OYPLA Home 3766 Manuel utilisateur
Wall Mountable Key Safe
User Manual
USER MANUAL Model No: 3766
USER MANUAL Model No: 3766
Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold on
this condition, which no representative of the company can waive or change.
•This product should only be used for its designated purpose.
•Make sure all screws are secured before using this product. The user is fully
responsible for ensuring the safe is mounted securely before use.
•This product is intended for outdoor use only.
•This product is not a toy, and is only to be used for its designated purpose.
•Do not carry out alterations or modifications to this product.
•This product contains small parts that could be a choking hazard if swallowed.
Keep these items away from children.
•Do not discard any of the packaging until you have checked that you have all the
parts and fittings required.
•If the product is damaged or has any defects, please contact [email protected]
How to install the Key Safe
1. Place the Key Safe against the wall you
wish to mount it on and mark the holes in
the safe onto the wall.
2. Once done, drill four hole into the wall
and slide screw anchors into the holes. Be
sure to line the holes up with the holes in
the Key Safe.
3. After this, drill a support screw though
the hole in the Key Safe and into the screw
anchor, ensuring that it goes through the
safe and into the wall. Repeat this with the
remaining screws. After this you will be able
to use the key safe.
Ensure fully assembled and secure before use.
Please retain a copy of all instructions for future consultation.
USER MANUAL Model No: 3766
Opening the Key Safe for the first time
1. Push the ‘CLEAR’ button down.
2. Push the ‘OPEN’ button down.
3. Open the cover.
How to save a new code
1. Remove the back panel of the cover with
a screwdriver.
2. Enter the new code (minimum of three
digits) and turn the plastic screw found on
the back of the panel 180° using the reset
tool. Push the code set button and reattach
the back panel. Do this before installing the
key safe.
Table des matières
Autres manuels OYPLA Home Sûr
Manuels Sûr populaires d'autres marques
Honeywell
Honeywell 2077D - 1.21 Cubic Foot Anti-Theft Safe Manuel utilisateur
Hornady
Hornady SnapSafe Trunk Safe II Manuel utilisateur
SPORTS AFIELD
SPORTS AFIELD SA-HD5-BIO Manuel utilisateur
Honeywell
Honeywell 5912 Manuel utilisateur
Phoenix
Phoenix FS1280F Manuel utilisateur
Phoenix
Phoenix SS0992K Fiche d'information produit
