PAC PAC-200 Manuel de service
The relay will handle 200 amperes on a continuous basis at 12 VDC and 300 Amperes in rush peak or surge.
Mount the relay between batteries as an isolator or in the main power lead servicing the mobile audio system,
amplifiers, light bars or any other equipment requiring on/off control.
INSTALLATION INSTRUCTIONS:
The two small terminals are for switching the relay on and off. Either one of the small terminals should be
connected to chassis ground or other ground location and the other terminal to switching power output. Switching
power must be between 10 and 16 VDC. The relay coil draws less than 1amp when switched on.
Battery or main power leads use the two large terminals. Either one may be incoming power. Fuse power leads as
close to battery or batteries as possible.
MODEL PAC-200
MOBILE AUDIO RELAY AND BATTERY ISOLATOR
200 Amp Continuous Power Handling
Pacific Accessory Corporation - 1502 S. Santa Fe Street, Santa Ana, CA 92705
_+
Battery
_+
Battery
FUSE
FUSE
PAC-200
Alternator
+
Accessory
Table des matières
Autres manuels PAC Accessoires automobiles
PAC
PAC BCI-CH21 Manuel utilisateur
PAC
PAC GM1A-RST Manuel utilisateur
PAC
PAC OS-4 Manuel utilisateur
PAC
PAC UPAC-NIS2 Manuel utilisateur
PAC
PAC GM1A-RT Manuel utilisateur
PAC
PAC OS-311 Manuel utilisateur
PAC
PAC RPK4-CH4102 Manuel utilisateur
PAC
PAC RadioPRO4 Manuel utilisateur
PAC
PAC RP4-CH11 Manuel utilisateur
PAC
PAC Automobile Accessories Manuel utilisateur
PAC
PAC TY1A-RS Manuel utilisateur
PAC
PAC RP4-CH21 Manuel utilisateur
PAC
PAC SWI-JACK Manuel utilisateur
PAC
PAC CH1AJKIT Manuel utilisateur
PAC
PAC BCI-CH41 Manuel utilisateur
PAC
PAC SRK-JW18EH Manuel utilisateur
PAC
PAC C2R-GM29 Manuel utilisateur
PAC
PAC RP4-GM41 Manuel utilisateur
PAC
PAC TATO Manuel utilisateur
PAC
PAC SWI-RC Manuel utilisateur
