Panasonic DP-8032 Manuel utilisateur

Order Number: MGCS080801C0

H21

Digital Imaging Systems

DP-8032 / 8025

[ Version 1.2 ]

This service information is designed for experienced repair technicians only and is not intended for use by the general public.

It does not contain warnings or cautions to advise non-technical individuals of potential dangers in attempting to service a product.

Products powered by electricity should be serviced or repaired only by experienced professional technicians. Any attempt to service

or repair the product or products dealt within this service information by anyone else could result in serious injury or death.

WARNING

Unauthorized copying and distribution is a violation of law.

Important Notice

Please read this notice completely BEFORE installing any

optional accessories. As failure to properly install the additional

board or connector with the power ON (only the front power

switch Off) could damage the copier’s SPC or SC board.

Please follow the instructions below:

1. It is essential that you turn OFF power to the Main Power

Switch located in the rear of the copier.

2. It is essential that you unplug the Main AC Power Cord from

the wall outlet.

3. Please carefully read the installation instructions and follow

each step.

< Example >

Note:

If the Hard Disk Drive Unit is installed, to prevent a Disk Scan Function from being

performed (similar to Windows OS when the power is abruptly interrupted), it is

important to follow the step sequence below when turning OFF the Power Switches on

the machine.

1. Turn the Power Switch on the Left Side of the machine to the OFF position first.

2. Wait approximately 10 seconds while the machine writes the closing status onto the Hard Disk

Drive Unit.

3. Turn the Main Power Switch on the Back of the machine to the OFF position.

(This interrupts all the power to the machine)

4. Unplug the AC Power Cord.

* The specifications are subject to change without notice. Panasonic Communications Co., Ltd. reserves

the right to make improvements in the product design without reservation and without notice.

Hinweis:

< Beispiel >

Precautions

Power and Ground Connection Cautions

Ensure that the plug connection is free of dust. In a damp environment, a contaminated

connector can draw a significant amount of current that can generate heat and eventually

cause fire if left unattended over an extended period of time.

Always use the power cord provided with your machine. When an extension power cord is

required, always use a properly rated cord.

120 V/15 A or AC 220 - 240V/10 A

If you use a cord with an unspecified current rating, it may be underrated, and the machine,

or plug may emit smoke, orbecome hot to the touch.

Do not attempt to repair, pull, bend, chafe or otherwise damage the power cord. Do not

place a heavy object on the cord. A damaged cord can cause fire or electric shocks.

Never touch a power cord with wet hands. Danger of electric shock exists.

If the power cord is damaged, or insulated wires are exposed, contact the authorized

Panasonic dealer for a replacement. Using a damaged cord can cause fire or electric

Stop operation immediately if your machine emits smoke, excessive heat, unusual noise, or

abnormal smell, or if water is spilt onto the machine. These conditions can cause fire.

Immediately switch Off and unplug the machine, and contact the authorized Panasonic.

Do not disconnect or reconnect the machine while the power switch is in the On position.

Disconnecting a live connector can cause arcing, consequently deforming the plug and

cause fire.

When disconnecting the machine, grasp the plug instead of the cord. Pulling on a cord

forcibly can damage it, and cause fire, or an electric shock.

When the machine is not used over an extended period of time, switch it Off and unplug it.

If an unused machine is left connected to a power source for a long period, degraded insulation

can cause electric shocks, current leakage or fire.

Be sure to switch Off, and unplug the machine before accessing the interior of the machine

for cleaning, maintenance or fault clearance. Access to a live machine's

interior can cause

an electric shock.

For Your Safety

To prevent severe injury and loss of life, read this section carefully before servicing the Panasonic

machine to ensure proper, and safe operation of your machine.

This section explains the Warnings and Cautions used in the machine and/or this manual.

WARNING: Denotes a potential hazard that could result in serious injury or death.

CAUTION:

Denotes hazards that could result in minor injury or damage to the machine.

This section also explains the Warnings and Cautions used in the machine and/or this manual.

These symbols are used to alert operators to a specific operating procedure

that must not be performed.

These symbols are used to alert operators to a specific operating procedure

that must be emphasized in order to operate the machine safely.

WARNING

Please ensure that the machine is installed near a wall outlet, and is easily accessible.

shocks.

dealer.

Once a month, unplug the machine and check the power cord for the following. If you notice any unusual

condition, contact your authorized Panasonic dealer.

The power cord is plugged firmly into the receptacle.

The plug is not excessively heated, rusted, or bent.

The plug and receptacle are free of dust.

The cord is not cracked or frayed.

Operating Safeguards

Do not touch areas where these caution labels are attached to, the surface may be very hot and may cause

severe burns.

Do not place any liquid container such as a vase, or coffee cup on the machine. Spilt water can cause fire or

shock hazard.

Do not place any metal parts such as staples or clips on the machine. If metal and flammable parts get into the

machine, they can short-circuit internal components, and cause fire or electric shocks.

If debris (metal or liquid) gets into the machine, switch Off and unplug the machine immediately.

Operating a debris-contaminated machine can cause fire or electric shock.

Do not try to alter the machine configuration or modify any parts. An unauthorized modification can cause

smoke or fire.

Consumable Safeguards

Never dispose of toner, toner cartridge, or a waste toner container into an open flame. Toner remaining in the

cartridge/bottle can cause an explosion, burns and/or injuries.

Keep button batteries/stamp out of the reach of children to prevent chocking or poisoning. If a button

battery/verification stamp is swallowed accidentally, get medical treatment immediately.

Installation and Relocation Cautions

Do not place the machine near heaters or volatile, flammable, or combustible materials such as curtains that

may catch fire.

Do not place the machine in a hot, humid, dusty, or poorly ventilated environment. Prolonged exposure to

these adverse conditions can cause fire or electric shocks.

Place the machine on a level and sturdy surface that can withstand the weight of the machine.

Refer to the Specifications section for the weight of the machine.

If tilted, the machine may tip-over and cause injuries.

When moving the machine, be sure to unplug the power cord from the outlet. If the machine is moved with the

power cord attached, it can cause damage to the cord which could result in fire or electric shock.

CAUTION

When relocating the machine, remove the toner and/or developer, and pack the machinee with proper

packing materials for shipping.

Notice: California only:

This product contains a CR Coin Cell Lithium Battery which contains Perchlorate Material - special handling may apply.

See www.dtsc.ca.gov/hazardouswaste/perchlorate

Operating Safeguards

Do not place a magnet near the safety switch of the machine. A magnet can activate the

machine accidentally, resulting in injuries.

Do not use a highly flammable spray, or solvent near the machine. It can cause fire.

When copying a thick document, do not use excessive force to press it against the scanning

glass. The glass may break and cause injuries.

Never touch a labelled area found on, or near the heat roller. You can get burnt. If a sheet of

paper is wrapped around the heat roller, do not try to remove it yourself to avoid injuries or

burns. Switch Off the machine immediately, and wait until it cools down.

Do not use conductive paper, e.g. folding paper, carbon paper and coated paper. When a

paper jam occurs, they can cause a short circuit and fire.

Do not place any heavy object on the machine. An off-balance machine can tip-over, or the

heavy object can fall, causing damage and/or injuries.

Keep the room ventilated when using the machine for an extended period of time to minimize

the ozone density in the air.

When copying with the document cover open, do not look directly at the exposure lamp.

Direct eye exposure can cause eye fatigue or eye injury.

Pull the paper trays out slowly to prevent injuries.

When removing jammed paper, make sure that no pieces of torn paper are left in the machine.

A piece of paper remaining in the machine can cause fire. If a sheet of paper is wrapped

around the heat roller, or when clearing a jammed paper that is difficult or impossible to see,

do not try to remove it by yourself. Doing so can cause injuries or burns. Switch Off the

machine immediately, and wait until it cools down.

Consumable Safeguards

Never heat the drum cartridge, or scratch its surface. A heated, or scratched drum can be

hazardous to your health.

Do not mix new and old batteries together, as they can burst or leak, causing a fire or

injuries. Be sure to use the specified type of batteries only..

Ensure that batteries are installed with correct polarity. Incorrectly installed batteries can

burst or leak, resulting in spillage or injuries.

Others

When clearing a paper jam or other fault, follow the appropriate procedure given in this manual.

The machine has a built-in circuit for protection against lightning-induced surge current. If lightning

strikes in your neighborhood, maintain an ample distance from the machine, and do not touch it

until the lightning stops.

If you notice flickering, distorted images, or noises on your audio-visual units, your machine may

be causing radio interference. Switch it Off, and if the interference disappears, the machine is the

cause of the radio interference. Perform the following procedure until the interference is corrected.

Move the machine, and theTV and/or radio away from each other.

Reposition or reorient the machine, and theTV and/or radio.

Unplug the machine, TV and/or radio, and replug them into outlets operating on different circuits.

Reorient the TV and/or radio antennas, and cables until the interference stops. For an outdoor

antenna, ask your local electrician for support.

Use a coaxial cable antenna.

CAUTION

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Panasonic Imprimante tout-en-un

Panasonic

Panasonic DP-2330 Manuel utilisateur

Panasonic

Panasonic KXFLB881 - Network Multifunction Laser... Manuel utilisateur

Panasonic

Panasonic Workio DP-C305 Manuel utilisateur

Panasonic

Panasonic KX-MC6260E Manuel utilisateur

Panasonic

Panasonic KX-MB783BR Manuel utilisateur

Panasonic

Panasonic KX-MB781C Manuel utilisateur

Panasonic

Panasonic KXFLB881 - Network Multifunction Laser... Mode d’emploi

Panasonic

Panasonic KX-MB2060C Manuel d'utilisation

Panasonic

Panasonic KX-FLB882CX Manuel utilisateur

Panasonic

Panasonic DP-2310/3010 Comment utiliser

Panasonic

Panasonic WORKIO DP-8035 Manuel utilisateur

Panasonic

Panasonic KX-MC6020CX Manuel utilisateur

Panasonic

Panasonic DP-C266 Manuel utilisateur

Panasonic

Panasonic KX-MC6040 - Color Laser Multi-Function... Mode d’emploi

Panasonic

Panasonic KX-PS8000 Guide de l'utilisateur

Panasonic

Panasonic WORKIO DP-C354 Manuel utilisateur

Panasonic

Panasonic FP-D350 Manuel utilisateur

Panasonic

Panasonic DP-1510P Guide de démarrage rapide

Panasonic

Panasonic DA-MC700 Manuel utilisateur

Panasonic

Panasonic Workio DP-3030 Manuel utilisateur

Panasonic

Panasonic WORKIO DP-C323 Manuel utilisateur

Panasonic

Panasonic KX-MC6040 - Color Laser Multi-Function... Manuel utilisateur

Panasonic

Panasonic DP-180 Manuel utilisateur

Panasonic

Panasonic WORKIO DP-8060 Manuel utilisateur

Manuels Imprimante tout-en-un populaires d'autres marques

Triumph Adler

Triumph Adler DC 2016 Manuel

Epson

Epson WorkForce WF-2510 Guide de l'utilisateur

Epson

Epson Stylus Scan 2000 Manuel d'installation et d'exploitation

Epson

Epson PictureMate Snap PM 240 Mode d’emploi

Konica Minolta

Konica Minolta bizhub C35 Manuel utilisateur

Brother

Brother MFC-J430w Manuel utilisateur

Konica Minolta

Konica Minolta BIZHUB 558 Manuel utilisateur

Lexmark

Lexmark MX710 Series Manuel

Brother

Brother MFC-9760 Manuel utilisateur

Lexmark

Lexmark XC8155 Manuel utilisateur

Lexmark

Lexmark X642E Manuel utilisateur

Sharp

Sharp MX-2310U Mode d’emploi

Aficio

Aficio 200 Manuel utilisateur

Canon

Canon ImageCLASS 2300 Manuel

Ricoh

Ricoh Pro C900 Manuel utilisateur

Lexmark

Lexmark X925 Manuel utilisateur

Brother

Brother Business Smart MFC-J4510dw Manuel utilisateur

Epson

Epson Stylus CX8400 Series Manuel utilisateur