Turn on the power once againafter one minute.

Note:

Whenthe protection circuitryfunctions, the unit will not operate unless the poweris first turned

off and thenon again.

3. Accessories

Note : RefertoPacking Materials & Accessories forpart number.

Remote Control Transmitter

FM indoorantenna

AC mains lead(ForEB only)

AC mains lead(ForE & EG only)

Antenna plug adapter(ForEB only)

AM Loop antenna

4. Operation Procedures

5. Handling the Lead-free Solder

5.1. About lead free solder (PbF)

Distinction of PbF P.C.B.:

P.C.B.s (manufactured) using leadfree solderwill have a PbF stampon the P.C.B.

Caution:

-Pb free solder has ahigher melting point than standard solder;

Typicallythe melting point is50 -70°F (30 -40°C)higher. Please

use ahigh temperature soldering iron. Incase of soldering iron

with temperature control, please set itto 700 ± 20°F (370 ± 10°C).

-Pb free solder will tend to splash when heated too high (about

1100°F/600°C).

-When soldering or unsoldering, please completelyremove all of

the solder on the pins or solder area, and be sure to heat the

soldering points with the Pb free solder until itmelts enough.

6. Handling Precautions For Traverse Deck

The laserdiode inthe traverse deck (optical pickup) maybreak downdue topotential difference

causedbystatic electricityof clothes orhumanbody.

So, be careful of electrostatic breakdownduring repairof the traverse deck (optical pickup).

Handling of CD traverse deck (optical pickup)

1. Donot subject the traverse deck (optical pickup) to static

electricityas itisextremelysensitive to electrical shock.

2. The short land between the No.4(LD)and No.5(GND)pins on the

flexibleboard (FFC)isshorted with asolder build-up to prevent

damage to the laser diode.

3. Take care not to applyexcessive stress to the flexibleboard (FPC

board).

4. Donot turn the variableresistor (laser power adjustment). Ithas

alreadybeen adjusted.

Grounding forelectrostatic breakdownprevention

1. Human bodygrounding

Use the anti-staticwrist strap to discharge the staticelectricity

from your body.

2. Work tablegrounding

Put aconductive material (sheet) or steel sheet on the area where

the traverse deck (optical pickup) isplaced, and ground the sheet.

Caution :

The staticelectricityof your clothes will not be grounded through

the wrist strap. So, take care not to let your clothes touch the

traverse deck (optical pickup).

Caution whenReplacing the Optical Pickup :

The traverse has ashort point shorted with solder to protect the

laser diode against electrostatics breakdown. Besure to remove

the solder from the short point before making connections.

7. Caution for AC Mains Lead

8. Operation Check and Main Component

Replacement Procedures

“ATTENTION SERVICER”

Some chassiscomponents mayhave sharp edges. Becareful when

disassembling and servicing.

1. Thissection describes procedures for checking the operation of

the major printed circuitboards and replacing the main

components.

2. For reassemblyafter operation checks or replacement, reverse

the respective procedures.Special reassemblyprocedures are

described onlywhen required.

3. Select items from the following index when checks or

replacement are required.

4. Refer the Parts No. on the page of "MainComponent Replacement

Procedures", ifnecessary.

Contents

-Checking Procedure for each major P.C.B.

-Checking of the MainP.C.B. &Transformer P.C.B.

-Checking for the Deck P.C.B. , Headphone P.C.B. and Tape Eject

P.C.B.

-Checking for the Panel P.C.B. and Power P.C.B. and Speaker

Terminal P.C.B.

-Checking for the CD Servo P.C.B.

-Disassemblyand Assemblyof the Disc Trayand CD Traverse Unit

-Disassemblyof the Disc Tray

-Disassemblyof the CD Traverse Unit

-MainComponent Replacement Procedure

-Replacement of the CD Servo P.C.B. and Optical Pick-up Unit

-Procedure for Replacing Cassette Holder

-Procedure for Replacing Pinch Roller and Head Block (Cassette

Mechanism Unit)

-Procedure for Replacing Motor, Capstan BeltA, Capstan BeltB

and Winding Belt(Cassette Mechanism Unit)

-Procedure for Replacing parts on Mechanism P.C.B.

Warning :-

Thisproduct uses alaser diode. Refer to caution statement

“Precaution of Laser Diode”.

ACHTUNG :-

-DieLasereinheitnicht zerlegen.

-DieLasereinheitdarf nur gegen eine vom Hertsteller spezifizierte

Einheitausgetauscht werden.

8.1. Checking Procedure for Each Major P.C.B.

8.1.1. Checking forMain& TransformerP.C.B.

Step1 Remove all the screws.

Step2 Remove side panel.

-Checking for MainP.C.B.

Ce manuel convient aux modèles suivants

Autres manuels Panasonic Système stéréo

Panasonic

Panasonic SC-HC295 Manuel utilisateur

Panasonic

Panasonic SCHT744 - RECEIVER Manuel utilisateur

Panasonic

Panasonic RX-ES27 Manuel utilisateur

Panasonic

Panasonic SC-PM47 Manuel utilisateur

Panasonic

Panasonic RX-D45 Manuel utilisateur

Panasonic

Panasonic SC-DP1 Manuel utilisateur

Panasonic

Panasonic SA-H82 Manuel utilisateur

Panasonic

Panasonic SC-DM502 Manuel utilisateur

Panasonic

Panasonic SA-AK240PL Manuel utilisateur

Panasonic

Panasonic SC-PM5 Manuel utilisateur

Panasonic

Panasonic SC-AK78 Manuel utilisateur

Panasonic

Panasonic SCPM71SD - MINI HES W/CD PLAYER Manuel utilisateur

Panasonic

Panasonic SA-AK270EB Manuel utilisateur

Panasonic

Panasonic SCPM22 - CD STEREO SYSTEM Manuel utilisateur

Panasonic

Panasonic SA-AK750PL Manuel utilisateur

Panasonic

Panasonic SC-HC1000 Manuel utilisateur

Panasonic

Panasonic RX-D55EE Manuel utilisateur

Panasonic

Panasonic RX-C52 Manuel utilisateur

Panasonic

Panasonic SC-HC17 Manuel utilisateur

Panasonic

Panasonic SC-AK110 Manuel utilisateur

Panasonic

Panasonic SC-AKX14 Manuel utilisateur

Panasonic

Panasonic SC-CH170 Manuel utilisateur

Panasonic

Panasonic SC-PM42DB Manuel utilisateur

Panasonic

Panasonic SA-AK250GCP Manuel utilisateur

Manuels Système stéréo populaires d'autres marques

LG CM3330B Manuel utilisateur

Sony

Sony SS-CEP50 Manuel utilisateur

Cetacea Sound

Cetacea Sound CVS-II Manuel utilisateur

Aiwa

Aiwa XR-H66MD Manuel utilisateur

Denon

Denon UCD-250 Manuel utilisateur

Sanyo

Sanyo DC-MX41i Manuel utilisateur

Sharp

Sharp CD-ES600V Manuel utilisateur

Exibel

Exibel BDX600-UK Manuel utilisateur

Sanyo

Sanyo DC-F320 Manuel utilisateur

Philips

Philips FWM583X Manuel utilisateur

Sharp

Sharp CD-C462 Manuel utilisateur

Onkyo

Onkyo CBX 300 - CD / MP3 Clock Radio Manuel utilisateur

Aiwa

Aiwa XR-EM70 Manuel utilisateur

Cyrus

Cyrus Lyric Manuel utilisateur

Philips

Philips MCM159/98 Manuel utilisateur

Philips/Magnavox

Philips/Magnavox Magnavox FW 62C Manuel utilisateur

RCA

RCA RS3965SB Manuel utilisateur

Sharp

Sharp XL-UH240 Manuel utilisateur