Panasonic NV-MX500EG Manuel utilisateur

ORDERNO.VMD0209050C8

Digital Video Camera/Recorder

NV-MX500EG / NV-MX500B / NV-MX500EN / NV-MX500A / NV

-MX500ENT

VOL.1

Q3-MECHANISM

SPECIFICATIONS

Unauthorized copying and distribution isaviolation of law.

1. INTRODUCTION

1.1. INTRODUCTION

This service manual contains technical information whichwill allowservice personnel's to

understand and service this model.Please place orders using the parts list and not the drawing

reference numbers.

If the circuit is changedormodified, this information will be followedbysupplement service

manual tobe filedwithoriginal service manual.

Information forQ-Mechanismshouldbe referdtothe anothermanual as below.

OrderNo. : VMD0109026C8

Note 1:

These movie cameras use AC Adaptoris VSK0581-A.

The service manual forAC Adaptoris separate volume.

OrdernumberforAC Adaptor..........VSK0581-A : VMD0105013C8

Note 2:

1) This service manual does not containthe following information, because of the impossibility

of sevicing at component level.

1. SchematicDiagram, Block Diagram and C.B.A. layout of Main

C.B.A./ Sub C.B.A.

2. Parts List for individual parts of MainC.B.A./ Sub C.B.A.

3. Exploded View and Parts List for individual parts of Mechanism

Unit.

2) The following categoryis/are recycle module part. Please send it/themtoCentral Repair

Center.

*MainC.B.A. (VEP03G20B)

*Sub C.B.A. (VEP23569B)

Whena part replacement is requiredforrepairing eachMainC.B.A. and/ orMechanismblock,

replace the assemblyparts.

(MainC.B.A., Sub C.B.A. and/ orMechanismUnit)

The following circuits are containedinMainC.B.A.

1. MainConnection Circuit

2. Drive Circuit

3. Video 1Circuit

4. Video 2Circuit

5. Control Circuit

6. LCD Circuit

7. Head/ Rec Amp Circuit

8. Power Circuit

9. Ex. Input Circuit

The following circuits are containedinSub C.B.A.

1. Sub Connection Circuit

2. Sensor Circuit

3. Lens Drive Circuit

4. Process Circuit

5. DSCCircuit

About leadfree solder(PbF)

Distinction of PbF PCB:

PCBs (manufactured) using leadfree solderwill have a PbF stampon the PCB.

Caution:

-Pb free solder has ahigher melting point than standard solder;

Typicallythe melting point is50-70°F (30-40°C)higher. Please use

ahigh temperature soldering iron. Incase of the soldering iron

with temperature control,please set itto 700±20°F (370±10°C).

-Pb free solder will tend to splash when heated too high (about

1100°F/ 600°C).

When soldering or unsoldering, please completelyremove all of the

solder on the pins or solder area, and be sure to heat the soldering

points with the Pb free solder until itmelts enough.

1.2. FEATURECOMPARISONCHART

FUNCTION EG B EN A

CardFunction (Multi Media Card, SD Card)

External DV/ VIDEO Input

MPEG4 Recording

2. CAUTION FOR AC CORD (VJA0940 TYPE)

2.1. INFORMATIONFORYOUR SAFETY

IMPORTANT

Yourattention is drawntothe fact that recording of pre-recordedtapes ordiscs orother

publishedorbroadcast material mayinfringe copyright laws.

WARNING

To reduce the risk of fire or shock hazard, do not expose this

equipment to rainor moisture.

CAUTION

To reduce the risk of fire or shock hazard and annoying

interference, use the recommended accessories only.

FOR YOUR SAFETY

DO NOTREMOVE THE OUTER COVER

To prevent electric shock, do not remove the cover. Nouserserviceable parts inside. Refer

servicing toqualifiedservice personnel.

2.2. CAUTIONFORAC MAINSLEAD

Foryoursafety, please readthe following text carefully.

This appliance is suppliedwitha mouldedthree-pinmains plug foryoursafetyand convenience.

A 5-ampere fuse is fittedinthis plug.

Shouldthe fuse needtobe replacedplease ensure that the replacement fuse has a rating of 5

amperes and it is approvedbyASTA orBSI toBS1362

Check forthe ASRA mark orthe BSI mark on the bodyof the fuse.

If the plug contains a removable fuse coveryou must ensure that it is refittedwhenthe fuse is

replaced.

If you lose the fuse cover, the plug must not be useduntil a replacement coveris obtained.

A replacement fuse covercanbe purchasedfromyourlocal Panasonic Dealer.

If the fittedmouldedplug is unsuitable forthe socket outlet inyourhome thenthe fuse should

be removedand the plug cut off and disposedof safety.

There is a dangerof severe electrical shock if the cut off plug is insertedintoany13-ampere

socket.

If a newplug is tobe fittedplease observe the wiring code as shownbelow.

If inanydoubt, please consult a qualifiedelectrician.

2.2.1. Important

The wires inthis mains leadare colouredinaccordance withthe following code:

Blue Neutral

Brown Live

As the colours of the wires inthe mains leadof this appliance maynot correspond withthe

colouredmarkings identifying the terminals inyourplug, proceedas follows:

The wire whichis colouredBLUE must be connectedtothe terminal inthe plug whichis marked

withthe letterN orcolouredBLACK.

The wire whichis colouredBROWN must be connectedtothe terminal inthe plug whichis

markedwiththe letterLorcolouredRED.

Underno circumstances shouldeitherof these wires be connectedtothe earthterminal of the

three pinplug, markedwiththe letterE orthe EarthSymbol.

2.2.2. Beforeuse

remove the ConnectorCoveras follows.

2.2.3. Howtoreplace the Fuse

1. Remove the Fuse Cover with ascrewdriver.

2. Replace the fuse and attach the Fuse cover.

3. SERVICE CAUTION

3.1. HOWTO DISCHARGETHECAPACITORONJACK SDC.B.A.

3.2. EEPROMDATAFORSPAREPARTS OFTHEMAINC.B.A.

Whenthe MainC.B.A. is replaced, the fixedand average data must be changedbyTatsujinkit

according tothe Movie Camera’s suffix.

Then, confirm and/oradjust the VTR and Camera section one byone.

3.3. SERVICEEXTENSIONCABLES

This models is requiredthe following extension cables forall connections.

Note 1:

Use the following extension cables whenchecking oradjusting individual circuit boards except

module Parts.

(MainC.B.A. and Sub C.B.A.)

Howtouse extension cables.

Fig. T1-1

3.4. LOCATIONFORSPARECONNECTORSOFTHEMAINC.B.A.&

SUB C.B.A.

3.4.1. MAIN C.B.A.

3.4.2. SUB C.B.A.

4. PREPARATION FOR ELECTRICAL ADJUSTMENT

1. Unlock the locking tab and remove the EVRconnector as shown

in Fig. E1.

2. Then connect the following cables as shownin Fig. E2.

Fig. E1

Fig. E2

Fig. E3

5. SERVICE MODE

5.1. New Error Code Display

Conventionally, the errorcode has beendisplayedautomaticallyon the EVForLCD Monitor

whenundesirable conditions have occurred. Withthe NewErrorCode Display, the errorcode

has not beendisplayedautomaticallyas follows except some errorcodesF31(Data

Transmission Error), U10(Dew) and U11(HeadClogging).

Note:

1. The onlysome error codes F31, U10 and U11 has displayed

automaticallyon the EVF or LCD monitor as usual.

2. The Power LEDalso has been flashed for 1min. when undesirable

condetions have occurred.(See below)

5.2. Viewing Error Code

Whendisplaying the ErrorCode on the EVForLCD Monitor, pushthe FADE/STOP and REC

START/PAUSE buttons simultaneouslyformore 3 seconds.

Note:

When the cassette tape isinserted, thisoperation will not be

worked.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Panasonic caméscope

Panasonic

Panasonic AG-CX6 Manuel utilisateur

Panasonic

Panasonic HX-A100D Instructions d'installation et d'entretien

Panasonic

Panasonic NV-DS30A Manuel utilisateur

Panasonic

Panasonic NV-VX7 Manuel utilisateur

Panasonic

Panasonic NV-DS28A Manuel utilisateur

Panasonic

Panasonic GP-VD151 Manuel utilisateur

Panasonic

Panasonic Palmcorder PV-DV951 Manuel utilisateur

Panasonic

Panasonic PV-D301 Manuel utilisateur

Panasonic

Panasonic PV-GS65 Manuel utilisateur

Panasonic

Panasonic HC-X2000 Manuel utilisateur

Panasonic

Panasonic Palmcorder IQ PV-A306 Manuel utilisateur

Panasonic

Panasonic HC-MDH2 Caractéristiques techniques

Panasonic

Panasonic HDC-SX5 Manuel utilisateur

Panasonic

Panasonic AJD910WA - DVCPRO50 Manuel utilisateur

Panasonic

Panasonic AVCCAM AG-AC8PJ Manuel utilisateur

Panasonic

Panasonic AG-HMC150 Guide d'installation

Panasonic

Panasonic NV-DS30A Manuel utilisateur

Panasonic

Panasonic AG-HPX300P Guide d'application

Panasonic

Panasonic NV-GS230EG Manuel utilisateur

Panasonic

Panasonic Palmcorder IQ DisplayMate PV-L606 Manuel utilisateur

Panasonic

Panasonic Palmcoder IQ PV-IQ225 Manuel utilisateur

Panasonic

Panasonic AJ-PX270 Manuel utilisateur

Panasonic

Panasonic VDR-D300GC Manuel utilisateur

Panasonic

Panasonic NV-MS5A Manuel utilisateur

Manuels caméscope populaires d'autres marques

Toshiba

Toshiba CAMILEO Z100 Manuel utilisateur

Canon

Canon RC 260 Manuel utilisateur

Sony

Sony Handycam DCR-DVD7E Manuel utilisateur

Brinno

Brinno TimeLapse TLC200 Manuel utilisateur

JVC

JVC GR-SXM68AC Guide de démarrage rapide

Insignia

Insignia NS-DCC5HB09 - Camcorder - 720p Manuel utilisateur

MYDLINK

MYDLINK DCS-6100LH Manuel utilisateur

Sony

Sony video Hi8 Handycam CCD-TR555 Manuel utilisateur

SECURECOM

SECURECOM V-5014B Manuel utilisateur

Sharper Image

Sharper Image U-VIDEO Manuel utilisateur

JVC

JVC AA-V15EG Manuel utilisateur

Canon

Canon LEGRIA HV40 Manuel utilisateur

Sony

Sony Handycam DCR-VX2000 Manuel utilisateur

RCA

RCA CC616 Manuel utilisateur

ATIK Cameras

ATIK Cameras Horizon Manuel utilisateur

Sony

Sony Handycam HDR-CX580V Manuel utilisateur

Sharp

Sharp ViewcamZ VL-Z8H Manuel utilisateur

Philips

Philips M620/21 Manuel utilisateur