- p. 2 of 2 -
Ocean Technology Systems
3133 W. Harvard Street • Santa Ana, California • 92704 • USA
Toll-free (800) 550-1984 • Telephone (714) 754-7848 • Fax (714) 966-1639
© Copyright 2008 by Undersea Systems International
dba Ocean Technology Systems. All rights reserved.
Specifications are subject to change without prior notice.
506138-000 (A)
Note: This instruction sheet and the information contained herein are provided for use as an installation guide only.
Please refer to your User’s Manual before using this or any OTS product. No license or rights to manufacture, re-
produce, and/or sell either the instruction sheet or the articles described herein are given.
*US patent no. 7,170,822; EU patent nos. 000458351-0001, -0002, -0003, -0004, -0005, -0006
6. Once the microphone is inside
the port, carefully position it within
1/4” of the right corner of the
diver’s lips. The ME-16R Hot-Mic®
is shown above; other microphones
are available (e.g.,the Super Mic®,
our patented* all-depth, noise-
cancelling microphone).
7. The left earphone cable travels
snug up the right side of the visor
and over the top by tucking the wire
into the groove between the mask
and visor.
9. The EP-2 earphone is direc-
tional. With the shiny side facing
toward the diver’s ear, insert the
earphone into the earphone holder
(on each side) past the snaps with
the cable positioned below the snap.
Secure the snap.
8. Insert the temple and chin mask
straps through the top and bot-
tom slots of each earphone holder,
respectively. The snaps face toward
the front of the mask with the OTS
logo on each earphone holder up-
right. Reassemble the mask straps.
11. The completed installation of
the OTS Ear/Mic Assembly.
Note: Before donning the mask,
position the earphone holders as
far back as possible to allow for
tightening of the mask straps. Once
fitted, adjust the earphone holders
into position.
10. The earphone cable should exit
the holder below the snap and run
parallel with the mask straps.
